Two-Step Procedure for Robust Design Using CAT Technology

1999 ◽  
pp. 231-240 ◽  
Author(s):  
Rikard Söderberg ◽  
Lars Lindkvist
Keyword(s):  
Robust Design ◽  
Step Procedure

Scanning Tunneling Microscopy of Amorphous Carbon Films

1990 ◽  
Vol 48 (1) ◽  
pp. 318-319
Author(s):  
Mircea Fotino ◽  
D.C. Parks
Keyword(s):  
Scanning Tunneling Microscopy ◽  
Amorphous Carbon ◽  
Carbon Films ◽  
Atomic Scale ◽  
Scanning Tunneling ◽  
Tunneling Microscopy ◽  
Amorphous Carbon Films ◽  
Image Optimization ◽  
Step Procedure ◽  
Stm Images

In the last few years scanning tunneling microscopy (STM) has made it possible and easily accessible to visualize surfaces of conducting specimens at the atomic scale. Such performance allows the detailed characterization of surface morphology in an increasing spectrum of applications in a wide variety of fields. Because the basic imaging process in STM differs fundamentally from its equivalent in other well-established microscopies, good understanding of the imaging mechanism in STM enables one to grasp the correct information content in STM images. It thus appears appropriate to explore by STM the structure of amorphous carbon films because they are used in many applications, in particular in the investigation of delicate biological specimens that may be altered through the preparation procedures.All STM images in the present study were obtained with the commercial instrument Nanoscope II (Digital Instruments, Inc., Santa Barbara, California). Since the importance of the scanning tip for image optimization and artifact reduction cannot be sufficiently emphasized, as stressed by early analyses of STM image formation, great attention has been directed toward adopting the most satisfactory tip geometry. The tips used here consisted either of mechanically sheared Pt/Ir wire (90:10, 0.010" diameter) or of etched W wire (0.030" diameter). The latter were eventually preferred after a two-step procedure for etching in NaOH was found to produce routinely tips with one or more short whiskers that are essentially rigid, uniform and sharp (Fig. 1) . Under these circumstances, atomic-resolution images of cleaved highly-ordered pyro-lytic graphite (HOPG) were reproducibly and readily attained as a standard criterion for easily recognizable and satisfactory performance (Fig. 2).

Procedure for Maximizing Phonological Information from Single-Word Responses

1984 ◽  
Vol 15 (4) ◽  
pp. 267-274 ◽  
Author(s):  
Harriet B. Klein
Keyword(s):  
Phonological Information ◽  
Single Word ◽  
Preliminary Assessment ◽  
Target Attainment ◽  
Phonological Processes ◽  
Step Procedure ◽  
Yield Information ◽  
Assessment Measure ◽  
Busy Clinician ◽  
Planning Intervention

Formal articulation test responses are often used by the busy clinician as a basis for planning intervention goals. This article describes a 6-step procedure for using efficiently the single-word responses elicited with an articulation test. This procedure involves the assessment of all consonants within a word rather than only test-target consonants. Responses are organized within a Model and Replica chart to yield information about an individual's (a) articulation ability, (b) frequency of target attainment, substitutions, and deletions, (c) variability in production, and (d) phonological processes. This procedure is recommended as a preliminary assessment measure. It is advised that more detailed analysis of continuous speech be undertaken in conjunction with early treatment sessions.

Plasminogen-Activator in Human Early Milk: Its Partial Purification and Characterization

1981 ◽  
Vol 45 (02) ◽  
pp. 121-126 ◽  
Author(s):  
Utako Okamoto ◽  
Noboru Horie ◽  
Yoko Nagamatsu ◽  
Jun-Ichiro Yamamoto
Keyword(s):  
Plasminogen Activator ◽  
Polyacrylamide Gel Electrophoresis ◽  
Gel Filtration ◽  
Partial Purification ◽  
Order Kinetic ◽  
Diisopropyl Fluorophosphate ◽  
Step Procedure ◽  
Activity Band ◽  
C 50 ◽  
Gel Isoelectric Focusing

SummaryMilk plasminogen-activator was partially purified from human transitional milk collected at about 10 days after delivery, by a five-step procedure involving chloroform treatment, ammonium sulfate precipitation, and column chromatography on Sephadex G-150, CM Sephadex C-50 and DEAE Sephadex A-50. This gave milk-activator with a maximum purification factor of about 2,400-fold with respect to the skimmed milk. The CM Sephadex-step preparation showed, on polyacrylamide gel electrophoresis, a single plasminogen-activator activity band located between the bands of albumin and prealbumin of human serum. This preparation exhibited no kinin forming activity. The activator hydrolyzed acetyl-glycyl-L-lysine methyl ester with similar order kinetic constants to urokinase, and was inhibited strongly by diisopropyl-fluorophosphate. The molecular weight of the activator as estimated by gel filtration was approximately 86,000, the isoelectric points as estimated by gel isoelectric focusing were pH 7.2, 6.9 and 6.6, and the activator activity was not quenched by antiurokinase globulin, indicating that the milk-activator is a different entity from urokinase.

