A Comparative Performance Analysis and Optimization of the Irreversible Atkinson Cycle Under Maximum Power Density and Maximum Power Conditions

Considering nonlinear variation of working fluid’s specific heat with its temperature, finite-time thermodynamic theory is applied to analyze and optimize the characteristics of an irreversible Atkinson cycle. Through numerical calculations, performance relationships between cycle dimensionless power density versus compression ratio and dimensionless power density versus thermal efficiency are obtained, respectively. When the design parameters take certain specific values, the performance differences of reversible, endoreversible and irreversible Atkinson cycles are compared. The maximum specific volume ratio, maximum pressure ratio, and thermal efficiency under the conditions of the maximum power output and maximum power density are compared. Based on NSGA-II, the single-, bi-, tri-, and quadru-objective optimizations are performed when the compression ratio is used as the optimization variable, and the cycle dimensionless power output, thermal efficiency, dimensionless ecological function, and dimensionless power density are used as the optimization objectives. The deviation indexes are obtained based on LINMAP, TOPSIS, and Shannon entropy solutions under different combinations of optimization objectives. By comparing the deviation indexes of bi-, tri- and quadru-objective optimization and the deviation indexes of single-objective optimizations based on maximum power output, maximum thermal efficiency, maximum ecological function and maximum power density, it is found that the deviation indexes of multi-objective optimization are smaller, and the solution of multi-objective optimization is desirable. The comparison results show that when the LINMAP solution is optimized with the dimensionless power output, thermal efficiency, and dimensionless power density as the objective functions, the deviation index is 0.1247, and this optimization objective combination is the most ideal.

Download Full-text

Carbon Nano Tube-Polymer Hybrid Nanocomposite Electrodes for Porous Polydimethylsiloxane Sponge-Based Flexible Triboelectric Nanogenerators

Journal of Nanoscience and Nanotechnology ◽

10.1166/jnn.2021.19297 ◽

2021 ◽

Vol 21 (9) ◽

pp. 4680-4684

Author(s):

Dae-Hyeon Kwon ◽

Jaebum Jeong ◽

Yongju Lee ◽

Jun-Kyu Park ◽

Suwoong Lee ◽

...

Keyword(s):

Power Density ◽

Output Voltage ◽

Maximum Power ◽

Maximum Power Density ◽

Flexible Electrodes ◽

Flexible Devices ◽

Copper Electrodes ◽

Polymer Hybrid ◽

Triboelectric Nanogenerators ◽

Carbon Nano Tube

Flexible triboelectric nanogenerators (TENGs) have attracted much attention because of its environmentally friendly, practical, and cost-producing advantages. In flexible TENGs, it is important to study the flexible electrodes in order to fabricate the fully flexible devices. Here, we compared electrical characteristics of the sponge porous polydimethylsiloxane (PDMS)-based flexible TENGs with two types of flexible electrodes, copper and carbon nanotube (CNT)-PDMS electrodes. The output voltage and maximum power density of sponge PDMS-based flexible TENGs with copper and CNTPDMS electrodes were compared. The voltage and power density of sponge PDMS-based flexible TENGs with CNT-PDMS electrodes were improved compare to those with copper electrodes. The output voltage and the maximum power density of sponge PDMS-based flexible TENGs with copper and CNT-PDMS electrodes increased 4 times and 7 times, respectively. It is attributed to higher electrical conductivity and stably flow electricity of CNT than those of copper.

Download Full-text