Conductivity and microstructural evaluation of SGDC solid electrolytes synthetized by Pechini and controlled precipitation

The presence of interfacial films at the whisker-matrix interface can significantly influence the fracture toughness of ceramic composites. The film may alter the interface debonding process though changes in either the interfacial fracture energy or the residual stress at the interface. In addition, the films may affect the whisker pullout process through the frictional sliding coefficients or the extent of mechanical interlocking of the interface due to the whisker surface topography.Composites containing ACMC silicon carbide whiskers (SiCw) which had been coated with 5-10 nm of carbon and Tokai whiskers coated with 2 nm of carbon have been examined. High resolution electron microscopy (HREM) images of the interface were obtained with a JEOL 4000EX electron microscope. The whisker geometry used for HREM imaging is described in Reference 2. High spatial resolution (< 2-nm-diameter probe) parallel-collection electron energy loss spectroscopy (PEELS) measurements were obtained with a Philips EM400T/FEG microscope equipped with a Gatan Model 666 spectrometer.

Download Full-text

A TEM investigation of a hyper-eutectic lead-tin alloy

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s042482010010487x ◽

1988 ◽

Vol 46 ◽

pp. 562-563

Author(s):

John A. Sutliff

Keyword(s):

Volume Diffusion ◽

Eutectic Mixture ◽

Precipitation Reaction ◽

Directionally Solidified ◽

X Ray Diffraction ◽

X Ray ◽

Transmission Electron ◽

Diffusion Controlled ◽

Discontinuous Precipitation Reaction ◽

Controlled Precipitation

Near-eutectic Pb-Sn alloys are important solders used by the electronics industry. In these solders, the eutectic mixture, which solidifies last, is the important microstructural consituent. The orientation relation (OR) between the eutectic phases has previously been determined for directionally solidified (DS) eutectic alloys using x-ray diffraction or electron chanelling techniques. In the present investigation the microstructure of a conventionally cast, hyper-eutectic Pb-Sn alloy was examined by transmission electron microscopy (TEM) and the OR between the eutectic phases was determined by electron diffraction. Precipitates of Sn in Pb were also observed and the OR determined. The same OR was found in both the eutectic and precipitation reacted materials. While the precipitation of Sn in Pb was previously shown to occur by a discontinuous precipitation reaction,3 the present work confirms a recent finding that volume diffusion controlled precipitation can also occur.Samples that are representative of the solder's cast microstructure are difficult to prepare for TEM because the alloy is multiphase and the phases are soft.

Download Full-text

Development of Solid Electrolytes for All-Solid-State Batteries

NIPPON GOMU KYOKAISHI ◽

10.2324/gomu.92.430 ◽

2019 ◽

Vol 92 (11) ◽

pp. 430-434

Author(s):

Akitoshi HAYASHI ◽

Atsushi SAKUDA ◽

Masahiro TATSUMISAGO

Keyword(s):

Solid State ◽

Solid Electrolytes ◽

Solid State Batteries ◽

All Solid State Batteries

Download Full-text

How Certain Are the Reported Ionic Conductivities of Thiophosphate-Based Solid Electrolytes? an Interlaboratory Study

10.26434/chemrxiv.11316497.v2 ◽

2020 ◽

Author(s):

Saneyuki Ohno ◽

Tim Bernges ◽

Johannes Buchheim ◽

Marc Duchardt ◽

Anna-Katharina Hatz ◽

...

