The effectiveness of cocoa agroforests depends on shade-tree canopy height

2021 ◽  
Vol 322 ◽  
pp. 107676
Author(s):  
W.J. Blaser-Hart ◽  
S.P. Hart ◽  
J. Oppong ◽  
D. Kyereh ◽  
E. Yeboah ◽  
...  
Keyword(s):  
2015 ◽  
Vol 24 (7) ◽  
pp. 814-825 ◽  
Author(s):  
Uri Roll ◽  
Eli Geffen ◽  
Yoram Yom-Tov

2020 ◽  
Vol 145 (3) ◽  
pp. 193-202
Author(s):  
Yi Gong ◽  
Ronald B. Pegg ◽  
Adrian L. Kerrihard ◽  
Brad E. Lewis ◽  
Richard J. Heerema

Pecan (Carya illinoinensis) is a tree nut native to North America. Although inhibited light exposure (most specifically as a result of overlapping tree canopies) has been shown to impair yield, the effect of this factor on nut antioxidant properties remains unknown. This study investigated effects of mechanical pruning and canopy height position of fruit on pecan kernel antioxidant contents and capacity. Beginning in 2006, trees in a ‘Western’ pecan orchard in New Mexico were subjected to three mechanical pruning frequency treatments (annual, biennial, and triennial) paralleling conventional practices, while other trees were maintained as unpruned controls. During the 2012 to 2014 seasons, pecans were sampled at fruit maturity from three canopy height zones (“low,” “middle,” and “high,” corresponding to 1.5 to 3.0 m, 3.0 to 4.5 m, and 4.5 to 6.0 m above the orchard floor). In vitro phenolics contents and antioxidant capacities of the nutmeats were evaluated by total phenolics content (TPC) and oxygen radical absorbance capacity (H-ORACFL), respectively. Soluble ester- and glycoside-bound phenolics were quantified by reversed-phase high-performance liquid chromatography (HPLC). For both TPC and H-ORACFL, results determined pruned samples had significantly higher values than unpruned samples (P < 0.001 for both comparisons), and that samples of “high” canopy height were significantly greater than those of “middle” height, which were in turn greater than those of “low” height (P < 0.001 for all comparisons). HPLC findings showed that in all three phenolic fractions (free, esterified, and glycoside-bound phenolics), nuts acquired from pruned trees had substantially greater concentrations of ellagic acid and its derivatives. Our findings indicate mechanical pruning of pecan trees and higher tree canopy position of fruit increase nut antioxidant properties.


2021 ◽  
Author(s):  
Merkebu Getachew ◽  
Kris Verheyen ◽  
Kassaye Tolessa ◽  
Biruk Ayalew ◽  
Kristoffer Hylander ◽  
...  

2008 ◽  
Vol 76 (2) ◽  
pp. 363-374 ◽  
Author(s):  
Naba R. Devkota ◽  
Peter D. Kemp ◽  
John Hodgson ◽  
Ian Valentine ◽  
I. Komang D. Jaya

2019 ◽  
Vol 434 ◽  
pp. 142-153 ◽  
Author(s):  
Geoffrey A. Fricker ◽  
Nicholas W. Synes ◽  
Josep M. Serra-Diaz ◽  
Malcolm P. North ◽  
Frank W. Davis ◽  
...  

2020 ◽  
Vol 12 (24) ◽  
pp. 4042
Author(s):  
Shashi Kumar ◽  
Himanshu Govil ◽  
Prashant K. Srivastava ◽  
Praveen K. Thakur ◽  
Satya P. S. Kushwaha

Spaceborne and airborne polarimetric synthetic-aperture radar interferometry (PolInSAR) data have been extensively used for forest parameter retrieval. The PolInSAR models have proven their potential in the accurate measurement of forest vegetation height. Spaceborne monostatic multifrequency data of different SAR missions and the Global Ecosystem Dynamics Investigation (GEDI)-derived forest canopy height map were used in this study for vegetation height retrieval. This study tested the performance of PolInSAR complex coherence-based inversion models for estimating the vegetation height of the forest ranges of Doon Valley, Uttarakhand, India. The inversion-based forest height obtained from the three-stage inversion (TSI) model had higher accuracy than the coherence amplitude inversion (CAI) model-based estimates. The vegetation height values of GEDI-derived canopy height map did not show good relation with field-measured forest height values. It was found that, at several locations, GEDI-derived forest height values underestimated the vegetation height. The statistical analysis of the GEDI-derived estimates with field-measured height showed a high root mean square error (RMSE; 5.82 m) and standard error (SE; 5.33 m) with a very low coefficient of determination (R2; 0.0022). An analysis of the spaceborne-mission-based forest height values suggested that the L-band SAR has great potential in forest height retrieval. TSI-model-based forest height values showed lower p-values, which indicates the significant relation between modelled and field-measured forest height values. A comparison of the results obtained from different SAR systems is discussed, and it is observed that the L-band-based PolInSAR inversion gives the most reliable result with low RMSE (2.87 m) and relatively higher R2 (0.53) for the linear regression analysis between the modelled tree height and the field data. These results indicate that higher wavelength PolInSAR datasets are more suitable for tree canopy height estimation using the PolInSAR inversion technique.


Sign in / Sign up

Export Citation Format

Share Document