scholarly journals Length-scales of chemical and isotopic heterogeneity in the mantle section of the Shetland Ophiolite Complex, Scotland

2018 ◽  
Vol 488 ◽  
pp. 144-154 ◽  
Author(s):  
B. O'Driscoll ◽  
R.J. Walker ◽  
P.L. Clay ◽  
J.M.D. Day ◽  
R.D. Ash ◽  
...  
Lithos ◽  
2019 ◽  
Vol 344-345 ◽  
pp. 51-67 ◽  
Author(s):  
E.J. Derbyshire ◽  
B. O'Driscoll ◽  
D. Lenaz ◽  
A. Zanetti ◽  
R. Gertisser

2014 ◽  
Vol 64 (4) ◽  
pp. 473-494 ◽  
Author(s):  
Argyrios N. Kapsiotis

Abstract The peridotites from the area of Korydallos, in the Pindos ophiolitic massif, crop out as deformed slices of a rather dismembered sub-oceanic, lithospheric mantle section and are tectonically enclosed within the Avdella melange. The most sizeable block is a chromitite-bearing serpentinite showing a mesh texture. Accessory, subhedral to euhedral Cr-spinels in the serpentinite display Cr# [Cr/(Cr + Al)] values that range from 0.36 to 0.42 and Mg# [Mg/(Mg+ Fe2+ )] values that vary between 0.57 and 0.62, whereas the TiO2 content may be up to 0.47 wt.%. The serpentinite fragment is characterized by low abundances of magmaphile elements (Al2 O3 : 0.66 wt.%, CaO: 0.12 wt.%, Na2 O: 0.08 wt.%, TiO2 : 0.007 wt.%, Sc: 4 ppm) and enrichment in compatible elements (Cr: 2780 ppm and Ni: 2110 ppm). Overall data are in accordance with derivation of the serpentinite exotic block from a dunite that was formed in the mantle region underneath a back-arc basin before tectonic incorporation in the Korydallos melange. Two compositionally different chromitite pods are recognized in the studied serpentinite fragment, a Cr-rich chromitite and a high-Al chromitite, which have been ascribed to crystallization from a single, progressively differentiating MORB/IAT melt. Although both pods are fully serpentinized only the Al-rich one shows signs of limited Cr-spinel replacement by an opaque spinel phase and clinochlore across grain boundaries and fractures. Modification of the ore-making Cr-spinel is uneven among the Al-rich chromitite specimens. Textural features such as olivine replacement by clinochlore and clinochlore disruption by serpentine indicate that Cr-spinel alteration is not apparently related to serpentinization. From the unaltered Cr-spinel cores to their reworked boundaries the Al2 O3 and MgO abundances decrease, being mainly compensated by FeOt and Cr2 O3 increases. Such compositional variations are suggestive of restricted ferrian chromite (and minor magnetite) substitution for Cr-spinel during a short-lived but relatively intense, low amphibolite facies metamorphic episode (temperature: 400-700 °C). The presence of tremolite and clinochlore in the interstitial groundmass of the high-Al chromitite and their absence from the Cr-rich chromitite matrix imply that after chromitite formation a small volume of a high temperature, post-magmatic fluid reacted with Cr-spinel, triggering its alteration.


2012 ◽  
Vol 40 (2) ◽  
pp. 124-150
Author(s):  
Klaus Wiese ◽  
Thiemo M. Kessel ◽  
Reinhard Mundl ◽  
Burkhard Wies

ABSTRACT The presented investigation is motivated by the need for performance improvement in winter tires, based on the idea of innovative “functional” surfaces. Current tread design features focus on macroscopic length scales. The potential of microscopic surface effects for friction on wintery roads has not been considered extensively yet. We limit our considerations to length scales for which rubber is rough, in contrast to a perfectly smooth ice surface. Therefore we assume that the only source of frictional forces is the viscosity of a sheared intermediate thin liquid layer of melted ice. Rubber hysteresis and adhesion effects are considered to be negligible. The height of the liquid layer is driven by an equilibrium between the heat built up by viscous friction, energy consumption for phase transition between ice and water, and heat flow into the cold underlying ice. In addition, the microscopic “squeeze-out” phenomena of melted water resulting from rubber asperities are also taken into consideration. The size and microscopic real contact area of these asperities are derived from roughness parameters of the free rubber surface using Greenwood-Williamson contact theory and compared with the measured real contact area. The derived one-dimensional differential equation for the height of an averaged liquid layer is solved for stationary sliding by a piecewise analytical approximation. The frictional shear forces are deduced and integrated over the whole macroscopic contact area to result in a global coefficient of friction. The boundary condition at the leading edge of the contact area is prescribed by the height of a “quasi-liquid layer,” which already exists on the “free” ice surface. It turns out that this approach meets the measured coefficient of friction in the laboratory. More precisely, the calculated dependencies of the friction coefficient on ice temperature, sliding speed, and contact pressure are confirmed by measurements of a simple rubber block sample on artificial ice in the laboratory.


Impact ◽  
2018 ◽  
Vol 2018 (1) ◽  
pp. 48-50
Author(s):  
Toralf Scharf ◽  
Paul Urbach ◽  
Carsten Rockstuhl ◽  
Frank Setzpfand

2020 ◽  
Vol 22 (36) ◽  
pp. 20914-20921 ◽  
Author(s):  
Rajmohan Muthaiah ◽  
Jivtesh Garg

We report novel pathways to significantly enhance the thermal conductivity at nanometer length scales in boron phosphide through biaxial strain.


Author(s):  
Mathaeus Tschaikowsky ◽  
Tanja Neumann ◽  
Sofia Brander ◽  
Heiko Haschke ◽  
Bernd Rolauffs ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document