Simultaneous PIV measurements of fluid and particle velocity fields of a sediment-laden buoyant jet

2015 ◽  
Vol 9 (2) ◽  
pp. 314-323 ◽  
Author(s):  
P. Liu ◽  
K.M. Lam
2006 ◽  
Vol 120 (5) ◽  
pp. 3356-3356
Author(s):  
Matthias Meyer ◽  
Jean‐Pierre Hermand ◽  
Kevin B. Smith

Author(s):  
John M. Furlan ◽  
Mohamed Garman ◽  
Jaikrishnan Kadambi ◽  
Robert J. Visintainer ◽  
Krishnan V. Pagalthivarthi

In the design of slurry transport equipment used in the mining and dredging industries, the effects of solid particle velocity and concentration on hydraulic performance and wear need to be considered. Two ultrasonic techniques have been used to investigate slurry flows through a centrifugal pump casing: a local particle concentration measurement technique (Furlan et al., 2012) and a pulsed ultrasonic Doppler Velocimetry (PUDV) technique (Hanjiang, 2003, Garman, 2015). Local particle velocities and concentrations have been obtained in a flow of soda lime glass particles (diameter of 195 μm) and water through the casing of a centrifugal slurry pump operating close to the best efficiency point using the two ultrasound techniques. For the concentration measurements, the acoustic properties of slurry flows such as sonic velocity, backscatter, and attenuation are correlated to the volume fraction of solid particles. The algorithm utilizes measurements obtained from homogeneous vertical pipe flow fields as calibration data in order to obtain experimental concentration profiles in the non-homogenous flow regimes which are encountered in the pump casing. The PUDV technique correlates the Doppler shift in frequency associated with the movement of particles towards or away from the transducer. A two measurement (angle) technique is applied within the pump casing in order to account for the components of particle velocity which are orthogonal to the casing side wall. The techniques are utilized to obtain concentration and velocity profiles within the pump casing for overall average loop particle concentrations ranging from 7–11 % by volume. The experimental results are compared with the concentration and velocity fields that are predicted by in-house finite element computational fluid dynamics (CFD) codes (Pagalthivarthi and Visintainer, 2009) which are used to predict wear in centrifugal slurry pump wet end components. Reasonable agreement is observed for both the concentration and velocity fields. Specifically, measurements indicate that there is a reduction of in-situ concentration and hence a corresponding radial acceleration of the particles with respect to the fluid occurring within the impeller which has also been predicted by computational predictions of flow through the impeller (Pagalthivarthi et al., 2013). Additionally, the prediction of the existence of secondary flow patterns by the casing computational code has been supported with the velocity measurements.


Author(s):  
Michael Bolduc ◽  
Samir Ziada ◽  
Philippe Lafon

Flow over ducted cavities can lead to strong resonances of the trapped acoustic modes due to the presence of the cavity within the duct. Aly & Ziada [1–3] investigated the excitation mechanism of acoustic trapped modes in axisymmetric cavities. These trapped modes in axisymmetric cavities tend to spin because they do not have preferred orientation. The present paper investigates rectangular cross-sectional cavities as this cavity geometry introduces an orientation preference to the excited acoustic mode. Three cavities are investigated, one of which is square while the other two are rectangular. In each case, numerical simulations are performed to characterize the acoustic mode shapes and the associated acoustic particle velocity fields. The test results show the existence of stationary modes, being excited either consecutively or simultaneously, and a particular spinning mode for the cavity with square cross-section. The computed acoustic pressure and particle velocity fields of the excited modes suggest complex oscillation patterns of the cavity shear layer because it is excited, at the upstream corner, by periodic distributions of the particle velocity along the shear layer circumference.


Author(s):  
Raffaele Colombi ◽  
Niclas Rohde ◽  
Michael Schlüter ◽  
Alexandra Von Kameke

Faraday waves form on the surface of a fluid which is subject to vertical forcing, and are researched in a large range of applications. Some examples are the formation of ordered wave patterns and the controlled walking or orbiting of droplets (Couder et al. (2005); Saylor and Kinard (2005)). Moreover, recent studies discovered the existence of a horizontal velocity field at  the fluid surface, called Faraday flow, which was shown to exhibit an inverse energy cascade and thus properties of two-dimensional turbulence (von Kameke et al., 2011, 2013; Francois et al., 2013). Additionally, three-dimensionality effects have been part of recent investigations in quasi-2D flows (both electromagnetically-driven (Kelley and Ouellette, 2011; Martell et al., 2019) or produced by parametrically-excited waves (Francois et al., 2014; Xia and Francois, 2017)). Furthermore, the occurrence of an inverse cascade in thick layers is also subject of current studies on the coexistence of 2D and 3D turbulence (Biferale et al., 2012; Kokot et al., 2017; Biferale et al., 2017). By performing 2D PIV measurements at horizontal planes beneath the Faraday waves, we recently showed that pronounced three dimensional flows occur in the bulk, with much larger spatial and temporal scales than those on the surface (Colombi et al., 2021), when the system is not shallow in comparison to typical length scales of the surface flow (fluid thickness exceeding half the Faraday wavelength λF). This in turn reveals that an inverse energy cascade and aspects of a confined 2D turbulence can coexist with a three dimensional bulk flow. In this work, 2D PIV measurements of the velocity fields are carried out at a vertical cross-section xz-plane and at four distinct horizontal xy-planes at different depths in Faraday waves. The results reveal that small and fast vertical jets penetrate from the surface into the bulk with fast accelerating bursts and strong momentum transport in the z−direction. Furthermore, the fraction of flow kinetic energy in the vertical direction is found to peak inside a layer of approximately 10 mm (one Faraday wavelength) below the fluid surface.


2012 ◽  
Vol 16 (2) ◽  
pp. 95-98 ◽  
Author(s):  
Yoshihide Tominaga ◽  
Tsubasa Okaze ◽  
Akashi Mochida ◽  
Yasutomo Sasaki ◽  
Masaki Nemoto ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document