Facile fabrication of superhydrophobic surfaces from austenitic stainless steel (AISI 304) by chemical etching

2018 ◽  
Vol 439 ◽  
pp. 598-604 ◽  
Author(s):  
Jae-Hun Kim ◽  
Ali Mirzaei ◽  
Hyoun Woo Kim ◽  
Sang Sub Kim
Keyword(s):  
Stainless Steel ◽  
Austenitic Stainless Steel ◽  
Chemical Etching ◽  
Superhydrophobic Surfaces ◽  
Aisi 304 ◽  
Steel Aisi ◽  
Facile Fabrication ◽  
Stainless Steel Aisi

scholarly journals Investigation on component wall angle in single stage incremental forming of austenitic stainless steel AISI 304 sheet

2020 ◽  
Vol 48 (2) ◽  
pp. 391-396
Author(s):  
Suresh Kumar ◽  
N. Ethiraj ◽  
T. Sivabalan ◽  
Mohamed Farhan ◽  
T. Bernadette
Keyword(s):  
Stainless Steel ◽  
Austenitic Stainless Steel ◽  
Incremental Forming ◽  
Single Stage ◽  
Wall Angle ◽  
Aisi 304 ◽  
Steel Aisi ◽  
Stainless Steel Aisi

Techanics Experiment Study on PcBN Cutting Tool Dry Turning Austenitic Stainless Steel AISI 304

2011 ◽  
Vol 341-342 ◽  
pp. 256-260
Author(s):  
Yun Hai Jia
Keyword(s):  
Stainless Steel ◽  
Austenitic Stainless Steel ◽  
Feed Rate ◽  
Cutting Tools ◽  
Cutting Speed ◽  
Aisi 304 ◽  
Dry Turning ◽  
Steel Aisi ◽  
Cut Depth ◽  
Stainless Steel Aisi

High deformation hardening, low thermal conductivity, high built-up edge tendency of austenitic stainless steels were the main factors that make their machinablity difficult. For determination of the suitable cutting parameters in machining austenitic stainless steel AISI 304 by PcBN cutting tools, the samples which were prepared to be used in the experiment, 300 mm in length and 60 mm in diameter, were dry machined in a numerical control lathe. During experiments, dry turning parameters, such as feed rate, cutting speed and cut depth were investigated. The suitable cutting speed and feed rate were determined according to workpieces surface roughness, cutting tools flank wear. Finally, cutting speed of 180 to 200 m/min, feed rate of 0.05 to 0.06 mm/rev and cut depth of 0.10 mm gave the satisfied results.

scholarly journals Effect of the Post-Weld Surface Condition on the Corrosion Resistance of Austenitic Stainless Steel AISI 304

2018 ◽  
Vol 2018 (1) ◽  
pp. 17-23 ◽  
Author(s):  
Grzegorz Rogalski ◽  
Mateusz Jurkowski ◽  
Jerzy Łabanowski ◽  
Dariusz Fydrych
Keyword(s):  
Stainless Steel ◽  
Corrosion Resistance ◽  
Austenitic Stainless Steel ◽  
Surface Condition ◽  
Aisi 304 ◽  
Steel Aisi ◽  
Stainless Steel Aisi
Sign in / Sign up

Export Citation Format

Share Document