Effects of Zr/Mo addition on He bubble formation in Y2O3-added W alloys

Tungsten ◽  
2022 ◽  
Author(s):  
Qiu Xu ◽  
M. Miyamoto ◽  
Lai-Ma Luo
Keyword(s):  
Bubble Formation

Direct observations of radiation-enhanced transformations in glass

1983 ◽  
Vol 41 ◽  
pp. 354-355
Author(s):  
J. F. DeNatale ◽  
D. G. Howitt
Keyword(s):  
Glass Matrix ◽  
Diffusion Mechanism ◽  
Bubble Formation ◽  
Silicate Glasses ◽  
Phase Decomposition ◽  
Direct Observations ◽  
Thin Foils ◽  
Oxygen Bubble ◽  
Electron Energy Loss ◽  
Kinetics Of

The electron irradiation of silicate glasses containing metal cations produces various types of phase separation and decomposition which includes oxygen bubble formation at intermediate temperatures figure I. The kinetics of bubble formation are too rapid to be accounted for by oxygen diffusion but the behavior is consistent with a cation diffusion mechanism if the amount of oxygen in the bubble is not significantly different from that in the same volume of silicate glass. The formation of oxygen bubbles is often accompanied by precipitation of crystalline phases and/or amorphous phase decomposition in the regions between the bubbles and the detection of differences in oxygen concentration between the bubble and matrix by electron energy loss spectroscopy cannot be discerned (figure 2) even when the bubble occupies the majority of the foil depth.The oxygen bubbles are stable, even in the thin foils, months after irradiation and if van der Waals behavior of the interior gas is assumed an oxygen pressure of about 4000 atmospheres must be sustained for a 100 bubble if the surface tension with the glass matrix is to balance against it at intermediate temperatures.

Considerations about mass and energy flow in discontinuous evaporating crystallizers

2016 ◽  
pp. 514-516
Author(s):  
Martin Bruhns
Keyword(s):  
Energy Flow ◽  
Static Pressure ◽  
Bubble Formation ◽  
Boiling Temperature ◽  
Vapor Bubbles ◽  
Local Pressure ◽  
Heating Steam ◽  
Flow Changes ◽  
Local Superheating ◽  
Local Supersaturation

The massecuite circulates in a loop within the evaporating crystallizing vessel. The massecuite flows upwards through the heating tubes. In the room above the calandria the massecuite flow changes its direction to radial inwards and then to vertical downwards. An impeller in the central tube forces the circulation. Below the calandria the main direction of flow is radially outwards until threads of the massecuite stream enter the heating tubes in upwards direction. Within the tubes heat is transferred to the massecuite. At low temperature differences between heating steam and massecuite and higher levels of the massecuite in the crystallizer vapor bubbles are not found in the tubes. Vapor bubbles can be formed at a massecuite level in the crystallizer where the temperature of the massecuite is higher than the local boiling temperature of water, which depends on the local pressure (including the static pressure of the massecuite at this point) and the boiling point elevation of the mother liquor. The surface tension of the liquid is a resistance against the bubble formation, which has to be overcome by the local superheating i.e. the part of the enthalpy of the massecuite exceeding the local boiling temperature. The formation and the flow of the bubbles change the density of the massecuite/bubbles mixture and has an influence on the massecuite flow. The formation of a vapour bubble is connected with a local drop of the massecuite temperature which changes the local supersaturation. Today the heat transfer into the magma is quite well known but the process of bubble formation is quite unknown. Some basic considerations about the formation of bubbles and its influence on local supersaturation based on calculation of heat and mass balances and models of bubble formation are be given and discussed. Experiments for basic investigations are proposed.

Hyperbaric treatment of air or gas embolism: current recommendations

2019 ◽  
pp. 673-683
Author(s):  
Richard E. Moon ◽  
Keyword(s):  
Animal Studies ◽  
Decompression Sickness ◽  
Bubble Formation ◽  
Endothelial Damage ◽  
Neurological Deficits ◽  
Breath Hold ◽  
Gas Embolism ◽  
Hyperbaric Treatment ◽  
Pulmonary Capillaries ◽  
Venous Gas Embolism

Gas can enter arteries (arterial gas embolism, AGE) due to alveolar-capillary disruption (caused by pulmonary over-pressurization, e.g. breath-hold ascent by divers) or veins (venous gas embolism, VGE) as a result of tissue bubble formation due to decompression (diving, altitude exposure) or during certain surgical procedures where capillary hydrostatic pressure at the incision site is subatmospheric. Both AGE and VGE can be caused by iatrogenic gas injection. AGE usually produces stroke-like manifestations, such as impaired consciousness, confusion, seizures and focal neurological deficits. Small amounts of VGE are often tolerated due to filtration by pulmonary capillaries; however VGE can cause pulmonary edema, cardiac “vapor lock” and AGE due to transpulmonary passage or right-to-left shunt through a patient foramen ovale. Intravascular gas can cause arterial obstruction or endothelial damage and secondary vasospasm and capillary leak. Vascular gas is frequently not visible with radiographic imaging, which should not be used to exclude the diagnosis of AGE. Isolated VGE usually requires no treatment; AGE treatment is similar to decompression sickness (DCS), with first aid oxygen then hyperbaric oxygen. Although cerebral AGE (CAGE) often causes intracranial hypertension, animal studies have failed to demonstrate a benefit of induced hypocapnia. An evidence-based review of adjunctive therapies is presented.

Sign in / Sign up

Export Citation Format

Share Document