Effects of pipe size on horizontal two-phase flow: Flow regimes, pressure drop, two-phase flow parameters, and drift-flux analysis

2018 ◽  
Vol 96 ◽  
pp. 75-89 ◽  
Author(s):  
Ran Kong ◽  
Seungjin Kim ◽  
Stephen Bajorek ◽  
Kirk Tien ◽  
Chris Hoxie
2004 ◽  
Vol 126 (4) ◽  
pp. 528-538 ◽  
Author(s):  
S. Kim ◽  
S. S. Paranjape ◽  
M. Ishii ◽  
J. Kelly

The vertical co-current downward air-water two-phase flow was studied under adiabatic condition in round tube test sections of 25.4-mm and 50.8-mm ID. In flow regime identification, a new approach was employed to minimize the subjective judgment. It was found that the flow regimes in the co-current downward flow strongly depend on the channel size. In addition, various local two-phase flow parameters were acquired by the multi-sensor miniaturized conductivity probe in bubbly flow. Furthermore, the area-averaged data acquired by the impedance void meter were analyzed using the drift flux model. Three different distributions parameters were developed for different ranges of non-dimensional superficial velocity, defined by the ration of total superficial velocity to the drift velocity.


Author(s):  
Christian Weinmu¨ller ◽  
Dimos Poulikakos

Microfluidics has experienced a significant increase in research activities in recent years with a wide range of applications emerging, such as micro heat exchangers, energy conversion devices, microreactors, lab-on-chip devices and micro total chemical analysis systems (μTAS). Efforts to enhance or extend the performance of single phase microfluidic devices are met by two-phase flow systems [1, 2]. Essential for the design and control of microfluidic systems is the understanding of the fluid/hydrodynamic behavior, especially pressure drop correlations. These are well established for single phase flow, however, analytical correlations for two-phase flow only reflect experimentally obtained values within an accuracy of ± 50% [3, 4]. The present study illustrates the effect of two-phase flow regimes on the pressure drop. Experimental measurement data is put into relation of calculated values based on established correlations of Lockhart-Martinelli with Chisholm modifications for macroscopic flows [5, 6] and Mishima-Hibiki modifications for microscale flows [7]. Further, the experimental pressure drop data is superimposed onto two-phase flow maps to identify apparent correlations of pressure drop abnormalities and flow regimes. The experiments were conducted in a square microchannel with a width of 200 μm. Optical access is guaranteed by an anodically bonded glass plate on a MEMS fabricated silicon chip. Superficial velocities range from 0.01 m/s to 1 m/s for the gas flow and from 0.0001 m/s to 1 m/s for the liquid flow with water as liquid feed and CO2 as gas. The analysis of the flow regimes was performed by imaging the distinct flow regimes by laser induced fluorescence microscopy, employing Rhodamine B as the photosensitive dye. The pressure drop was synchronically recorded with a 200 mbar, 2.5 bar and 25 bar differential pressure transmitter and the data was exported via a LabView based software environment, see Figure 1. Figure 2 illustrates the experimentally obtained pressure drop in comparison to the calculated values based on the Lockhard-Martinelli correlation with the Chisholm modification and the Mishima-Hibiki modification. For both cases the predications underestimate the two-phase pressure drop by more than 50%. Nevertheless, the regression of the experimental data has an offset of linear nature. Two-phase flow is assigned to flow regime maps of bubbly, wedging, slug or annular flow defined by superficial gas and liquid velocities. In Figure 3 the pressure drop is plotted as a surface over the corresponding flow regime map. Transition lines indicate a change of flow regimes enclosing an area of an anticline in the pressure data. In the direct comparison between the calculated and the measured values, the two surfaces show a distinct deviation. Especially, the anticline of the experimental data is not explained by the analytical correlations. Figure 4 depicts the findings of Figure 3 at a constant superficial velocity of 0.0232 m/s. The dominant influence of the flow regimes on the pressure drop becomes apparent, especially in the wedging flow regime. The evident deviation of two-phase flow correlations for the pressure drop is based on omitting the influence of the flow regimes. In conclusion, the study reveals a strong divergence of pressure drop measurements in microscale two-phase flow from established correlations of Lockhart-Martinelli and recognized modifications. In reference to [8, 9], an analytical model incorporating the flow regimes and, hence, predicting the precise pressure drop would be of great benefit for hydrodynamic considerations in microfluidics.


