scholarly journals Dynamical instability of laminated plates with external cutout

2016 ◽  
Vol 81 ◽  
pp. 103-114 ◽  
Author(s):  
Jan Awrejcewicz ◽  
Lidiya Kurpa ◽  
Olga Mazur
Keyword(s):  
Laminated Plates ◽  
Dynamical Instability

Evaluation of layerwise mixed theories for laminated plates analysis

AIAA Journal ◽  
1998 ◽  
Vol 36 ◽  
pp. 830-839 ◽  
Author(s):  
Erasmo Carrera
Keyword(s):  
Laminated Plates

Physical Ultrasonics of Composites

2011 ◽  
Author(s):  
Dale Chimenti ◽  
Stanislav Rokhlin ◽  
Peter Nagy
Keyword(s):  
Composite Laminates ◽  
Stiffness Matrix ◽  
Composite Plates ◽  
Anisotropic Media ◽  
Anisotropic Materials ◽  
Ultrasonic Waves ◽  
Laminated Plates ◽  
Structure Characteristic ◽  
Major Advance

Physical Ultrasonics of Composites is a rigorous introduction to the characterization of composite materials by means of ultrasonic waves. Composites are treated here not simply as uniform media, but as inhomogeneous layered anisotropic media with internal structure characteristic of composite laminates. The objective here is to concentrate on exposing the singular behavior of ultrasonic waves as they interact with layered, anisotropic materials, materials which incorporate those structural elements typical of composite laminates. This book provides a synergistic description of both modeling and experimental methods in addressing wave propagation phenomena and composite property measurements. After a brief review of basic composite mechanics, a thorough treatment of ultrasonics in anisotropic media is presented, along with composite characterization methods. The interaction of ultrasonic waves at interfaces of anisotropic materials is discussed, as are guided waves in composite plates and rods. Waves in layered media are developed from the standpoint of the "Stiffness Matrix", a major advance over the conventional, potentially unstable Transfer Matrix approach. Laminated plates are treated both with the stiffness matrix and using Floquet analysis. The important influence on the received electronic signals in ultrasonic materials characterization from transducer geometry and placement are carefully exposed in a dedicated chapter. Ultrasonic wave interactions are especially susceptible to such influences because ultrasonic transducers are seldom more than a dozen or so wavelengths in diameter. The book ends with a chapter devoted to the emerging field of air-coupled ultrasonics. This new technology has come of age with the development of purpose-built transducers and electronics and is finding ever wider applications, particularly in the characterization of composite laminates.

Buckling of shear-deformable orthotropic laminated plates with elastic restraints

2020 ◽  
Vol 157 ◽  
pp. 107071
Author(s):  
Philip Schreiber ◽  
Christian Mittelstedt ◽  
Matthias Beerhorst
Keyword(s):  
Laminated Plates ◽  
Elastic Restraints ◽  
Shear Deformable

scholarly journals Interfacial Morphology and Bonding Mechanism of Explosive Weld Joints

2021 ◽  
Vol 34 (1) ◽  
Author(s):  
Tingting Zhang ◽  
Wenxian Wang ◽  
Zhifeng Yan ◽  
Jie Zhang
Keyword(s):  
Laminated Composite ◽  
Base Plate ◽  
Sine Wave ◽  
Laminated Plates ◽  
Bonding Interface ◽  
Interfacial Structure ◽  
Bonding Mechanism ◽  
Critical Material ◽  
Interfacial Morphology ◽  
Az31b Alloy

AbstractInterfacial structure greatly affects the mechanical properties of laminated plates. However, the critical material properties that impact the interfacial morphology, appearance, and associated bonding mechanism of explosive welded plates are still unknown. In this paper, the same base plate (AZ31B alloy) and different flyer metals (aluminum alloy, copper, and stainless steel) were used to investigate interfacial morphology and structure. SEM and TEM results showed that typical sine wave, wave-like, and half-wave-like interfaces were found at the bonding interfaces of Al/Mg, Cu/Mg and SS/Mg clad plates, respectively. The different interfacial morphologies were mainly due to the differences in hardness and yield strength between the flyer and base metals. The results of the microstructural distribution at the bonding interface indicated metallurgical bonding, instead of the commonly believed solid-state bonding, in the explosive welded clad plate. In addition, the shear strength of the bonding interface of the explosive welded Al/Mg, Cu/Mg and SS/Mg clad plates can reach up to 201.2 MPa, 147.8 MPa, and 128.4 MPa, respectively. The proposed research provides the design basis for laminated composite metal plates fabrication by explosive welding technology.

RETRACTED: Response of ship hull laminated plates to close proximity blast loads

2012 ◽  
Vol 52 (1) ◽  
pp. 197-203 ◽  
Author(s):  
Ionel Chirica ◽  
Doina Boazu ◽  
Elena-Felicia Beznea
Keyword(s):  
Laminated Plates ◽  
Ship Hull ◽  
Blast Loads ◽  
Close Proximity

Nonlinear Vibrations of Two-Span Composite Laminated Plates with Equal and Unequal Subspan Lengths

2017 ◽  
Vol 9 (6) ◽  
pp. 1485-1505
Author(s):  
Lingchang Meng ◽  
Fengming Li
Keyword(s):  
Multiple Scales ◽  
Equations Of Motion ◽  
Primary Resonance ◽  
Laminated Plates ◽  
Laminated Plate ◽  
Composite Laminated Plate ◽  
Vibration Localization ◽  
Composite Laminated Plates ◽  
Localization Phenomenon ◽  
Harmonic Resonance

AbstractThe nonlinear transverse vibrations of ordered and disordered two-dimensional (2D) two-span composite laminated plates are studied. Based on the von Karman's large deformation theory, the equations of motion of each-span composite laminated plate are formulated using Hamilton's principle, and the partial differential equations are discretized into nonlinear ordinary ones through the Galerkin's method. The primary resonance and 1/3 sub-harmonic resonance are investigated by using the method of multiple scales. The amplitude-frequency relations of the steady-state responses and their stability analyses in each kind of resonance are carried out. The effects of the disorder ratio and ply angle on the two different resonances are analyzed. From the numerical results, it can be concluded that disorder in the length of the two-span 2D composite laminated plate will cause the nonlinear vibration localization phenomenon, and with the increase of the disorder ratio, the vibration localization phenomenon will become more obvious. Moreover, the amplitude-frequency curves for both primary resonance and 1/3 sub-harmonic resonance obtained by the present analytical method are compared with those by the numerical integration, and satisfactory precision can be obtained for engineering applications and the results certify the correctness of the present approximately analytical solutions.

Sign in / Sign up

Export Citation Format

Share Document