Residual Strength of Weakly Cemented Kaolin Clay in Multi-stage Ring Shear Test

2021 ◽  
Author(s):  
Nguyen Thanh Duong ◽  
Nguyen Van Hai
Keyword(s):  
Residual Strength ◽  
Shear Test ◽  
Kaolin Clay ◽  
Ring Shear Test ◽  
Multi Stage ◽  
Ring Shear

Residual strength of smectite-dominated soils from the Kamenose landslide in Japan

1987 ◽  
Vol 24 (3) ◽  
pp. 456-462 ◽  
Author(s):  
Seiichi Gibo ◽  
Kazuhiko Egashira ◽  
Masami Ohtsubo
Keyword(s):  
Residual Strength ◽  
Shear Test ◽  
Slip Surface ◽  
Clay Fraction ◽  
Particle Orientation ◽  
Shear Mode ◽  
Ring Shear Test ◽  
Ring Shear ◽  
Shearing Resistance ◽  
Clay Fraction Content

The residual strength of smectite-dominated soils from the main slip surfaces of the Kamenose landslide, Japan, was measured by ring shear test, and the relations of the residual strength to the clay fraction content and clay particle orientation were studied. The residual angles of shearing resistance, [Formula: see text], were estimated assuming that the residual cohesion is zero. The magnitude of the residual angle of shearing resistance was dependent on the <2-μm clay fraction content, CF, and on the effective normal stress, [Formula: see text], because of curved strength lines. At [Formula: see text] equivalent to the overburden pressures, the soils had [Formula: see text] of 6–8°. These residual angles of shearing resistance were fitted on the [Formula: see text] – CF line for sand–bentonite mixtures, and exhibited the sliding shear mode.The orientation of smectite particles on shear surfaces showing slickensides was assessed by X-ray diffraction technique. The orientation of smectite particles was found to reduce the residual strength considerably, and this orientation effect was revealed more clearly at low effective normal stresses. Key words: residual strength, particle orientation, landslide, smectite, shear mode, slip surface, slickenside, clay mineral, physicochemical properties, ring shear test.

Effect of cyclic loading on the residual strength of over-consolidated silty clay in a ring shear test

Landslides ◽  
2011 ◽  
Vol 8 (2) ◽  
pp. 233-240 ◽  
Author(s):  
Yong Hong ◽  
Guangming Yu ◽  
Yingxia Wu ◽  
Xiaoyu Zheng
Keyword(s):  
Cyclic Loading ◽  
Residual Strength ◽  
Shear Test ◽  
Silty Clay ◽  
Ring Shear Test ◽  
Ring Shear

scholarly journals Relation between Residual Strength and Shear Displacement of Clay in Ring Shear Test.

1997 ◽  
pp. 141-158
Author(s):  
Motoyuki Suzuki ◽  
Takeo Umezaki ◽  
Hiroshi Kawakami
Keyword(s):  
Residual Strength ◽  
Shear Test ◽  
Shear Displacement ◽  
Ring Shear Test ◽  
Ring Shear

Surface Analysis of Shear Strength Tested Tungsten Carbide Thermal Spray Coatings+

1997 ◽  
Vol 3 (S2) ◽  
pp. 791-792 ◽  
Author(s):  
S. V. Naidu ◽  
Carlos Green ◽  
Christopher Maxie ◽  
James D. Garber ◽  
Gary A. Glass
Keyword(s):  
Thermal Spray ◽  
Adhesive Strength ◽  
Shear Test ◽  
Spray Coating ◽  
Test Method ◽  
Thermal Spray Coatings ◽  
Oxide Content ◽  
Ring Shear Test ◽  
Spray Coatings ◽  
Ring Shear

Thermal spray processing has become an important powder-consolidation technique to yield new materials for extremes of temperature, radiation, wear, corrosion and mechanical stresses. High Velocity Oxy-Fuel (HVOF) spray coating process gives higher deposition densities and coating hardness; lower oxide content and porosity. The adhesive strength of thermal spray coatings is greatly effected by the interfacial impurities. The ring shear test method shown in Fig. 1 appears to give the most accurate results on shear adhesive strength. A typical ring shear test result of 88WC12Co 1/4" ring HVOF thermal spray coating on 4140 steel rod using a Jet kote thermal spray gun is shown in Fig. 2. Repeated ring shear tests on similar samples prepared under same spray and test conditions resulted in different shear bond strength and coating ring displacement before break off. We examined the ring shear tested coatings using a Zeiss DMS942 Scanning Electron Microscope (SEM) and Kevex Energy Dispersive X-ray Spectrometer (EDXS) with LPX1 Quantum Si(Li) Detector.

Sign in / Sign up

Export Citation Format

Share Document