Viscoelastic fluids in turbulent pipe flow — A new heat transfer correlation

1980 ◽  
Vol 7 (5) ◽  
pp. 347-351
Author(s):  
Y Cho
1978 ◽  
Vol 100 (2) ◽  
pp. 224-229 ◽  
Author(s):  
O. T. Hanna ◽  
O. C. Sandall

Analytical approximations are developed to predict the effect of a temperature-dependent viscosity on convective heat transfer through liquids in fully developed turbulent pipe flow. The analysis expresses the heat transfer coefficient ratio for variable to constant viscosity in terms of the friction factor ratio for variable to constant viscosity, Tw, Tb, and a fluid viscosity-temperature parameter β. The results are independent of any particular eddy diffusivity distribution. The formulas developed here represent an analytical approximation to the model developed by Goldmann. These approximations are in good agreement with numerical solutions of the model nonlinear differential equation. To compare the results of these calculations with experimental data, a knowledge of the effect of variable viscosity on the friction factor is required. When available correlations for the friction factor are used, the results given here are seen to agree well with experimental heat transfer coefficients over a considerable range of μw/μb.


Author(s):  
Alparslan Oztekin ◽  
Sudhakar Neti ◽  
Ananchai Ukaew

Spatial and temporal characteristics of turbulent pipe flows using nanofluids and dilute polymer solutions are examined by means of instantaneous differential pressure and velocity measurements. Spherical and elongated nanosilica particles (SiO2) are mixed into water to make nanofluid and polyacrylamide (PAC) is dissolved into water to make PAC solution. The effects of nanofluid on the drag reduction and turbulent structure are determined and compared with the effects of polymer additives on the turbulent structures and drag reduction. Suppression of turbulence near pipe wall was observed with the introduction of both spherical and elongated nanoparticles. Although experimental results show that nanofluids are not candidates for drag reduction unlike polymer additives, they do not increase pressure drop. Hence addition of nanoparticles into heat transfer fluids could have the potential for heat transfer enhancement in pipe flow without paying the penalty of increasing pumping power.


Sign in / Sign up

Export Citation Format

Share Document