scholarly journals Changes in the interfacial charge-transfer resistance of Mg metal electrodes, measured by dynamic electrochemical impedance spectroscopy

2021 ◽  
Vol 124 ◽  
pp. 106952
Author(s):  
Ran Attias ◽  
Ben Dlugatch ◽  
Munseok S. Chae ◽  
Yosef Goffer ◽  
Doron Aurbach
Keyword(s):  
Charge Transfer ◽  
Electrochemical Impedance Spectroscopy ◽  
Impedance Spectroscopy ◽  
Electrochemical Impedance ◽  
Charge Transfer Resistance ◽  
Metal Electrodes ◽  
Transfer Resistance ◽  
Interfacial Charge Transfer ◽  
Dynamic Electrochemical Impedance Spectroscopy ◽  
Interfacial Charge

scholarly journals Electrochemical Impedance Spectroscopy on the Performance Degradation of LiFePO4/Graphite Lithium-Ion Battery Due to Charge-Discharge Cycling under Different C-Rates

Energies ◽  
2019 ◽  
Vol 12 (23) ◽  
pp. 4507 ◽  
Author(s):  
Yusuke Abe ◽  
Natsuki Hori ◽  
Seiji Kumagai
Keyword(s):  
Charge Transfer ◽  
Electrochemical Impedance Spectroscopy ◽  
Impedance Spectroscopy ◽  
Electrochemical Impedance ◽  
Specific Capacity ◽  
Lithium Ion ◽  
Performance Degradation ◽  
Charge Transfer Resistance ◽  
Transfer Resistance ◽  
Charge Discharge

Lithium-ion batteries (LIBs) using a LiFePO4 cathode and graphite anode were assembled in coin cell form and subjected to 1000 charge-discharge cycles at 1, 2, and 5 C at 25 °C. The performance degradation of the LIB cells under different C-rates was analyzed by electrochemical impedance spectroscopy (EIS) and scanning electron microscopy. The most severe degradation occurred at 2 C while degradation was mitigated at the highest C-rate of 5 C. EIS data of the equivalent circuit model provided information on the changes in the internal resistance. The charge-transfer resistance within all the cells increased after the cycle test, with the cell cycled at 2 C presenting the greatest increment in the charge-transfer resistance. Agglomerates were observed on the graphite anodes of the cells cycled at 2 and 5 C; these were more abundantly produced in the former cell. The lower degradation of the cell cycled at 5 C was attributed to the lowered capacity utilization of the anode. The larger cell voltage drop caused by the increased C-rate reduced the electrode potential variation allocated to the net electrochemical reactions, contributing to the charge-discharge specific capacity of the cells.

Thermal transitions in hydrated layer-by-layer assemblies observed using electrochemical impedance spectroscopy

Soft Matter ◽  
2014 ◽  
Vol 10 (34) ◽  
pp. 6467-6476 ◽  
Author(s):  
Choonghyun Sung ◽  
Katelin Hearn ◽  
Jodie Lutkenhaus
Keyword(s):  
Charge Transfer ◽  
Electrochemical Impedance Spectroscopy ◽  
Impedance Spectroscopy ◽  
Electrochemical Impedance ◽  
Charge Transfer Resistance ◽  
Thermal Transition ◽  
Layer By Layer ◽  
Thermal Transitions ◽  
Transfer Resistance ◽  
Hydrated Layer

Layer-by-layer assemblies exhibit increased conductivity and decreased charge transfer resistance upon heating through the thermal transition.

scholarly journals An Investigation on Dislocation Density in Cold-Rolled Copper Using Electrochemical Impedance Spectroscopy

2013 ◽  
Vol 2013 ◽  
pp. 1-6 ◽  
Author(s):  
Elyas Rafiee ◽  
Mansour Farzam ◽  
Mohammad Ali Golozar ◽  
Ali Ashrafi
Keyword(s):  
Charge Transfer ◽  
Electrochemical Impedance Spectroscopy ◽  
Impedance Spectroscopy ◽  
Dislocation Density ◽  
Electrochemical Impedance ◽  
Pure Copper ◽  
Annealed Sample ◽  
Charge Transfer Resistance ◽  
Transfer Resistance ◽  
Cold Rolled

Variation of electrochemical impedance with dislocation density was investigated using electrochemical impedance spectroscopy (EIS). For this purpose, EIS measurements were carried out on 10, 20, 30, 40, and 50% cold-rolled commercially pure copper in 0.1 M NaCl (pH = 2) solution. Nyquist plots illustrated that the electrochemical reactions are controlled by both charge transfer and diffusion process. Increasing dislocation density, the magnitude of electrochemical impedance of samples was decreased. Decreasing magnitude of impedance at intermediate frequencies indicated increasing double-layer capacitance. Charge transfer resistance decreased from value 329.6 Ωcm2 for annealed sample to 186.3 Ωcm2 for sample with maximum dislocation density (1.72×1015 m−2). Phase angles were lower for samples that contained more dislocation density, indicating more tendencies to loss of electrons and releasing atoms into electrolyte.

scholarly journals Deciphering the Disaggregation Mechanism of Amyloid Beta Aggregate by 4-(2-Hydroxyethyl)-1-Piperazinepropanesulfonic Acid Using Electrochemical Impedance Spectroscopy

