Characteristics of Tofu Whey Degradation During Self-Sustaining Batch Anaerobic Process for Methane Production

Author(s):  
Arini Wresta ◽  
Neni Sintawardani ◽  
Sanggono Adisasmito ◽  
Tonni Agustiono Kurniawan ◽  
Tjandra Setiadi
2014 ◽  
Vol 20 (2) ◽  
pp. 297-315 ◽  
Author(s):  
K.J. Gurubel ◽  
E.N. Sanchez ◽  
S. Carlos-Hernandez ◽  
F. Ornelas-Tellez ◽  
M.A. Perez-Cisneros

2012 ◽  
Vol 13 (2) ◽  
pp. 118-125 ◽  
Author(s):  
Prawit Kongjan ◽  
Sompong O-Thong ◽  
Irini Angelidaki

2008 ◽  
Vol 47 (15) ◽  
pp. 5227-5233 ◽  
Author(s):  
Georgia Antonopoulou ◽  
Katerina Stamatelatou ◽  
Nikolaos Venetsaneas ◽  
Michael Kornaros ◽  
Gerasimos Lyberatos

2006 ◽  
Vol 54 (9) ◽  
pp. 209-219 ◽  
Author(s):  
I. Pereda ◽  
R. Irusta ◽  
S. Montalvo ◽  
J.L. del Valle

The use of solid mining residues (Cola) which contain a certain amount of Ni, Fe and Co, to stimulate anaerobic processes was evaluated. The effect over methane production and chemical oxygen demand (COD) removal efficiency was analysed. The studies were carried out in discontinuous reactors at lab scale under mesophilic conditions until exhausted. 0, 3, 5 and 7 mgCola l−1 doses were applied to synthetic wastewater. Volatile fatty acids (VFA) and sucrose were used as substrate, sulphur and nitrogen concentration, being the noise variable. Cola addition at dose around 5 mg l−1, turned out to be stimulating for the anaerobic process. It was the factor that most influenced on methane production rate together with VFA and high content of volatile suspended solids. In the case of methane yield, pH was the control factor of strongest influence. Higher values of COD removal efficiency were obtained when the reactors were operated with sucrose at relatively low pH and at the smallest concentration of nitrogen and sulphur. Solid residues dose and the type of substrate were the factors that had most influence on COD removal efficiency.


2018 ◽  
Vol 6 (2) ◽  
Author(s):  
Indriyati Indriyati

Seeding in Fixed Bed anaerobic reactor are infl uenced by several condition such as the growth rate total population of microbial, bacterial adaption to infl uent and the retention of biomass in reactor. The aim of this observation is to fi nd out the seeding and acclimation process in anaerobic process by using plastic as support material. Seeding and acclimatization process run smoothly can be seen from the increasing of infl uent or substrate and following by the increasing degradation of soluble COD, beside that the decreasing of VSS concentration indicates that microorganism are all ready fi x in support material, therefore reactor can be operated continuously and the acclimatization process can be stopped.Keywords : anaerobic seeding, acclimation anaerobic process


2015 ◽  
Vol 14 (4) ◽  
pp. 745-749
Author(s):  
Daisuke Tashima ◽  
Yoki Asano ◽  
Shigeki Tomomatsu ◽  
Yasuhiro Sugimoto

Sign in / Sign up

Export Citation Format

Share Document