Plastic-Damage Modeling of Unreinforced Masonry Walls (URM) Subject to Lateral Loading

2017 ◽  
Vol 42 (9) ◽  
pp. 4201-4220 ◽  
Author(s):  
Basheer H. AlGohi ◽  
Mohammed H. Baluch ◽  
Muhammad K. Rahman ◽  
Ali H. Al-Gadhib ◽  
Cem Demir
Keyword(s):  
Unreinforced Masonry ◽  
Lateral Loading ◽  
Masonry Walls ◽  
Damage Modeling ◽  
Plastic Damage

Assessing vibration induced damage in unreinforced masonry walls subject to vehicular impact – A numerical study

2021 ◽  
Vol 245 ◽  
pp. 112843
Author(s):  
Mohammad Asad ◽  
Tatheer Zahra ◽  
David P Thambiratnam ◽  
Tommy H.T. Chan ◽  
Yan Zhuge
Keyword(s):  
Numerical Study ◽  
Unreinforced Masonry ◽  
Masonry Walls

Full‐scale shake‐table tests on two unreinforced masonry cavity‐wall buildings: effect of an innovative timber retrofit

2021 ◽  
Author(s):  
Marco Miglietta ◽  
Nicolò Damiani ◽  
Gabriele Guerrini ◽  
Francesco Graziotti
Keyword(s):  
Seismic Vulnerability ◽  
Concrete Slab ◽  
Cost Effective ◽  
Unreinforced Masonry ◽  
Full Scale ◽  
Cavity Wall ◽  
Masonry Walls ◽  
Shake Table ◽  
Earthquake Excitation ◽  
Reinforced Concrete Slab

AbstractTwo full-scale building specimens were tested on the shake-table at the EUCENTRE Foundation laboratories in Pavia (Italy), to assess the effectiveness of an innovative timber retrofit solution, within a comprehensive research campaign on the seismic vulnerability of existing Dutch unreinforced masonry structures. The buildings represented the end-unit of a two-storey terraced house typical of the North-Eastern Netherlands, a region affected by induced seismicity over the last few decades. This building typology is particularly vulnerable to earthquake excitation due to lack of seismic details and irregular distribution of large openings in masonry walls. Both specimens were built with the same geometry. Their structural system consisted of cavity walls, with interior load-bearing calcium-silicate leaf and exterior clay veneer, and included a first-floor reinforced concrete slab, a second-floor timber framing, and a roof timber structure supported by masonry gables. A timber retrofit was designed and installed inside the second specimen, providing an innovative sustainable, light-weight, reversible, and cost-effective technique, which could be extensively applied to actual buildings. Timber frames were connected to the interior surface of the masonry walls and completed by oriented strands boards nailed to them. The second-floor timber diaphragm was stiffened and strengthened by a layer of oriented-strand boards, nailed to the existing joists and to additional blocking elements through the existing planks. These interventions resulted also in improved wall-to-diaphragm connections with the inner leaf at both floors, while steel ties were added between the cavity-wall leaves. The application of the retrofit system favored a global response of the building with increased lateral capacities of the masonry walls. This paper describes in detail the bare and retrofitted specimens, compares the experimental results obtained through similar incremental dynamic shake-table test protocols up to near-collapse conditions, and identifies damage states and damage limits associated with displacements and deformations.

scholarly journals Numerical Modeling of Unreinforced Masonry Walls Strengthened with Fe-Based Shape Memory Alloy Strips

Materials ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 2961
Author(s):  
Moein Rezapour ◽  
Mehdi Ghassemieh ◽  
Masoud Motavalli ◽  
Moslem Shahverdi
Keyword(s):  
Energy Dissipation ◽  
Shape Memory Alloy ◽  
Shape Memory ◽  
Unreinforced Masonry ◽  
Masonry Wall ◽  
Masonry Walls ◽  
Vertical Strip ◽  
Maximum Resistance ◽  
The Cross ◽  
Post Tensioning