Sensors ◽  
2021 ◽  
Vol 21 (3) ◽  
pp. 788
Author(s):  
Hien T. Ngoc Le ◽  
Sungbo Cho
Keyword(s):  
Electrochemical Impedance Spectroscopy ◽  
Impedance Spectroscopy ◽  
Electrochemical Impedance ◽  
Specific Binding ◽  
Amyloid Β ◽  
Electrochemical Measurement ◽  
Charge Transfer Resistance ◽  
Chemical Agent ◽  
Transfer Resistance ◽  
K Value

Aggregation of amyloid-β (aβ) peptides into toxic oligomers, fibrils, and plaques is central in the molecular pathogenesis of Alzheimer’s disease (AD) and is the primary focus of AD diagnostics. Disaggregation or elimination of toxic aβ aggregates in patients is important for delaying the progression of neurodegenerative disorders in AD. Recently, 4-(2-hydroxyethyl)-1-piperazinepropanesulfonic acid (EPPS) was introduced as a chemical agent that binds with toxic aβ aggregates and transforms them into monomers to reduce the negative effects of aβ aggregates in the brain. However, the mechanism of aβ disaggregation by EPPS has not yet been completely clarified. In this study, an electrochemical impedimetric immunosensor for aβ diagnostics was developed by immobilizing a specific anti-amyloid-β (aβ) antibody onto a self-assembled monolayer functionalized with a new interdigitated chain-shaped electrode (anti-aβ/SAM/ICE). To investigate the ability of EPPS in recognizing AD by extricating aβ aggregation, commercially available aβ aggregates (aβagg) were used. Electrochemical impedance spectroscopy was used to probe the changes in charge transfer resistance (Rct) of the immunosensor after the specific binding of biosensor with aβagg. The subsequent incubation of the aβagg complex with a specific concentration of EPPS at different time intervals divulged AD progression. The decline in the Rct of the immunosensor started at 10 min of EPPS incubation and continued to decrease gradually from 20 min, indicating that the accumulation of aβagg on the surface of the anti-aβ/SAM/ICE sensor has been extricated. Here, the kinetic disaggregation rate k value of aβagg was found to be 0.038. This innovative study using electrochemical measurement to investigate the mechanism of aβagg disaggregation by EPPS could provide a new perspective in monitoring the disaggregation periods of aβagg from oligomeric to monomeric form, and then support for the prediction and handling AD symptoms at different stages after treatment by a drug, EPPS.

scholarly journals Investigation of Temperature and Aging Effects in Nanostructured Dye Solar Cells Studied by Electrochemical Impedance Spectroscopy

2009 ◽  
Vol 2009 ◽  
pp. 1-15 ◽  
Author(s):  
Minna Toivola ◽  
Janne Halme ◽  
Lauri Peltokorpi ◽  
Peter Lund
Keyword(s):  
Solar Cells ◽  
Electrochemical Impedance Spectroscopy ◽  
Impedance Spectroscopy ◽  
Electrochemical Impedance ◽  
Charge Transfer Resistance ◽  
Aging Effects ◽  
Transfer Resistance ◽  
Deterioration Rate ◽  
Dye Solar Cells ◽  
Effects Of Aging

Effects of aging and cyclically varying temperature on the electrical parameters of dye solar cells were analyzed with electrochemical impedance spectroscopy. Photoelectrode total resistance increased as a function of time due to increasing electron transport resistance in theTiO2film. On the other hand, photoelectrode recombination resistance was generally larger, electron lifetimes in theTiO2were film longer, and charge transfer resistance on the counter electrode was smaller after the temperature treatments than before them. These effects correlated with the slower deterioration rate of the temperature-treated cells, in comparison to the reference cells.

scholarly journals Yeast Propagation Control: Low Frequency Electrochemical Impedance Spectroscopy as an Alternative for Cell Counting Chambers in Brewery Applications

Chemosensors ◽  
2020 ◽  
Vol 8 (2) ◽  
pp. 27
Author(s):  
Georg Christoph Brunauer ◽  
Oliver Spadiut ◽  
Alfred Gruber ◽  
Christoph Slouka
Keyword(s):  
Electrochemical Impedance Spectroscopy ◽  
Impedance Spectroscopy ◽  
Pathogen Detection ◽  
Electrochemical Impedance ◽  
Low Frequency ◽  
Charge Transfer Resistance ◽  
Cell Counting ◽  
Delayed Response ◽  
Transfer Resistance ◽  
Cell Counts

Electrochemical impedance spectroscopy is a powerful tool in life science for cell and pathogen detection, as well as for cell counting. The measurement principles and techniques using impedance spectroscopy are highly diverse. Differences can be found in used frequency range (β or α regime), analyzed quantities, like charge transfer resistance, dielectric permittivity of double layer capacitance and in off- or online usage. In recent contributions, applications of low-frequency impedance spectroscopy in the α regime were tested for determination of cell counts and metabolic burden in Escherichia coli and Saccharomyces cerevisiae. The established easy to use methods showed reasonable potential in the lab scale, especially for S. cerevisiae. However, until now, measurements for cell counts in food science are generally based on Thoma cell counting chambers. These microscopic cell counting methods decelerate an easy and quick prediction of yeast viability, as they are labor intensive and result in a time delayed response signal. In this contribution we tested our developed method using low frequency impedance spectroscopy locally at an industrial brewery propagation site and compared results to classic cell counting procedures.

Sign in / Sign up

Export Citation Format

Share Document