Appreciation of Spherically Symmetric Models of Electrical Conductivity

Author(s):  
J. Pěčová ◽  
Z. Martinec ◽  
K. Pěč
1987 ◽  
Vol 125 (2-3) ◽  
pp. 291-318 ◽  
Author(s):  
J. Pěčová ◽  
Z. Martinec ◽  
K. Pěč

Author(s):  
Zdeněk Martinec ◽  
Javier Fullea ◽  
Jakub Velí mský ◽  
Libor Šachl

Summary A new global model of the present-day thermochemical state of the lithosphere and upper mantle based on global waveform inversion, satellite gravity and gradiometry measurements, surface elevation and heat flow data has been recently presented: WINTERC-G (Fullea et al., 2021). WINTERC-G is built within an integrated geophysical-petrological framework where the mantle seismic velocity and density fields are computed in a thermodynamically self-consistent framework, allowing for a direct parameterisation in terms of the temperature, pressure and composition of the subsurface rocks. In this paper, we combine WINTERC-G thermal and compositional fields along with laboratory experiments constraining the electrical conductivity of mantle minerals, melt and water, and derive a set of new global three dimensional electrical conductivity models of the upper mantle. The new conductivity models, WINTERC-e, consist of two end-members corresponding to minimum and maximum conductivity of the in-situ rock aggregate accounting for mantle melting, mineral water content and the individual conductivities of the main stable mantle mineral phases. The end-member models are validated over oceans by simulating the magnetic field induced by the ocean M2 tidal currents and comparing the predicted fields with the M2 tidal magnetic field estimated from six-year Swarm satellite observations. Our new conductivity model, derived independently from any surface or satellite magnetic data sets, is however able to predict tidal magnetic fields that are in good agreement with the Swarm M2 tidal magnetic field models estimated by Sabaka et al. (2018, 2020) and Grayver & Olsen (2019). Our predicted M2 tidal magnetic fields differ in amplitudes by about 5-20% from the Swarm M2 tidal magnetic field, with the high conductivity WINTERC-e end-member model accounting for mantle melt and water content capturing the structure of Swarm data better than the low conductivity end-member model. Spherically symmetric conductivity models derived by averaging new WINTERC-e conductivities over oceanic areas are slightly more conductive than the recent global conductivity models AA17 by Grayver et al. (2017) derived from Swarm and CHAMP satellite data in the 60-140 km depth range, while they are less conductive deeper in the mantle. The conductivities in WINTERC-e are about 3-4 times smaller than the AA17 conductivities at a depth of 400 km. Despite the differences in electrical conductivity, our spherically symmetric high conductivity end-member model WINTERC-e captures the structure of Swarm M2 tidal magnetic field almost the same as a state of the art 1D conductivity models derived entirely from magnetic data (AA17, (Grayver et al., 2017). Moreover, we show that realistic lateral electrical conductivity inhomogeneities of the oceanic upper mantle derived from the temperature, melt and water distributions in WINTERC-e contribute to the M2 tidal magnetic field up to ±0.3 nT at 430 km altitude.


Author(s):  
John C. Russ ◽  
Nicholas C. Barbi

The rapid growth of interest in attaching energy-dispersive x-ray analysis systems to transmission electron microscopes has centered largely on microanalysis of biological specimens. These are frequently either embedded in plastic or supported by an organic film, which is of great importance as regards stability under the beam since it provides thermal and electrical conductivity from the specimen to the grid.Unfortunately, the supporting medium also produces continuum x-radiation or Bremsstrahlung, which is added to the x-ray spectrum from the sample. It is not difficult to separate the characteristic peaks from the elements in the specimen from the total continuum background, but sometimes it is also necessary to separate the continuum due to the sample from that due to the support. For instance, it is possible to compute relative elemental concentrations in the sample, without standards, based on the relative net characteristic elemental intensities without regard to background; but to calculate absolute concentration, it is necessary to use the background signal itself as a measure of the total excited specimen mass.


Author(s):  
Klaus-Ruediger Peters ◽  
Samuel A. Green

High magnification imaging of macromolecules on metal coated biological specimens is limited only by wet preparation procedures since recently obtained instrumental resolution allows visualization of topographic structures as smal l as 1-2 nm. Details of such dimensions may be visualized if continuous metal films with a thickness of 2 nm or less are applied. Such thin films give sufficient contrast in TEM as well as in SEM (SE-I image mode). The requisite increase in electrical conductivity for SEM of biological specimens is achieved through the use of ligand mediated wet osmiuum impregnation of the specimen before critical point (CP) drying. A commonly used ligand is thiocarbohvdrazide (TCH), first introduced to TEM for en block staining of lipids and glvcomacromolecules with osmium black. Now TCH is also used for SEM. However, after ligand mediated osinification nonspecific osmium black precipitates were often found obscuring surface details with large diffuse aggregates or with dense particular deposits, 2-20 nm in size. Thus, only low magnification work was considered possible after TCH appl ication.


1991 ◽  
Vol 18 (3) ◽  
pp. 611-627 ◽  
Author(s):  
Marta L. Fiorotto ◽  
William J. Klish

2020 ◽  
Vol 92 (1) ◽  
pp. 10901
Author(s):  
Saloua El Asri ◽  
Hamid Ahamdane ◽  
Lahoucine Hajji ◽  
Mohamed El Hadri ◽  
Moulay Ahmed El Idrissi Raghni ◽  
...  

Forsterite single phase powder Mg2SiO4 was synthesized by sol–gel method alongside with heat treatment, using two different cation alkaline salts MCl as mineralizers (M = Na, K) with various mass percentages (2.5, 5, 7.5, and 10 wt.%). In this work, we report on the effect of the cation type and the added amount of used mineralizer on microstructure and electrical conductivity of Mg2SiO4. The formation of forsterite started at 680–740  °C and at 630–700  °C with KCl and NaCl respectively, as shown by TG-DTA and confirmed by XRD. Furthermore, the Fourier transform infrared (FTIR) transmission spectra indicated bands corresponding to vibrations of forsterite structure. The morphology and elemental composition of sintered ceramics were examined by SEM-EDX analyses, while their densities, which were measured by Archimedes method, increased with addition of both alkaline salts. The electrical measurements were performed by Complex Impedance Spectroscopy. The results showed that electrical conductivity increased with the addition of both mineralizers, which was higher for samples prepared with NaCl than those prepared with KCl.


1980 ◽  
Vol 41 (C5) ◽  
pp. C5-219-C5-222
Author(s):  
J. P. Desfours ◽  
C. Godart ◽  
J. P. Nadai ◽  
A. Mauger ◽  
G. Weill ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document