Assessment of air flow patterns of trace element transfer from the continents to the ocean

1988 ◽  
Vol 70 (1-2) ◽  
pp. 94
Author(s):  
G. Bergametti ◽  
D. Martin ◽  
F. Dulac ◽  
P. Buat-Menard
Author(s):  
Anne-Aziliz Pelleter ◽  
Gaëlle Prouteau ◽  
Bruno Scaillet

Abstract We performed phase equilibrium experiments on a natural Ca-poor pelite at 3 GPa, 750-1000 °C, under moderately oxidizing conditions, simulating the partial melting of such lithologies in subduction zones. Experiments investigated the effect of sulphur addition on phase equilibria and compositions, with S contents of up to ∼ 2.2 wt. %. Run products were characterized for their major and trace element contents, in order to shed light on the role of sulphur on the trace element patterns of melts produced by partial melting of oceanic Ca-poor sediments. Results show that sulphur addition leads to the replacement of phengite by biotite along with the progressive consumption of garnet, which is replaced by an orthopyroxene-kyanite assemblage at the highest sulphur content investigated. All Fe-Mg silicate phases produced with sulphur, including melt, have higher MgO/(MgO+FeO) ratios (relative to S-free/poor conditions), owing to Fe being primarily locked up by sulphide in the investigated redox range. Secular infiltration of the mantle wedge by such MgO and K2O-rich melts may have contributed to the Mg and K-rich character of the modern continental crust. Addition of sulphur does not affect significantly the stability of the main accessory phases controlling the behaviour of trace elements (monazite, rutile and zircon), although our results suggest that monazite solubility is sensitive to S content at the conditions investigated. The low temperature (∼ 800 °C) S-bearing and Ca-poor sediment sourced slab melts show Th and La abundances, Th/La systematics and HFSE signatures in agreement with the characteristics of sediment-rich arc magmas. Because high S contents diminish phengite and garnet stabilities, S-rich and Ca-poor sediment sourced slab melts have higher contents of Rb, B, Li (to a lesser extent), and HREE. The highest ratios of La/Yb are observed in sulphur-poor runs (with a high proportion of garnet, which retains HREE) and beyond the monazite out curve (which retains LREE). Sulphides appear to be relatively Pb-poor and impart high Pb/Ce ratio to coexisting melts, even at high S content. Overall, our results show that Phanerozoic arc magmas from high sediment flux margins owe their geochemical signature to the subduction of terrigenous, sometimes S-rich, sediments. In contrast, subduction of such lithologies during Archean appears unlikely or unrecorded.


Minerals ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 394
Author(s):  
Richen Zhong ◽  
Min Zhang ◽  
Chang Yu ◽  
Hao Cui

A subduction zone plays a critical role in forging continental crust via formation of arc magmas, which are characteristically enriched in large ion lithophile elements (LILEs) and depleted in high field strength elements (HFSEs). This trace element pattern results from the different mobilities of LILEs and HFSEs during slab-to-wedge mass transfer, but the mechanisms of trace element transfer from subducting crusts are not fully understood. In this study, thermodynamic simulations are carried out to evaluate the mobilities of K and Zr, as representative cases of LILE and HFSE, respectively, in slab fluids. The fluids buffered by basaltic eclogite can dissolve > 0.1 molal of K at sub-arc depths (~3 to 5.5 GPa). However, only minor amounts of K can be liberated by direct devolatilization of altered oceanic basalt, because sub-arc dehydration mainly takes place at temperatures < 600 °C (talc-out), wherein the fluid solubility of K is very limited (<0.01 molal). Therefore, serpentinite-derived fluids are required to flush K from the eclogite. The solubility of K can be enhanced by the addition of NaCl to the fluid, because fluid Na+ can unlock phengite-bonded K via a complex ion exchange. Finally, it is further confirmed that Zr and other HFSEs are immobile in slab fluids.


2021 ◽  
Vol 13 (9) ◽  
pp. 4748
Author(s):  
Edwin Villagran ◽  
Carlos Bojacá ◽  
Mohammad Akrami

The use of covered structures is an alternative increasingly used by farmers to increase crop yields per unit area compared to open field production. In Latin American countries such as Colombia, productive areas are located in with predominantly hillside soil conditions. In the last two decades, farmers have introduced cover structures adapted to these soil conditions, structures for which the behavior of factors that directly affect plant growth and development, such as microclimate, are still unknown. Therefore, in this research work, a CFD-3D model successfully validated with experimental data of temperature and air velocity was implemented. The numerical model was used to determine the behavior of air flow patterns and temperature distribution inside a Colombian passive greenhouse during daytime hours. The results showed that the slope of the terrain affects the behavior of the air flow patterns, generating thermal gradients inside the greenhouse with values between 1.26 and 16.93 °C for the hours evaluated. It was also found that the highest indoor temperature values at the same time were located in the highest region of the terrain. Based on the results of this study, future researches on how to optimize the microclimatic conditions of this type of sustainable productive system can be carried out.


1986 ◽  
Vol 33 (3) ◽  
pp. 187-203
Author(s):  
T.G. Kelly ◽  
V.A. Dodd ◽  
D.J. Ruane
Keyword(s):  
Air Flow ◽  

Sign in / Sign up

Export Citation Format

Share Document