Author(s):  
Pei-Syuan Ruan ◽  
Shao-Wen Chen ◽  
Min-Song Lin ◽  
Jin-Der Lee ◽  
Jong-Rong Wang

Abstract This paper presents the experimental results and analyses of the structure velocity of air-water two-phase flow in a 3 × 3 rod bundle channel. A total of 56 flow conditions were tested and investigated for rod-gap, sub-channel, rod-wall and global regions of rod bundle geometry. The experimental tests were carried out under bubbly and cap-bubbly flow regimes with superficial gas and liquid velocities of 0–1 m/s and 1–1.7 m/s, respectively. The conductivity probes were set at different heights to measure the global and local void fractions. The structure velocity of air-water two-phase flow is the average bubble velocity calculated by the method in this study. The structure velocity were determined by utilizing the cross-correlation technique to analyze the time lags of the bubbles passing through the conductivity probes. The results of this study indicated that the structure velocity may increase with increasing superficial gas and liquid velocities. In low superficial gas velocity region, the structure velocity may first slightly increase and follow by a sudden jump which appear in most regions. After the sudden jump, the structure velocity may keep increasing mildly. The present structure velocities have been compared with the area-averaged gas velocities predicted by the drift flux model, and it appears that most structure velocities show a good agreement with the averaged gas velocities from the drift flux model after the jump.


2000 ◽  
Author(s):  
Bofeng Bai ◽  
Tiejun Wu ◽  
Liejin Guo ◽  
Xuejun Chen

Abstract The fluctuating pressure drop for air-water two-phase flow was measured in the vertical upward section of U-type tube with 0.05m I.D. The feature of the fluctuations was extracted by means of statistical and chaotic theories. The influence of liquid superficial velocity on the features was also investigated. The results showed that the mean, root mean square, fractal dimension of pressure drop fluctuations is function of flow regimes. The fractal dimension can be larger than 1.5 in annular flow with great liquid superficial velocity which is reported for the first time. Furthermore, the present paper provided a feasible solution, which the gas-liquid two-phase flow regimes can be recognized automatically and objectively on basis of the combination of the Counter Propagation Network (CPN) and the FFT coefficients of the differential pressure fluctuations. The recognition possibility is determined by the clustering results of the Kohonen layer in the CPN. With the presented test cases, the possibility can be greater than 90 percent for different liquid phase velocity.


2012 ◽  
Vol 33 (2) ◽  
pp. 47-65
Author(s):  
Amr Mohamed Elazhary ◽  
Hassan M. Soliman

Abstract An experimental study was conducted in order to investigate two-phase flow regimes and fully developed pressure drop in a mini-size, horizontal rectangular channel. The test section was machined in the form of an impacting tee junction in an acrylic block (in order to facilitate visualization) with a rectangular cross-section of 1.87-mm height on 20-mm width on the inlet and outlet sides. Pressure drop measurement and flow regime identification were performed on all three sides of the junction. Air-water mixtures at 200 kPa (abs) and room temperature were used as the test fluids. Four flow regimes were identified visually: bubbly, plug, churn, and annular over the ranges of gas and liquid superficial velocities of 0.04 ≤ JG ≤ 10 m/s and 0.02 ≤ JL ≤ 0.7 m/s, respectively, and a flow regime map was developed. Accuracy of the pressure-measurement technique was validated with single-phase, laminar and turbulent, fully developed data. Two-phase experiments were conducted for eight different inlet conditions and various mass splits at the junction. Comparisons were conducted between the present data and former correlations for the fully developed two-phase pressure drop in rectangular channels with similar sizes. Wide deviations were found among these correlations, and the correlations that agreed best with the present data were identified.


Author(s):  
Takashi Hibiki ◽  
Tomoji Takamasa ◽  
Mamoru Ishii

In view of the practical importance of the drift-flux model for two-phase flow analyses at microgravity conditions, the constitutive equations for distribution parameter and drift velocity have been developed for various two-phase flow regimes at microgravity conditions. A comparison of the model with various experimental data over various flow regimes and a wide range of flow parameters taken at microgravity conditions shows a satisfactory agreement. The newly developed drift-flux model has been applied to reduced gravity conditions such as 1.62 and 3.71 cm/s2, which correspond to the Lunar and Martian surface gravities, respectively, and the effect of the gravity on the void fraction in two-phase flow systems has been discussed.


Sign in / Sign up

Export Citation Format

Share Document