Transformation behavior and magnetocaloric effect in Mn1−xCrxCoGe (x = 0.04 and 0.11) melt-spun ribbons tailored by heat treatment

2017 ◽  
Vol 444 ◽  
pp. 263-269 ◽  
Author(s):  
Gerardo Daniel-Pérez ◽  
J.L. Sánchez Llamazares ◽  
P. Alvarez-Alonso ◽  
C.F. Sánchez-Valdés ◽  
R. Varga ◽  
...  
2021 ◽  
Vol 21 (4) ◽  
pp. 2552-2557
Author(s):  
Nguyen Hai Yen ◽  
Nguyen Hoang Ha ◽  
Pham Thi Thanh ◽  
Nguyen Huy Ngoc ◽  
Tran Dang Thanh ◽  
...  

In this work, we investigated magnetic properties and magnetocaloric effect in Fe90−xCoxZr7Cu1B2 (x = 0, 1, 2, 3 and 4) melt-spun ribbons. The ribbons were prepared by using a melt-spinning method with a tangential velocity of a copper wheel of 40 m·s-1. The obtained ribbons are almost amorphous. The alloys exhibit typical soft magnetic behavior with low coercivity at room temperature. A minor replacement of Fe by Co gives an increment in Curie temperature (TC) of the alloys to higher temperatures. The TC of the alloys increases from 242 to 342 K with an increase of x from 0 to 4. Maximum magnetic entropy change, ΔSm max, of the alloys, was found to be larger than 0.7 J·kg-1·K-1 in a magnetic field change ΔH of 12 kOe for all the concentrations of Co. High refrigerant capacitys (RC >100 J ·kg-1 with ΔH = 12 kOe) at room temperature region have been obtained for the alloys. The large magnetocaloric effect near room temperature suggests that the alloys can be considered as magnetic refrigerants in the range of 250–350 K.


2020 ◽  
Vol 128 (5) ◽  
pp. 055110
Author(s):  
Yiqiao Yang ◽  
Zongbin Li ◽  
César Fidel Sánchez-Valdés ◽  
José Luis Sánchez Llamazares ◽  
Bo Yang ◽  
...  

2012 ◽  
Vol 05 ◽  
pp. 841-846
Author(s):  
AMIR KEYVANARA ◽  
REZA GHOLAMIPOUR ◽  
SHAMSEDIN MIRDAMADI ◽  
FARZAD SHAHRI ◽  
HOSSEIN SEPEHRI AMIN

Melt spun ribbons of Co 64 Fe 4 Ni 2 B 19 Si 8 Cr 3 alloy have been prepared and the nanocrystallization process was carried out by the heat treatment of the as spun ribbons above the crystallization temperature. Structural studies of the samples have been performed by transmission electron microscopy and X-ray diffraction. Magnetic properties of the samples and magnetoimpedance measurements were investigated and it was revealed that magnetic properties and magnetoimpedance of the samples deteriorate by the formation of nanocrystalline phases.


2012 ◽  
Vol 112 (3) ◽  
pp. 033903 ◽  
Author(s):  
X. C. Zhong ◽  
J. X. Min ◽  
Z. G. Zheng ◽  
Z. W. Liu ◽  
D. C. Zeng

2007 ◽  
Vol 561-565 ◽  
pp. 1481-1484 ◽  
Author(s):  
Hong Yan Xing ◽  
Hee Young Kim ◽  
Shuichi Miyazaki

Effects of rotation speed on the microstructure and transformation behavior were investigated for Ti-48at%Ni melt-spun ribbons. The Ti-48at%Ni shape memory alloy ribbons were fabricated by the melt-spinning method with various rotation speeds ranging from 2500rpm to 7500rpm. The melt-spun ribbons were completely crystallized to TiNi B2 phase during solidification at lower rotation speeds less than 4000rpm. Amorphous and B2 phase coexisted in the melt-spun ribbons fabricated at higher rotation speeds of 5000rpm and 7500rpm. The martensitic transformation behavior was investigated both in the as-spun and heat-treated ribbons. The transformation temperature increased with decreasing cooling rate and increasing heat-treatment temperature.


2009 ◽  
Vol 1 (3) ◽  
pp. 151-155 ◽  
Author(s):  
Ingale Babita ◽  
Raghavan Gopalan ◽  
Shanker Ram ◽  
Hans-Jörg Fecht

2019 ◽  
Vol 774 ◽  
pp. 700-705 ◽  
Author(s):  
J.L. Sánchez Llamazares ◽  
P. Ibarra-Gaytán ◽  
C.F. Sánchez-Valdés ◽  
Pablo Álvarez-Alonso ◽  
R. Varga

Sign in / Sign up

Export Citation Format

Share Document