The hot deformation behavior and hot rolling based on the hot processing map of a nano-Y2O3 addition near-α titanium alloy were investigated. The isothermal compression tests were conducted at various deformation temperatures (950–1070 °C) and strain rates (0.001–1 s−1), up to a true strain of 1.2. The flow stress was strongly dependent on deformation temperature and strain rate, decreasing with increased temperature and decreased strain rate. The average activation energy was 657.8 kJ/mol and 405.9 kJ/mol in (α + β) and β region, respectively. The high activation energy and peak stress were contributed to the Y2O3 particles and refractory elements comparing with other alloys and composites. The deformation mechanisms in the (α + β) region were dynamic recovery and spheroidization of α phase, while the β phase field was mainly controlled by the dynamic recrystallization and dynamic recovery of β grains. Moreover, the constitutive equation based on Norton–Hoff equation and hot processing map were also obtained. Through the optimal processing window determined by the hot processing map at true strains of 0.2, 0.4 and 0.6, the alloy sheet with multi-pass hot rolling (1050 °C/0.03–1 s−1) was received directly from the as-cast alloy. The ultimate tensile strength and yield strength of the alloy sheet were 1168 MPa and 1091 MPa at room temperature, and 642 MPa and 535 MPa at 650 °C, respectively, which performs some advantages in current research.
Compressive/tensile deformation behavior and the correlated microstructure evolution of Ti-6Al-4V titanium alloy at warm temperatures