Changes in the moisture stability of CaS:Eu2+ phosphors with surface coating methods

The various methods presently available for the repair of brick masonry walls are reviewed. Particular attention is given to structural repair made necessary as the result of earthquake induced damage or retrofit measures to be applied to an existing masonry structure to increase seismic resistance. Among the techniques discussed are: crack injection with epoxy or resin, crack or void injection with a cement based grout, surface coating methods, base isolation, repointing or limited replacement of damaged elements and installation of steel reinforcing elements. Use of nondestructive evaluation methods to determine the initial damaged state and the condition of the repaired masonry wall will also be presented.

Download Full-text

From powders to plating[ellipsis (horizontal)]. Surface coating by ionic bombardment!

Production Engineer ◽

10.1049/tpe.1981.0146 ◽

1981 ◽

Vol 60 (7-8) ◽

pp. 37

Keyword(s):

Surface Coating ◽

Horizontal Surface ◽

Ionic Bombardment

Download Full-text

Surface coating of the matrix using autologous fibrin improved an in vivo re-endothelialization of allogeneic detergent-decellularized heart valves

The Thoracic and Cardiovascular Surgeon ◽

10.1055/s-0029-1191622 ◽

2009 ◽

Vol 56 (S 01) ◽

Author(s):

A Lichtenberg ◽

P Akhyari ◽

H Kamiya ◽

P Mambou ◽

H Ziegler ◽

...

Keyword(s):

Surface Coating ◽

Heart Valves ◽

The Matrix

Download Full-text

Antithrombin III Binding to Surface Immobilized Heparin and Its Relation to F Xa Inhibition

Thrombosis and Haemostasis ◽

10.1055/s-0038-1646057 ◽

1987 ◽

Vol 58 (04) ◽

pp. 1064-1067 ◽

Cited By ~ 41

Author(s):

K Kodama ◽

B Pasche ◽

P Olsson ◽

J Swedenborg ◽

L Adolfsson ◽

...

Keyword(s):

Molecular Weight ◽

Ionic Strength ◽

Surface Coating ◽

Antithrombin Iii ◽

Lower Class ◽

Biologically Active ◽

High Affinity ◽

Heparin Coating ◽

Continuous Surface ◽

Approximate Molecular Weight

SummaryThe mode of F Xa inhibition was investigated on a thromboresistant surface with end-point attached partially depoly-merized heparin of an approximate molecular weight of 8000. Affinity chromatography revealed that one fourth of the heparin used in surface coating had high affinity for antithrombin III (AT). The heparin surface adsorbed AT from both human plasma and solutions of purified AT. By increasing the ionic strength in the AT solution the existence of high and low affinity sites could be shown. The uptake of AT was measured and the density of available high and low affinity sites was found to be in the range of 5 HTid 11 pic.omoles/cmf, respectively Thus the estimated density of biologically active high and low ailmity heparm respectively would be 40 and 90 ng/cm2 The heparin coating did not take up or exert F Xa inhibition by itself. With AT adsorbed on both high and low affinity heparin the surface had the capacity to inhibit several consecutive aliquots of F Xa exposed to the surface. When mainly high affinity sites were saturated with AT the inhibition capacity was considerably lower. Tt was demonstrated that the density of AT on both high and low affinity heparin determines the F Xa inhibition capacity whereas the amount of AT on high affinity sites limits the rate of the reaction. This implies that during the inhibition of F Xa there is a continuous surface-diffusion of AT from sites of a lower class to the high affinity sites where the F Xa/AT complex is formed and leaves the surface. The ability of the immobilized heparin to catalyze inhibition of F Xa is likely to be an important component for the thromboresistant properties of a heparin coating with non-compromized AT binding sequences.

Download Full-text