Agreement between passive infrared detector measurements and human observations of animal activity

2018 ◽  
Vol 214 ◽  
pp. 219-224 ◽  
Author(s):  
R. Besteiro ◽  
M.R. Rodríguez ◽  
M.D. Fernández ◽  
J.A. Ortega ◽  
R. Velo
1987 ◽  
Vol 75 (1) ◽  
pp. 345-354 ◽  
Author(s):  
Hans Meixner

2019 ◽  
Vol 35 (4) ◽  
pp. 481-493 ◽  
Author(s):  
Y. Cai ◽  
Li Ma ◽  
Gang Liu

Abstract. The amount of daily activity can be used as important data for the analysis and evaluation of the health, diseases, and environmental conditions of hog farms, which in turn can affect fertility rate and productivity. In this article, a monitoring system based on a passive infrared detector (PID) is proposed to analyze daily hog activity and abnormal behaviors. The hardware includes a high-accuracy acquisition system, which uses a 24-bit ADS1256 chip as its A/D conversion and signal input channel, and a PID, which ensures that the signal can be obtained uninterruptedly day and night. Based on the LabVIEW software platform, a real-time data acquisition, display, and storage system was programmed in which the activity curve can be displayed, and the system parameters can be modified if necessary. A simulation experiment was performed in a test laboratory (7 × 17 m) with a larger size than a typical hog room (7 × 15 m), and the appropriate orientation of the sensor, the installed position, and the lens were selected. Data for 90 days (day and night) were collected in a hog room to establish the model of daily activity. To find the abnormal behaviors during the night, an improved K-means clustering was constructed. The results indicated that the improved K-means clustering method performed satisfactorily in clustering and anomaly detection. The developed system for daily activities monitoring and night-time anomaly detection could be a potential technique to assist research in hog behavior detection and animal welfare improvement. Keywords: Animal activity, Hog, Motion sensor, PID, Signal processing.


Animals ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 1607
Author(s):  
Roberto Besteiro ◽  
Tamara Arango ◽  
Juan Ortega ◽  
María D. Fernández ◽  
Manuel R. Rodríguez

Measuring animal activity is useful for monitoring animal welfare in real time. In this regard, passive infrared detectors have been used in recent years to quantify piglet activity because of their robustness and ease of use. This study was conducted on a commercial farm in Northwest Spain during six complete breeding cycles. The hourly average activity of weaned piglets with a body mass of 6–20 kg was recorded and further analyzed by using a multiplicative decomposition of the series followed by a wavelet analysis. Finally, the real series were compared to the theoretical models of activity. Results showed a high level of movement immediately after weaning and a sustained level of activity throughout the cycles. The daily behavior of the piglets followed a clear circadian pattern with several peaks of activity. No differences in behavior were observed between spring–summer cycles and autumn–winter cycles. Single-peak models achieved the best predictive results. In addition, the installed sensors were found to underestimate mild activity.


Author(s):  
M. E. Twigg ◽  
B. R. Bennett ◽  
J. R. Waterman ◽  
J. L. Davis ◽  
B. V. Shanabrook ◽  
...  

Recently, the GaSb/InAs superlattice system has received renewed attention. The interest stems from a model demonstrating that short period Ga1-xInxSb/InAs superlattices will have both a band gap less than 100 meV and high optical absorption coefficients, principal requirements for infrared detector applications. Because this superlattice system contains two species of cations and anions, it is possible to prepare either InSb-like or GaAs-like interfaces. As such, the system presents a unique opportunity to examine interfacial properties.We used molecular beam epitaxy (MBE) to prepare an extensive set of GaSb/InAs superlattices grown on an GaSb buffer, which, in turn had been grown on a (100) GaAs substrate. Through appropriate shutter sequences, the interfaces were directed to assume either an InSb-like or GaAs-like character. These superlattices were then studied with a variety of ex-situ probes such as x-ray diffraction and Raman spectroscopy. These probes confirmed that, indeed, predominantly InSb-like and GaAs-like interfaces had been achieved.


Sign in / Sign up

Export Citation Format

Share Document