Weldability and mechanical properties of dissimilar aluminum–copper lap joints made by friction stir welding

2010 ◽  
Vol 490 (1-2) ◽  
pp. 652-655 ◽  
Author(s):  
T. Saeid ◽  
A. Abdollah-zadeh ◽  
B. Sazgari
Keyword(s):  
Mechanical Properties ◽  
Friction Stir Welding ◽  
Lap Joints ◽  
Friction Stir

A study on the effect of cooling on microstructure and mechanical properties of friction stir-welded AA5086 aluminum butt and lap joints

2017 ◽  
Vol 233 (6) ◽  
pp. 1156-1165 ◽  
Author(s):  
Adel Sedaghati ◽  
Hamed Bouzary
Keyword(s):  
Mechanical Properties ◽  
Friction Stir Welding ◽  
Feed Rate ◽  
Rotational Speed ◽  
Lap Joints ◽  
Tensile Behavior ◽  
Water Cooling ◽  
Friction Stir ◽  
Microstructural Behavior ◽  
Constant Feed Rate

In this paper, the effect of water cooling on mechanical properties and microstructure of AA5086 aluminum joints during friction stir welding is investigated. For doing so, the mechanical and microstructural behavior of samples welded both in air and in water was analyzed. Tests were performed involving both butt and lap welds and the results were compared. The effect of rotational speed at constant feed rate of 50 mm/min and changing rotational speed ranging from 250 to 1250 r/min was investigated. The results showed a significant change in the tensile behavior of the butt-welded specimens due to water cooling. In addition, welding was performed at constant spindle speed of 800 r/min and various traverse speeds (25 mm/min to 80 mm/min) to determine the effect of feed rate. The strength increases at first, but then decreases dramatically along with the feed rate which is due to the occurrence of a groove defect. Results showed some generally positive impacts of water cooling which are discussed in terms of tensile results, hardness distributions and microstructure analysis.

Investigation of Microstructure and Mechanical Properties of Friction Stir Lap Jointed Ni Base Superalloy

2012 ◽  
Vol 724 ◽  
pp. 481-485
Author(s):  
Kuk Hyun Song ◽  
Kazuhiro Nakata
Keyword(s):  
Mechanical Properties ◽  
Grain Size ◽  
Friction Stir Welding ◽  
Base Material ◽  
Lap Joints ◽  
Stir Zone ◽  
Inconel 600 ◽  
Friction Stir ◽  
Microstructure And Mechanical Properties ◽  
Average Grain Size

This study evaluated the microstructure and mechanical properties of friction stir welded lap joints. Inconel 600 and SS 400 as experimental materials were selected, and friction stir welding was carried out at tool rotation speed of 200 rpm and welding speed of 100 mm/min. Applying the friction stir welding was notably effective to reduce the grain size of the stir zone, as a result, the average grain size of Inconel 600 was reduced from 20 μm in the base material to 8.5 μm in the stir zone. Joint interface between Inconel 600 and SS 400 showed a sound weld without voids and cracks. Also, the hook, along the Inconel 600 alloy from SS 400, was formed at advancing side, which directly affected an increase in peel strength. In this study, we systematically discussed the evolution on microstructure and mechanical properties of friction stir lap jointed Inconel 600 and SS 400.

Sign in / Sign up

Export Citation Format

Share Document