Tests of Magnetic Properties of New Zealand Pliocene Marine Mudstones

1989 ◽  
pp. 263-269
Author(s):  
D. M. McGuire
Keyword(s):  
Magnetic Properties ◽  
New Zealand

scholarly journals Magnetic properties of Dashing Rocks loess at Timaru, South Island, New Zealand

2013 ◽  
Vol 195 (1) ◽  
pp. 75-85 ◽  
Author(s):  
Mingming Ma ◽  
Xiuming Liu ◽  
Brad J. Pillans ◽  
Shouyun Hu ◽  
Bin Lü ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
New Zealand

Magellanic Cloud Eclipsing Binaries: Primary Distance Indicators

1999 ◽  
Vol 190 ◽  
pp. 563-566
Author(s):  
J. D. Pritchard ◽  
W. Tobin ◽  
J. V. Clausen ◽  
E. F. Guinan ◽  
E. L. Fitzpatrick ◽  
...  
Keyword(s):  
New Zealand ◽  
Magellanic Cloud ◽  
Eclipsing Binaries ◽  
Fundamental Parameters ◽  
Distance Indicators

Our collaboration involves groups in Denmark, the U.S.A. Spain and of course New Zealand. Combining ground-based and satellite (IUEandHST) observations we aim to determine accurate and precise stellar fundamental parameters for the components of Magellanic Cloud Eclipsing Binaries as well as the distances to these systems and hence the parent galaxies themselves. This poster presents our latest progress.

AEM analysis of crystallization in Ti-based amorphous alloys

1983 ◽  
Vol 41 ◽  
pp. 270-271
Author(s):  
A.R. Pelton ◽  
A.F. Marshall ◽  
Y.S. Lee
Keyword(s):  
Magnetic Properties ◽  
Amorphous Alloys ◽  
Amorphous Materials ◽  
Isothermal Annealing ◽  
Amorphous Matrix ◽  
Nucleation And Growth ◽  
Current Interest ◽  
Amorphous Films ◽  
Electrical And Magnetic Properties

Amorphous materials are of current interest due to their desirable mechanical, electrical and magnetic properties. Furthermore, crystallizing amorphous alloys provides an avenue for discerning sequential and competitive phases thus allowing access to otherwise inaccessible crystalline structures. Previous studies have shown the benefits of using AEM to determine crystal structures and compositions of partially crystallized alloys. The present paper will discuss the AEM characterization of crystallized Cu-Ti and Ni-Ti amorphous films.Cu60Ti40: The amorphous alloy Cu60Ti40, when continuously heated, forms a simple intermediate, macrocrystalline phase which then transforms to the ordered, equilibrium Cu3Ti2 phase. However, contrary to what one would expect from kinetic considerations, isothermal annealing below the isochronal crystallization temperature results in direct nucleation and growth of Cu3Ti2 from the amorphous matrix.

Heat-Etching with a Bullivant Type II Simple Freeze-Cleave Device

1970 ◽  
Vol 28 ◽  
pp. 106-107 ◽  
Author(s):  
Ronald S. Weinstein ◽  
N. Scott McNutt
Keyword(s):  
New Zealand ◽  
General Hospital ◽  
Massachusetts General Hospital ◽  
Type I ◽  
Type Ii ◽  
Collaborative Effort ◽  
Temperature And Pressure ◽  
The University

The Type I simple cold block device was described by Bullivant and Ames in 1966 and represented the product of the first successful effort to simplify the equipment required to do sophisticated freeze-cleave techniques. Bullivant, Weinstein and Someda described the Type II device which is a modification of the Type I device and was developed as a collaborative effort at the Massachusetts General Hospital and the University of Auckland, New Zealand. The modifications reduced specimen contamination and provided controlled specimen warming for heat-etching of fracture faces. We have now tested the Mass. General Hospital version of the Type II device (called the “Type II-MGH device”) on a wide variety of biological specimens and have established temperature and pressure curves for routine heat-etching with the device.

Microstructure in soft magnetic E3 (S1, Al) (Sendust) alloys

1988 ◽  
Vol 46 ◽  
pp. 770-771
Author(s):  
June D. Kim
Keyword(s):  
Electron Microscopy ◽  
Magnetic Properties ◽  
Ternary Phase Diagram ◽  
Vertical Tube ◽  
Vacuum Induction Melting ◽  
Induction Melting ◽  
Soft Magnetic ◽  
Quenching Temperature ◽  
Thin Foils ◽  
Vertical Tube Furnace

Iron-base alloys containing 8-11 wt.% Si, 4-8 wt.% Al, known as “Sendust” alloys, show excellent soft magnetic properties. These magnetic properties are strongly dependent on heat treatment conditions, especially on the quenching temperature following annealing. But little has been known about the microstructure and the Fe-Si-Al ternary phase diagram has not been established. In the present investigation, transmission electron microscopy (TEM) has been used to study the microstructure in a Sendust alloy as a function of temperature.An Fe-9.34 wt.% Si-5.34 wt.% Al (approximately Fe3Si0.6Al0.4) alloy was prepared by vacuum induction melting, and homogenized at 1,200°C for 5 hrs. Specimens were heat-treated in a vertical tube furnace in air, and the temperature was controlled to an accuracy of ±2°C. Thin foils for TEM observation were prepared by jet polishing using a mixture of perchloric acid 15% and acetic acid 85% at 10V and ∼13°C. Electron microscopy was performed using a Philips EM 301 microscope.

A Cytochemical Study of Glucose-6-Phosphatase (G-6-PASE) in Cells Participating in Atherogenesis of Rabbit Aorta

1975 ◽  
Vol 33 ◽  
pp. 460-461
Author(s):  
Sidney D. Kobernick ◽  
Edna A. Elfont ◽  
Neddra L. Brooks
Keyword(s):  
Lipid Metabolism ◽  
New Zealand ◽  
Aortic Wall ◽  
Rabbit Aorta ◽  
Plaque Formation ◽  
Metabolic Changes ◽  
Atherosclerotic Plaques ◽  
Cytochemical Study ◽  
Cellular Alteration ◽  
New Zealand White Rabbits

This cytochemical study was designed to investigate early metabolic changes in the aortic wall that might lead to or accompany development of atherosclerotic plaques in rabbits. The hypothesis that the primary cellular alteration leading to plaque formation might be due to changes in either carbohydrate or lipid metabolism led to histochemical studies that showed elevation of G-6-Pase in atherosclerotic plaques of rabbit aorta. This observation initiated the present investigation to determine how early in plaque formation and in which cells this change could be observed.Male New Zealand white rabbits of approximately 2000 kg consumed normal diets or diets containing 0.25 or 1.0 gm of cholesterol per day for 10, 50 and 90 days. Aortas were injected jin situ with glutaraldehyde fixative and dissected out. The plaques were identified, isolated, minced and fixed for not more than 10 minutes. Incubation and postfixation proceeded as described by Leskes and co-workers.

Isozyme variation of Microsporum canis and M. cookei from New Zealand

1998 ◽  
Vol 36 (5) ◽  
pp. 255-262
Author(s):  
SIMPANYA ◽  
JARVIS ◽  
BAXTER
Keyword(s):  
New Zealand ◽  
Microsporum Canis ◽  
Isozyme Variation
Sign in / Sign up

Export Citation Format

Share Document