Keyword(s):

Standard Deviation ◽

Ionic Conductivity ◽

Relative Standard Deviation ◽

Solid Electrolytes ◽

Ionic Conductivities ◽

Ionic Conductors ◽

Energy Storage Devices ◽

Activation Barriers ◽

Storage Devices ◽

Relative Standard

Owing to highly conductive solid ionic conductors, all-solid-state batteries attract significant attention as promising next-generation energy storage devices. A lot of research is invested in the search and optimization of solid electrolytes with higher ionic conductivity. However, a systematic study of an interlaboratory reproducibility of measured ionic conductivities and activation energies is missing, making the comparison of absolute values in literature challenging. In this study, we perform an uncertainty evaluation via a Round Robin approach using different Li-argyrodites exhibiting orders of magnitude different ionic conductivities as reference materials. Identical samples are distributed to different research laboratories and the conductivities and activation barriers are measured by impedance spectroscopy. The results show large ranges of up to 4.5 mScm-1 in the measured total ionic conductivity (1.3 – 5.8 mScm-1 for the highest conducting sample, relative standard deviation 35 – 50% across all samples) and up to 128 meV for the activation barriers (198 – 326 meV, relative standard deviation 5 – 15%, across all samples), presenting the necessity of a more rigorous methodology including further collaborations within the community and multiplicate measurements.

Download Full-text

A New Phase of the Na+ Ion Conductor Na3PS4

10.26434/chemrxiv.8003717.v1 ◽

2019 ◽

Author(s):

Theodosios Famprikis ◽

James Dawson ◽

François Fauth ◽

Emmanuelle Suard ◽

Benoit Fleutot ◽

...

Keyword(s):

Solid Electrolytes ◽

Density Functional ◽

Density Functional Theory Calculations ◽

Orthorhombic Crystal ◽

Orthorhombic Crystal Structure ◽

Ion Conductor ◽

Solid State Batteries ◽

Density Analysis ◽

Two Phases ◽

Dynamics Simulations

<div> Solid electrolytes are crucial for next‑generation solid‑state batteries and Na3PS4 is one of the most promising Na+ conductors for such applications. At present, two phases of Na3PS4 have been identified and it had been thought to melt above 500 °C. In contrast, we show that it remains solid above this temperature and transforms into a third polymorph, γ, exhibiting superionic behavior. We propose an orthorhombic crystal structure for γ‑Na3PS4 based on scattering density analysis of diffraction data and density functional theory calculations. We show that the Na+ superionic behavior is associated with rotational motion of the thiophosphate polyanions pointing to a rotor phase, based on ab initio molecular dynamics simulations and supported by high‑temperature synchrotron and neutron diffraction, thermal analysis and impedance spectroscopy. These findings are of importance for the development of new polyanion‑based solid electrolytes. </div>

Download Full-text

Operando Visualization of Morphological Dynamics in All-Solid-State Batteries

10.26434/chemrxiv.8299406 ◽

2019 ◽

Author(s):

Xiaohan Wu ◽

Juliette Billaud ◽

Iwan Jerjen ◽

Federica Marone ◽

Yuya Ishihara ◽

...

Keyword(s):

Solid State ◽

Solid Electrolytes ◽

Rational Design ◽

Morphological Evolution ◽

Active Material ◽

Composite Layer ◽

Transference Number ◽

Thermal Stabilities ◽

Solid State Batteries ◽

All Solid State Batteries

<div> <div> <div> All-solid-state batteries are considered as attractive options for next-generation energy storage owing to the favourable properties (unit transference number and thermal stabilities) of solid electrolytes. However, there are also serious concerns about mechanical deformation of solid electrolytes leading to the degradation of the battery performance. Therefore, understanding the mechanism underlying the electro-mechanical properties in SSBs are essentially important. Here, we show three-dimensional and time-resolved measurements of an all-solid-state cell using synchrotron radiation x-ray tomographic microscopy. We could clearly observe the gradient of the electrochemical reaction and the morphological evolution in the composite layer. Volume expansion/compression of the active material (Sn) was strongly oriented along the thickness of the electrode. While this results in significant deformation (cracking) in the solid electrolyte region, we also find organized cracking patterns depending on the particle size and their arrangements. This study based on operando visualization therefore opens the door towards rational design of particles and electrode morphology for all-solid-state batteries. </div> </div> </div>

Download Full-text

Experimental Assessment of the Practical Oxidative Stability of Lithium Thiophosphate Solid Electrolytes

10.26434/chemrxiv.8014715.v1 ◽

2019 ◽

Author(s):

Georg Dewald ◽

Saneyuki Ohno ◽

Marvin Kraft ◽

Raimund Koerver ◽

Paul Till ◽

...