This study presents a new way to improve masonry wall behavior. Masonry structures comprise a significant part of the world’s structures. These structures are very vulnerable to earthquakes, and their performances need to be improved. One way to enhance the performances of such types of structures is the use of post-tensioning reinforcements. In the current study, the effects of shape memory alloy as post-tensioning reinforcements on originally unreinforced masonry walls were investigated using finite element simulations in Abaqus. The developed models were validated based on experimental results in the literature. Iron-based shape memory alloy strips were installed on masonry walls by three different configurations, namely in cross or vertical forms. Seven macroscopic masonry walls were modeled in Abaqus software and were subjected to cyclic loading protocol. Parameters such as stiffness, strength, durability, and energy dissipation of these models were then compared. According to the results, the Fe-based strips increased the strength, stiffness, and energy dissipation capacity. So that in the vertical-strip walls, the stiffness increases by 98.1%, and in the cross-strip model's position, the stiffness increases by 127.9%. In the vertical-strip model, the maximum resistance is equal to 108 kN, while in the end cycle, this number is reduced by almost half and reaches 40 kN, in the cross-strip model, the maximum resistance is equal to 104 kN, and in the final cycle, this number decreases by only 13.5% and reaches 90 kN. The scattering of Fe-based strips plays an important role in energy dissipation. Based on the observed behaviors, the greater the scattering, the higher the energy dissipation. The increase was more visible in the walls with the configuration of the crossed Fe-based strips.

Resistance of Reinforced Concrete Frames with Masonry Infill Walls to In-Plane Vertical Loading

2016 ◽  
Vol 711 ◽  
pp. 982-988
Author(s):  
Alex Brodsky ◽  
David Z. Yankelevsky
Keyword(s):  
Reinforced Concrete ◽  
Failure Modes ◽  
Progressive Collapse ◽  
Lateral Loading ◽  
Masonry Walls ◽  
Reinforced Concrete Frame ◽  
Masonry Infill ◽  
Concrete Frame ◽  
Vertical Loading ◽  
Infill Masonry

Numerous studies have been conducted on the in plane behavior of masonry infill walls to lateral loading simulating earthquake action on buildings. The present study is focused on a problem that has almost not been studied regarding the vertical (opposed to lateral) in-plane action on these walls. This may be of concern when a supporting column of a multi-storey reinforced concrete frame with infill masonry walls undergoes a severe damage due to an extreme loading such as a strong earthquake, car impact or military or terror action in proximity to the column. The loss of the supporting column may cause a fully or partly progressive collapse to a bare reinforced concrete frame, without infill masonry walls. The presence of the infill masonry walls may restrain the process and prevent the development of a progressive collapse. The aim of the present study is to test the in-plane composite action of Reinforced Concrete (RC) frames with infill masonry walls under vertical loading through laboratory experiments and evaluate the contributions of infill masonry walls, in an attempt to examine the infill masonry wall added resistance to the bare frame under these circumstances. Preliminary results of laboratory tests that have been conducted on reinforced concrete infilled frames without a support at their end, under monotonic vertical loading along that column axis will be presented. The observed damages and failure modes under vertical loading are clearly different from the already known failure modes observed in the case of lateral loading.

Out-of-plane strength reduction of unreinforced masonry walls because of in-plane damages

2015 ◽  
Vol 44 (13) ◽  
pp. 2157-2176 ◽  
Author(s):  
Kiarash M. Dolatshahi ◽  
Mohammad Yekrangnia
Keyword(s):  
Unreinforced Masonry ◽  
Strength Reduction ◽  
Masonry Walls ◽  
Out Of Plane

Experimental testing of unreinforced masonry walls with openings subject to cyclic in-plane shear

2016 ◽  
pp. 1401-1408 ◽  
Author(s):  
C. Allen ◽  
M.J. Masia ◽  
A.W. Page ◽  
M.C. Griffith ◽  
H. Derakhshan ◽  
...  
Keyword(s):  
Experimental Testing ◽  
Unreinforced Masonry ◽  
Masonry Walls ◽  
Plane Shear

scholarly journals Numerical simulation of soft brick unreinforced masonry walls subjected to lateral loads

2018 ◽  
Vol 5 (1) ◽  
pp. 1551503
Author(s):  
Jayaprakash Vemuri ◽  
Syed Ehteshamuddin ◽  
Subramaniam Kolluru ◽  
Massimo Latour
Keyword(s):  
Numerical Simulation ◽  
Unreinforced Masonry ◽  
Masonry Walls ◽  
Lateral Loads
Sign in / Sign up

Export Citation Format

Share Document