Plastic Deformation of Zirconia Single Crystals by in Situ Straining Experiments in an HVEM at 1150°C

1995 ◽  
pp. 43-51
Author(s):  
B. Baufeld ◽  
U. Messerschmidt ◽  
D. Baither ◽  
M. Bartsch ◽  
A. Foitzik ◽  
...  
Keyword(s):  
Plastic Deformation ◽  
Single Crystals

In Situ Deformation at 850°C of Standard and Rafted Microstructures of Nickel Base Superalloys

2006 ◽  
Vol 509 ◽  
pp. 57-62 ◽  
Author(s):  
Nicole Clément ◽  
Mustafa Benyoucef ◽  
M. Legros ◽  
Pierre Caron ◽  
Armand Coujou
Keyword(s):  
Plastic Deformation ◽  
Single Crystals ◽  
Stress Conditions ◽  
Actual Temperature ◽  
In Situ Study ◽  
The Creation ◽  
Nickel Base ◽  
In Situ Deformation

An in situ study of the plastic deformation of <001> single crystals of an industrial superalloy has been performed at 850 °C in a TEM to observe directly the micromechanisms which control the deformation under the actual temperature and stress conditions experienced by this material in aeroengines. A comparison between the creation and propagation modes of moving dislocations in the standard microstructure after annealing and the rafted microstructure after 20 h of creep at 1050°C evidence the important role of the width of the γ channels as well as the strength of the γ/γ’ interface in controlling the shearing events of γ’ channels.

scholarly journals Plastic Deformation Behavior of Mg-Y Alloy Single Crystals Observed Using In Situ Brinell Indentation

2018 ◽  
Vol 59 (4) ◽  
pp. 602-611 ◽  
Author(s):  
Takahiro Mineta ◽  
Seiji Miura ◽  
Kazuhiko Oka ◽  
Tatsuya Miyajima
Keyword(s):  
Plastic Deformation ◽  
Single Crystals ◽  
Deformation Behavior ◽  
Plastic Deformation Behavior

Investigation of shock-wave deformation history from recovered structure

1986 ◽  
Vol 44 ◽  
pp. 434-435
Author(s):  
M.A. Mogilevsky ◽  
L.S. Bushnev
Keyword(s):  
Shock Wave ◽  
Plastic Deformation ◽  
Dislocation Density ◽  
Shock Waves ◽  
Shock Front ◽  
Single Crystals ◽  
Residual Deformation ◽  
Deformation Structure ◽  
Deformation History ◽  
Deformation Velocity

Single crystals of Al were loaded by 15 to 40 GPa shock waves at 77 K with a pulse duration of 1.0 to 0.5 μs and a residual deformation of ∼1%. The analysis of deformation structure peculiarities allows the deformation history to be re-established.After a 20 to 40 GPa loading the dislocation density in the recovered samples was about 1010 cm-2. By measuring the thickness of the 40 GPa shock front in Al, a plastic deformation velocity of 1.07 x 108 s-1 is obtained, from where the moving dislocation density at the front is 7 x 1010 cm-2. A very small part of dislocations moves during the whole time of compression, i.e. a total dislocation density at the front must be in excess of this value by one or two orders. Consequently, due to extremely high stresses, at the front there exists a very unstable structure which is rearranged later with a noticeable decrease in dislocation density.

scholarly journals A new development of four-point method to measure the electrical resistivity in situ during plastic deformation

Measurement ◽  
2021 ◽  
pp. 109547
Author(s):  
Saeid Saberi ◽  
Martin Stockinger ◽  
Christian Stoeckl ◽  
Bruno Buchmayr ◽  
Helmut Weiss ◽  
...  
Keyword(s):  
Plastic Deformation ◽  
Electrical Resistivity ◽  
Point Method ◽  
New Development

Evolution of Pore Ordering during Anodizing of Aluminum Single Crystals: In Situ Small-Angle X-ray Scattering Study

2021 ◽  
Author(s):  
Ilya V. Roslyakov ◽  
Andrei P. Chumakov ◽  
Andrei A. Eliseev ◽  
Alexey P. Leontiev ◽  
Oleg V. Konovalov ◽  
...  
Keyword(s):  
Single Crystals ◽  
Small Angle ◽  
X Ray ◽  
X Ray Scattering ◽  
Scattering Study ◽  
Ray Scattering

scholarly journals In Situ Shear Test for Revealing the Mechanical Properties of the Gravelly Slip Zone Soil

Sensors ◽  
2020 ◽  
Vol 20 (22) ◽  
pp. 6531 ◽  
Author(s):  
Zongxing Zou ◽  
Qi Zhang ◽  
Chengren Xiong ◽  
Huiming Tang ◽  
Lei Fan ◽  
...  
Keyword(s):  
Mechanical Property ◽  
Plastic Deformation ◽  
Shear Test ◽  
Slip Zone ◽  
Three Gorges Reservoir Area ◽  
Silty Clay ◽  
Sigmoid Function ◽  
In Situ Test ◽  
Deformation Stage

Slip zone soil is usually composed of clay or silty clay; in some special geological environments, it contains gravels, which make the properties of the slip zone soil more complex. Unfortunately, in many indoor shear tests, gravels are removed to meet the demands of apparatus size, and the in situ mechanical property of the gravelly slip zone soil is rarely studied. In this study, the shear mechanical property of the gravelly slip zone soil of Huangtupo landslide in the Three Gorges Reservoir area of China was investigated by the in situ shear test. The test results show that the shear deformation process of the gravelly slip zone soil includes an elastic deformation stage, elastic–plastic deformation stage, and plastic deformation stage. Four functions were introduced to express the shear constitutive model of the gravelly slip zone soil, and the asymmetric sigmoid function was demonstrated to be the optimum one to describe the relationship of the shear stress and shear displacement with a correlation coefficient of 0.986. The comparison between the in situ test and indoor direct shear test indicates that gravels increase the strength of the slip zone soil. Therefore, the shear strength parameters of the gravelly slip zone soil obtained by the in situ test are more preferable for evaluating the stability of the landslide and designing the anti-slide structures.

Dislocation Processes in MgO Single Crystals Observed by In-situ Deformation in the HVEM

1979 ◽  
Vol 14 (11) ◽  
pp. 1329-1329 ◽  
Author(s):  
F. Appel ◽  
U. Messerschmidt
Keyword(s):  
Single Crystals ◽  
In Situ Deformation
Sign in / Sign up

Export Citation Format

Share Document