The effect of sintering temperature on magnetic and dielectric properties of Ho3Fe5O12 ceramics

2011 ◽  
Vol 46 (10) ◽  
pp. 3488-3492 ◽  
Author(s):  
Jie Su ◽  
Xiaomei Lu ◽  
Chao Zhang ◽  
Junting Zhang ◽  
Song Peng ◽  
...  
Keyword(s):  
Dielectric Properties ◽  
Sintering Temperature ◽  
Magnetic And Dielectric Properties

Electrical and Magnetic Studies of (La0.5-xPrxBa0.5)(Mn0.5Ti0.5)O3 as Multiferroic Material

2012 ◽  
Vol 545 ◽  
pp. 269-274
Author(s):  
Nor Hayati Alias ◽  
Abdul Halim Shaari ◽  
Wan Mohamad Daud Wan Yusoff ◽  
Che Seman Mahmood
Keyword(s):  
Magnetic Properties ◽  
Dielectric Properties ◽  
Solid State ◽  
Room Temperature ◽  
Sintering Temperature ◽  
Multiferroic Material ◽  
Magnetic Studies ◽  
State Technique ◽  
Magnetic And Dielectric Properties ◽  
Synthesized Materials

A new perovskite based titano-manganite (La0.5-xPrxBa0.5)(Mn0.5Ti0.5)O3 at x concentration 0, 0.01, 0.03, 0.05, 0.07 and 0.09 has been successfully prepared by ceramic solid-state technique at sintering temperature of 1300 °C. Dielectric electrical properties of the synthesized materials at frequency ranging from 5 Hz to 1 MHz and magnetic properties have been studied at room temperature. Analyses have been carried out to determine the structural, magnetic and dielectric properties of the synthesized material as a candidate of multiferroic material.

Influence of Ca-Doping on Structural, Magnetic and Dielectric Properties of Ba3Co2-xCaxFe24O41 Hexaferrite Powders

2015 ◽  
Vol 241 ◽  
pp. 226-236 ◽  
Author(s):  
Neha Solanki ◽  
Rajshree B. Jotania
Keyword(s):  
Dielectric Constant ◽  
Dielectric Properties ◽  
Sol Gel ◽  
Calcium Content ◽  
Combustion Method ◽  
Dielectric Behavior ◽  
Dielectric Parameters ◽  
Ca Doping ◽  
Auto Combustion ◽  
Magnetic And Dielectric Properties

Influence of Ca substitution on structural, magnetic and dielectric properties of Ba3Co2-xCaxFe24O41(where x = 0.0, 0.2, 0.4, 0.6, 0.8 and 1.0), prepared by Sol-Gel auto-combustion method, has been investigated in present studies. The obtained powder was sintered at 950 oC for 4 hrs. in the static air atmosphere. Structural analysis of Ca-doped Ba3Co2-xCaxFe24O41powders revealed pure Z-type hexaferrite phase at low temperature. The frequency dependent dielectric constant (Єʹ) and magnetic properties such as remanent magnetization (Mr), saturation magnetization (Ms) and coercivity (Hc) were studied. It is observed that coercivity increased gradually with increase in calcium content. The real dielectric constant (Єʹ) and dielectric loss tangent (tan δ) were studied in the frequency range of 20Hz to 2MHz. The dielectric parameters for all samples show normal dielectric behavior as observed in hexaferrites. Contents of Paper

scholarly journals Microwave Sintering and Microwave Dielectric Properties of (1–x)Ca0.61La0.26TiO3-xNd(Mg0.5Ti0.5)O3 Ceramics

Materials ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 438
Author(s):  
Shuwei Yang ◽  
Bingliang Liang ◽  
Changhong Liu ◽  
Jin Liu ◽  
Caisheng Fang ◽  
...  
Keyword(s):  
Dielectric Properties ◽  
Mobile Communications ◽  
Sintering Temperature ◽  
Microwave Sintering ◽  
Microwave Dielectric Properties ◽  
Conventional Heating ◽  
Sintering Process ◽  
Microwave Dielectric ◽  
Sintering Time ◽  
Frequency Temperature

The (1–x)Ca0.61La0.26TiO3-xNd(Mg0.5Ti0.5)O3 [(1–x)CLT-xNMT, x = 0.35~0.60] ceramics were prepared via microwave sintering. The effects of sintering temperature and composition on the phase formation, microstructure, and microwave dielectric properties were investigated. The results show that the microwave sintering process requires a lower sintering temperature and shorter sintering time of (1–x)CLT-xNMT ceramics than conventional heating methods. All of the (1–x)CLT-xNMT ceramics possess a single perovskite structure. With the increase of x, the dielectric constant (ε) shows a downward trend; the quality factor (Qf) drops first and then rises significantly; the resonance frequency temperature coefficient (τf) keeps decreasing. With excellent microwave dielectric properties (ε = 51.3, Qf = 13,852 GHz, τf = −1.9 × 10−6/°C), the 0.65CLT-0.35NMT ceramic can be applied to the field of mobile communications.

Sign in / Sign up

Export Citation Format

Share Document