Large-Scale Model Analysis on Bearing Characteristics of Geocell-Reinforced Earth Retaining Wall Under Cyclic Dynamic Load

Author(s):  
Jia-Quan Wang ◽  
Bin Ye ◽  
Liang-Liang Zhang ◽  
Liang Li
2011 ◽  
Vol 71-78 ◽  
pp. 383-387 ◽  
Author(s):  
Qian Su ◽  
Xing Li ◽  
Hao Bai

A series of tests based on large scale model are designed to study dynamic response of pile-broad subgrade, aiming at structure’s response towards different load frequency and structure’s performance under long-term dynamic load. The test results indicate that dynamic stress of reinforcement and soil decrease slightly with load frequency, while accelerations trend to increase. Soil under loading plate has certain supporting effect because stress of reinforcement is smaller in test group with soil remains. Performance of pile-board subgrade under long-term dynamic load is steady and reliable since none of stress and displacement varies obviously when loading times increase to 106. Ultimate bearing capacity of pile-board subgrade is much bigger than actual demand, so the structural type of pile-broad plate remains to be optimized.


2013 ◽  
Vol 14 (2) ◽  
Author(s):  
Noor Fachrizal

Biomass such as agriculture waste and urban waste are enormous potency as energy resources instead of enviromental problem. organic waste can be converted into energy in the form of liquid fuel, solid, and syngas by using of pyrolysis technique. Pyrolysis process can yield higher liquid form when the process can be drifted into fast and flash response. It can be solved by using microwave heating method. This research is started from developing an experimentation laboratory apparatus of microwave-assisted pyrolysis of biomass energy conversion system, and conducting preliminary experiments for gaining the proof that this method can be established for driving the process properly and safely. Modifying commercial oven into laboratory apparatus has been done, it works safely, and initial experiments have been carried out, process yields bio-oil and charcoal shortly, several parameters are achieved. Some further experiments are still needed for more detail parameters. Theresults may be used to design small-scale continuous model of productionsystem, which then can be developed into large-scale model that applicable for comercial use.


1984 ◽  
Vol 106 (1) ◽  
pp. 222-228 ◽  
Author(s):  
M. L. Marziale ◽  
R. E. Mayle

An experimental investigation was conducted to examine the effect of a periodic variation in the angle of attack on heat transfer at the leading edge of a gas turbine blade. A circular cylinder was used as a large-scale model of the leading edge region. The cylinder was placed in a wind tunnel and was oscillated rotationally about its axis. The incident flow Reynolds number and the Strouhal number of oscillation were chosen to model an actual turbine condition. Incident turbulence levels up to 4.9 percent were produced by grids placed upstream of the cylinder. The transfer rate was measured using a mass transfer technique and heat transfer rates inferred from the results. A direct comparison of the unsteady and steady results indicate that the effect is dependent on the Strouhal number, turbulence level, and the turbulence length scale, but that the largest observed effect was only a 10 percent augmentation at the nominal stagnation position.


1989 ◽  
Author(s):  
R. DE GAAIJ ◽  
E. VAN RIETBERGEN ◽  
M. SLEGERS

Sign in / Sign up

Export Citation Format

Share Document