Vacuum system design for the 300 m gravitational wave laser interferometer in Japan (TAMA300)

Vacuum ◽  
1996 ◽  
Vol 47 (6-8) ◽  
pp. 609-611 ◽  
Author(s):  
Y Saito ◽  
N Matuda ◽  
Y Ogawa ◽  
G Horikoshi
Vacuum ◽  
1999 ◽  
Vol 53 (1-2) ◽  
pp. 353-356 ◽  
Author(s):  
Y. Saito ◽  
Y. Ogawa ◽  
G. Horikoshi ◽  
N. Matuda ◽  
R. Takahashi ◽  
...  

Vacuum ◽  
2001 ◽  
Vol 60 (1-2) ◽  
pp. 3-8 ◽  
Author(s):  
Y. Saito ◽  
G. Horikoshi ◽  
R. Takahashi ◽  
M. Fukushima

1989 ◽  
Vol 32 (6) ◽  
pp. 28-32
Author(s):  
Jeffrey Livas ◽  
Boude Moore

A laser interferometer gravitational wave observatory (LIGO) is being developed with sensitivities that will have a high probability of detecting gravitational waves from astrophysical sources. Detectors are also planned by others in Europe and eventually in space. A major component of the proposed LIGO is a total of 16 km (10 miles) of 1.2 m (48 in.) dia tube at a pressure of less than 10-8torn It will be of 304 L stainless steel procured directly from the steel mills with the initial hydrogen content specially reduced. (Target is 1 ppm by weight.) Projections of the outgassing rates of hydrogen and of water vapor as a function of time will be given and the uncertainties discussed. Based on these, a preliminary analysis of the vacuum system will be presented.


2009 ◽  
Vol 72 (7) ◽  
pp. 076901 ◽  
Author(s):  
B P Abbott ◽  
R Abbott ◽  
R Adhikari ◽  
P Ajith ◽  
B Allen ◽  
...  

Sensors ◽  
2021 ◽  
Vol 21 (5) ◽  
pp. 1877
Author(s):  
Nikolai Petrov ◽  
Vladislav Pustovoit

It is highly desirable to have a compact laser interferometer for detecting gravitational waves. Here, a small-sized tabletop laser interferometer with Fabry–Perot resonators consisting of two spatially distributed “mirrors” for detecting gravitational waves is proposed. It is shown that the spectral resolution of 10−23 cm−1 can be achieved at a distance between mirrors of only 1–3 m. The influence of light absorption in crystals on the limiting resolution of such resonators is also studied. A higher sensitivity of the interferometer to shorter-wave laser radiation is shown. A method for detecting gravitational waves is proposed based on the measurement of the correlation function of the radiation intensities of non-zero-order resonant modes from the two arms of the Mach–Zehnder interferometer.


Author(s):  
Kun Chen ◽  
Xiaofeng Zhang ◽  
Tong Guo ◽  
Zhi-Ming Cai ◽  

The observation of gravitational wave enables human to explore the origin, formation and evolution of universe governed by the gravitational interaction and the nature of gravity beyond general theory of relativity. The groundbreaking discovery of Gravitational Wave by Laser Interferometer Gravitational-Wave Observatory provides a brand-new observation way. While detecting gravitational wave on ground is limited by noises and test scale, space detection is an optimized alternative to learn rich sources in range of 0.1 mHz–1 Hz. Considering the great significance of space gravitational wave detection, ESA proposed LISA project, CAS also proposed Taiji project. Due to the extremely weak gravitational wave signal and high measurement accuracy requirement, the spaceborne GW observation antenna is accomplished by three spacecrafts constitute isosceles triangle formation intersatellite interferometer. The arm length of the interferometer reaches millions of kilometers between them, and the measurement accuracy reaches pico-meter magnitude. There are many key technologies including pm magnitude space laser interferometer metrology, drag-free control using TM of Gravity Reference Sensor, [Formula: see text]N micro thruster, ultra-clean & ultra-stable spacecraft, etc. This paper focuses on key technologies of the ultra-clean & ultra-stable spacecraft, analyzing the design of mechanical, thermal control and magnetic clean. Moreover, it reports the preliminary results of the technological breakthrough.


Sign in / Sign up

Export Citation Format

Share Document