Analysis and mitigation of noise in simultaneous transmission and reception in MRI

Author(s):  
Bilal Tasdelen ◽  
Alireza Sadeghi‐Tarakameh ◽  
Ugur Yilmaz ◽  
Ergin Atalar
Circulation ◽  
1996 ◽  
Vol 93 (3) ◽  
pp. 463-473 ◽  
Author(s):  
Edward P. Ficaro ◽  
Jeffrey A. Fessler ◽  
Paul D. Shreve ◽  
James N. Kritzman ◽  
Patricia A. Rose ◽  
...  

Electronics ◽  
2021 ◽  
Vol 10 (2) ◽  
pp. 196
Author(s):  
Jun Lu ◽  
Qunfei Zhang ◽  
Wentao Shi ◽  
Lingling Zhang ◽  
Juan Shi

Self-interference (SI) is usually generated by the simultaneous transmission and reception in the same system, and the variable SI channel and impulsive noise make it difficult to eliminate. Therefore, this paper proposes an adaptive digital SI cancellation algorithm, which is an improved normalized sub-band adaptive filtering (NSAF) algorithm based on the sparsity of the SI channel and the arctangent cost function. The weight vector is hardly updated when the impulsive noise occurs, and the iteration error resulting from impulsive noise is significantly reduced. Another major factor affecting the performance of SI cancellation is the variable SI channel. To solve this problem, the sparsity of the SI channel is estimated with the estimation of the weight vector at each iteration, and it is used to adjust the weight vector. Then, the convergence performance and calculation complexity are analyzed theoretically. Simulation results indicate that the proposed algorithm has better performance than the referenced algorithms.


2011 ◽  
Vol 36 (1) ◽  
pp. 141-150 ◽  
Author(s):  
Sylwia Muc ◽  
Tadeusz Gudra

Abstract The possibility of acoustic wave propagation in optical waveguides creates new prospects for simultaneous transmission of laser beams and ultrasonic waves. Combined laser-ultrasonic technology could be useful in e.g. surgical treatment. The article presents the results of experimental studies of transmission of ultrasonic wave in optical fibres, the core of which is doped by 7.5% of TiO2, using a sandwich-type transducer. It also presents amplitude characteristics of an ultrasonic signal propagated in the optical fibre. Authors studied the effect which the length of the fibre has on the achieved output signal amplitudes. They presented the relation of the output signal amplitude from a capacitive sensor to the power applied to the sandwich-type transducer. The obtained results were compared with the results produced when using an optical fibre with a core doped by 3% of GeO2, in order to select optical fibre suitable for simultaneous transmission of ultrasonic waves and laser rays.


Sign in / Sign up

Export Citation Format

Share Document