The quasihole aspect of hole strength distributions in odd potassium and calcium isotopes

1976 ◽  
Vol 263 (2) ◽  
pp. 210-236 ◽  
Author(s):  
P. Doll ◽  
G.J. Wagner ◽  
K.T. Knöpfle ◽  
G. Mairle
2008 ◽  
Vol 268 (1-2) ◽  
pp. 124-136 ◽  
Author(s):  
Elizabeth M. Griffith ◽  
Adina Paytan ◽  
Reinhard Kozdon ◽  
Anton Eisenhauer ◽  
A. Christina Ravelo

1979 ◽  
Vol 85 (2-3) ◽  
pp. 167-171 ◽  
Author(s):  
B.A. Brown ◽  
S.E. Massen ◽  
P.E. Hodgson

1972 ◽  
Vol 27 (2) ◽  
pp. 126-133 ◽  
Author(s):  
Klaus Gustav Heumann ◽  
Karl Heinrich Lieser

The following heterogeneous exchange equilibria have been examined for isotopic effects: CaCO3/Ca(aq.)2⊕. Ca-GBHA/Ca(aq.)2⊕ and Ca(Dowex 50)2⊕/Ca(aq.)2⊕ (GBHA = glyoxal-bis (2-hydroxyanil)). The isotopic ratios 44Ca/40Ca and 48Ca/40Ca were determined by means of a mass spectrometer with a thermal ion source. In the system CaCO3/Ca(aq.)2⊕, the elementary separation factor was found to be less than 1‰ or 0,5‰ per mass unit, respectively.For the exchange in the system Ca-GBHA/Ca(aq.)2⊕ in the concentration range from 0.011 to 0.84 M an elementary separation factor less than 1‰ per mass unit was found; from a three-stage experiment at a calcium concentration of 1.23 M it was concluded that the elementary isotopic effect is less than 0.4‰ per mass unit. Therefore no isotopic fractionation is to be expected for precipitation of inorganic or organic calcium salts.An enrichment of the heavier calcium isotopes in the solution was found in the case of the exchange in a Dowex 50-X12 loaded column. The isotopic effect depends on the concentration of the hydrochloric acid used as the eluent.


1970 ◽  
Vol 24 (4) ◽  
pp. 145-148 ◽  
Author(s):  
L. R. B. Elton ◽  
S. J. Webb

1985 ◽  
Vol 63 (3) ◽  
pp. 417-427 ◽  
Author(s):  
Ashok Kumar ◽  
William J. Meath

Dipole oscillator strength distributions have been constructed and used to evaluate integrated oscillator strengths, and a variety of dipole oscillator strength properties, for ground state SO2, CS2, and OCS. Each distribution has been constructed by using experimental and theoretical photoabsorption cross sections and by subjecting the resulting dipole oscillator strength data to constraints provided by the Thomas–Reiche–Kuhn sum rule and molar refractivity data for the relevant dilute gases. The discussion includes graphical presentations of how various spectral regions of the dipole oscillator strength distributions contribute to the more important dipole properties.


1983 ◽  
Vol 27 (1) ◽  
pp. 405-407 ◽  
Author(s):  
A. Saha ◽  
Kamal K. Seth ◽  
H. Nann

Author(s):  
Vladimir A. Avakov

Abstract In the previous publication [2], the transformation between fatigue life and strength distribution was established using double-logarithmic coordinate system (lnN-lnS). Here, a similar transformation is established using a semi logarithmic (lnN-S) coordinate system. With the aid of the developed orthogonal relations, lognormal, Weibull and three-parameter logweibull life distributions have been transformed into normal, asymptotic type 1 of smallest value, and three-parameter Weibull strength distributions, respectively. This procedure may be applied to other types of fatigue life distribution.


Author(s):  
D. L. Shelleman ◽  
O. M. Jadaan ◽  
J. C. Conway ◽  
J. J. Mecholsky

Abstract The strength distribution of reaction bonded silicon carbide tubes that failed by internal pressurization was predicted from strength distributions obtained from simple laboratory test specimens at room temperature. The strength distributions of flexure bars, C-rings tested in tension, C-rings tested in compression, diametrally compressed O-rings, and internally pressurized short tubes were compared to the strength distribution of internally pressurized long tubes. The methodology involved application of Weibull statistical theory using elasticity theory to define the stress distributions in the simple specimens. The flexural specimens did not yield acceptable results, since they were ground prior to testing, thereby altering their flaw population in comparison with the processing induced flaw populations of the tubular specimens. However, the short tube internal pressure test, the c-ring tested in tension and the diametrally compressed o-ring test configurations yielded accurate predictions, since these specimens more accurately represent the strength limiting flaw population in the long tubes.


Sign in / Sign up

Export Citation Format

Share Document