Formation and Evolution of Minerals in Accretion Disks and Stellar Outflows

Author(s):  
Hans-Peter Gail
2016 ◽  
Vol 60 (1) ◽  
pp. 87-98 ◽  
Author(s):  
A. M. Fateeva ◽  
A. G. Zhilkin ◽  
D. V. Bisikalo

2000 ◽  
Vol 175 ◽  
pp. 611-616
Author(s):  
A. E. Dudorov ◽  
R. E. Pudritz

AbstractAn investigation of the formation and evolution of Be stars show that these stars could have dipolar fossil magnetic fields. This magnetic field should constrain the circumstellar magnetic disk and influence its dynamical features. For studying these effects we refine the alphamodel of accretion disks of Shakura and Sunyaev by incorporating into this model the evolution of large-scale magnetic fields. In the frame of our model we can investigate the rotational history of the star with the disk and the ionization and thermal properties of disks. We show in particular that in the magnetopause region a current sheet can form that can generate X-ray radiation.


Author(s):  
Michael W. Bench ◽  
Jason R. Heffelfinger ◽  
C. Barry Carter

To gain a better understanding of the surface faceting that occurs in α-alumina during high temperature processing, atomic force microscopy (AFM) studies have been performed to follow the formation and evolution of the facets. AFM was chosen because it allows for analysis of topographical details down to the atomic level with minimal sample preparation. This is in contrast to SEM analysis, which typically requires the application of conductive coatings that can alter the surface between subsequent heat treatments. Similar experiments have been performed in the TEM; however, due to thin foil and hole edge effects the results may not be representative of the behavior of bulk surfaces.The AFM studies were performed on a Digital Instruments Nanoscope III using microfabricated Si3N4 cantilevers. All images were recorded in air with a nominal applied force of 10-15 nN. The alumina samples were prepared from pre-polished single crystals with (0001), , and nominal surface orientations.


2020 ◽  
Vol 640 ◽  
pp. A53
Author(s):  
L. Löhnert ◽  
S. Krätschmer ◽  
A. G. Peeters

Here, we address the turbulent dynamics of the gravitational instability in accretion disks, retaining both radiative cooling and irradiation. Due to radiative cooling, the disk is unstable for all values of the Toomre parameter, and an accurate estimate of the maximum growth rate is derived analytically. A detailed study of the turbulent spectra shows a rapid decay with an azimuthal wave number stronger than ky−3, whereas the spectrum is more broad in the radial direction and shows a scaling in the range kx−3 to kx−2. The radial component of the radial velocity profile consists of a superposition of shocks of different heights, and is similar to that found in Burgers’ turbulence. Assuming saturation occurs through nonlinear wave steepening leading to shock formation, we developed a mixing-length model in which the typical length scale is related to the average radial distance between shocks. Furthermore, since the numerical simulations show that linear drive is necessary in order to sustain turbulence, we used the growth rate of the most unstable mode to estimate the typical timescale. The mixing-length model that was obtained agrees well with numerical simulations. The model gives an analytic expression for the turbulent viscosity as a function of the Toomre parameter and cooling time. It predicts that relevant values of α = 10−3 can be obtained in disks that have a Toomre parameter as high as Q ≈ 10.


2001 ◽  
Vol 1 ◽  
pp. 53-61
Author(s):  
J.-M. Hure ◽  
D. Richard

Sign in / Sign up

Export Citation Format

Share Document