Keyword(s):

Cyclic Voltammetry ◽

Solid State ◽

Oxidative Stability ◽

Photoelectron Spectroscopy ◽

Solid Electrolytes ◽

Stability Limit ◽

Lithium Ion ◽

High Energy ◽

Redox Activity ◽

Solid State Batteries

All-solid-state batteries are often expected to replace conventional lithium-ion batteries in the future. However, the practical electrochemical and cycling stability of the best-conducting solid electrolytes, i.e. lithium thiophosphates, are still critical issues that prevent long-term stable high-energy cells. In this study, we use stepwisecyclic voltammetry to obtain information on the practical oxidative stability limit of Li10GeP2S12, a Li2S‑P2S5glass, as well as the argyrodite Li6PS5Cl solid electrolytes. We employ indium metal and carbon black as the counter and working electrode, respectively, the latter to increase the interfacial contact area to the electrolyte as compared to the commonly used planar steel electrodes. Using a stepwise increase in the reversal potentials, the onset potential at 25 °C of oxidative decomposition at the electrode-electrolyte interface is identified. X‑ray photoelectron spectroscopy is used to investigate the oxidation of sulfur(-II) in the thiophosphate polyanions to sulfur(0) as the dominant redox process in all electrolytes tested. Our results suggest that after the formation of these decomposition products, significant redox behavior is observed. This explains previously reported redox activity of thiophosphate solid electrolytes, which contributes to the overall cell performance in solid-state batteries. The stepwise cyclic voltammetryapproach presented here shows that the practical oxidative stability at 25 °C of thiophosphate solid electrolytes against carbon is kinetically higher than predicted by thermodynamic calculations. The method serves as an efficient guideline for the determination of practical, kinetic stability limits of solid electrolytes.

Download Full-text

Experimental Assessment of the Practical Oxidative Stability of Lithium Thiophosphate Solid Electrolytes

10.26434/chemrxiv.8014715 ◽

2019 ◽

Author(s):

Georg Dewald ◽

Saneyuki Ohno ◽

Marvin Kraft ◽

Raimund Koerver ◽

Paul Till ◽

...

Keyword(s):

Cyclic Voltammetry ◽

Solid State ◽

Oxidative Stability ◽

Photoelectron Spectroscopy ◽

Solid Electrolytes ◽

Stability Limit ◽

Lithium Ion ◽

High Energy ◽

Redox Activity ◽

Solid State Batteries

All-solid-state batteries are often expected to replace conventional lithium-ion batteries in the future. However, the practical electrochemical and cycling stability of the best-conducting solid electrolytes, i.e. lithium thiophosphates, are still critical issues that prevent long-term stable high-energy cells. In this study, we use stepwisecyclic voltammetry to obtain information on the practical oxidative stability limit of Li10GeP2S12, a Li2S‑P2S5glass, as well as the argyrodite Li6PS5Cl solid electrolytes. We employ indium metal and carbon black as the counter and working electrode, respectively, the latter to increase the interfacial contact area to the electrolyte as compared to the commonly used planar steel electrodes. Using a stepwise increase in the reversal potentials, the onset potential at 25 °C of oxidative decomposition at the electrode-electrolyte interface is identified. X‑ray photoelectron spectroscopy is used to investigate the oxidation of sulfur(-II) in the thiophosphate polyanions to sulfur(0) as the dominant redox process in all electrolytes tested. Our results suggest that after the formation of these decomposition products, significant redox behavior is observed. This explains previously reported redox activity of thiophosphate solid electrolytes, which contributes to the overall cell performance in solid-state batteries. The stepwise cyclic voltammetryapproach presented here shows that the practical oxidative stability at 25 °C of thiophosphate solid electrolytes against carbon is kinetically higher than predicted by thermodynamic calculations. The method serves as an efficient guideline for the determination of practical, kinetic stability limits of solid electrolytes.

Download Full-text