Delayed Closure of Multiple Muscular Ventricular Septal Defects in an Infant after Coarctation Repair and a Hybrid Procedure�A Case Report

2011 ◽  
Vol 14 (1) ◽  
pp. 67 ◽  
Author(s):  
Ireneusz Haponiuk ◽  
Maciej Chojnicki ◽  
Radosaw Jaworski ◽  
Jacek Juciski ◽  
Mariusz Steffek ◽  
...  
Keyword(s):  
Septal Defect ◽  
Color Doppler ◽  
Hybrid Approach ◽  
Ventricular Septal Defects ◽  
Color Doppler Echocardiography ◽  
Septal Defects ◽  
Coarctation Repair ◽  
Step Procedure ◽  
The Right ◽  
Delayed Closure

There are several strategies of surgical approach for the repair of multiple muscular ventricular septal defects (mVSDs), but none leads to a fully predictable, satisfactory therapeutic outcome in infants. We followed a concept of treating multiple mVSDs consisting of a hybrid approach based on intraoperative perventricular implantation of occluding devices. In this report, we describe a 2-step procedure consisting of a final hybrid approach for multiple mVSDs in the infant following initial coarctation repair with pulmonary artery banding in the newborn. At 7 months, sternotomy and debanding were performed, the right ventricle was punctured under transesophageal echocardiographic guidance, and the 8-mm device was implanted into the septal defect. Color Doppler echocardiography results showed complete closure of all VSDs by 11 months after surgery, probably via a mechanism of a localized inflammatory response reaction, ventricular septum growth, and implant endothelization.

Non-Stochastic Robust Design of Airfoils - a New Paradigm

2021 ◽  
Author(s):  
Pat Piperni ◽  
Almir Tricic
Keyword(s):  
Robust Design ◽  
New Paradigm

Seeded Growth of Single-Crystal Two-Dimensional Covalent Organic Frameworks

2017 ◽  
Author(s):  
Austin M. Evans ◽  
Lucas R. Parent ◽  
Nathan C. Flanders ◽  
Ryan P. Bisbey ◽  
Edon Vitaku ◽  
...  
Keyword(s):  
Molecular Transport ◽  
Controlled Synthesis ◽  
Two Dimensional ◽  
Covalent Organic Frameworks ◽  
Seeded Growth ◽  
Covalent Bonds ◽  
Crystalline Materials ◽  
Step Procedure ◽  
Structures And Properties ◽  
2D Polymer

<div> <div> <div> <p>Polymerizing monomers into periodic two-dimensional (2D) networks provides structurally precise, atomically thin macromolecular sheets linked by robust, covalent bonds. These materials exhibit desirable mechanical, optoelectrotronic, and molecular transport properties derived from their designed structure and permanent porosity. 2D covalent organic frameworks (COFs) offer broad monomer scope, but are generally isolated as polycrystalline, insoluble powders with limited processability. Here we overcome this limitation by controlling 2D COF formation using a two- step procedure. In the first step, 2D COF nanoparticle seeds are prepared with approximate diameters of 30 nm. Next, monomers are slowly added to suppress new nucleation while promoting epitaxial growth on the existing seeds to sizes of several microns. The resulting COF nanoparticles are of exceptional and unprecedented quality, isolated as single crystalline materials with micron-scale domain sizes. These findings advance the controlled synthesis of 2D layered COFs and will enable a broad exploration of synthetic 2D polymer structures and properties. </p> </div> </div> </div>

Seeded Growth of Single-Crystal Two-Dimensional Covalent Organic Frameworks

2017 ◽  
Author(s):  
Austin M. Evans ◽  
Lucas R. Parent ◽  
Nathan C. Flanders ◽  
Ryan P. Bisbey ◽  
Edon Vitaku ◽  
...  
Keyword(s):  
Molecular Transport ◽  
Controlled Synthesis ◽  
Two Dimensional ◽  
Covalent Organic Frameworks ◽  
Seeded Growth ◽  
Covalent Bonds ◽  
Crystalline Materials ◽  
Step Procedure ◽  
Structures And Properties ◽  
2D Polymer

<div> <div> <div> <p>Polymerizing monomers into periodic two-dimensional (2D) networks provides structurally precise, atomically thin macromolecular sheets linked by robust, covalent bonds. These materials exhibit desirable mechanical, optoelectrotronic, and molecular transport properties derived from their designed structure and permanent porosity. 2D covalent organic frameworks (COFs) offer broad monomer scope, but are generally isolated as polycrystalline, insoluble powders with limited processability. Here we overcome this limitation by controlling 2D COF formation using a two- step procedure. In the first step, 2D COF nanoparticle seeds are prepared with approximate diameters of 30 nm. Next, monomers are slowly added to suppress new nucleation while promoting epitaxial growth on the existing seeds to sizes of several microns. The resulting COF nanoparticles are of exceptional and unprecedented quality, isolated as single crystalline materials with micron-scale domain sizes. These findings advance the controlled synthesis of 2D layered COFs and will enable a broad exploration of synthetic 2D polymer structures and properties. </p> </div> </div> </div>

Sign in / Sign up

Export Citation Format

Share Document