Integrated model reference adaptive control to coordinate active front steering and direct yaw moment control

2020 ◽  
Vol 106 ◽  
pp. 85-96 ◽  
Author(s):  
Narjes Ahmadian ◽  
Alireza Khosravi ◽  
Pouria Sarhadi
2018 ◽  
Vol 41 (9) ◽  
pp. 2428-2440 ◽  
Author(s):  
Jiaxu Zhang ◽  
Jing Li

This paper presents an integrated vehicle chassis control (IVCC) strategy to improve vehicle handling and stability by coordinating active front steering (AFS) and direct yaw moment control (DYC) in a hierarchical way. In high-level control, the corrective yaw moment is calculated by the fast terminal sliding mode control (FTSMC) method, which may improve the transient response of the system, and a non-linear disturbance observer (NDO) is used to estimate and compensate for the model uncertainty and external disturbance to suppress the chattering of FTSMC. In low-level control, the null-space-based control reallocation method and inverse tyre model are utilized to transform the corrective yaw moment to the desired longitudinal slips and the steer angle increment of front wheels by considering the constraints of actuators and friction ellipse of each wheel. Finally, the performance of the proposed control strategy is verified through simulations of various manoeuvres based on vehicle dynamic software CarSim.


2001 ◽  
Author(s):  
M. A. Selby ◽  
W. J. Manning ◽  
M. D. Brown ◽  
D. A. Crolla

Abstract This paper studies the benefits of coordinating stability and steerability controllers to reduce vehicle deceleration during limit handling situations. The stability controller, DYC, uses the vehicle brakes to apply a restoring moment when the vehicle sideslip angle and sideslip velocity exceed fixed bounds. This use of the brakes interferes with the longitudinal dynamics of the vehicle in a way that drivers find undesirable. Active front steering (AFS) and active rear steering(ARS) can be used to tune the vehicle handling balance in the low to mid-range lateral-acceleration regime. Earlier work has shown that the use of AFS can reduce the interference observed using DYC alone. The levels of improvement achievable by coordinating AFS and ARS with DYC are quantified using open loop handling simulations tests by predicting the deceleration of the vehicle in an extreme manoeuvre. The results from these simulations are compared to assess the relative benefits of AFS and ARS when coordinated with DYC. The computer simulations are based on a four-degree of freedom vehicle model incorporating longitudinal, lateral, yaw, roll, and load transfer effects.


Author(s):  
Xinxin Yao ◽  
Xianguang Gu ◽  
Ping Jiang

A coordination control strategy based on stability judgment is presented for autonomous vehicles (AVs) aiming to enhance the handling and stability performance. Firstly, the stability judgment scheme is used to evaluate the real-time stability level of vehicles based on the Self-Organizing Feature Map (SOFM) neural network and K-Means algorithm. Secondly, a coordination controller of active front steering (AFS) and direct yaw moment control (DYC) is designed to track the desired vehicle motion. To enhance the handling and stability of AVs, the weights of AFS and DYC controllers are adaptively adjusted according to the vehicle stability level. Finally, the effectiveness of the proposed method is verified in co-simulation environment of CarSim and Simulink, and a rapid control prototyping test is implemented to evaluate the feasibility and robustness. The results indicate that the stability judgment scheme and coordination control strategy for AVs can not only satisfy the requirements of path tracking accuracy but also enhance the handling and stability performance.


Sign in / Sign up

Export Citation Format

Share Document