Biofilm capacitance and mixed culture bacteria influence on performance of Microbial Fuel Cells-Electrochemical impedance studies

2019 ◽  
Vol 8 ◽  
pp. 11-21
Author(s):  
M. Sindhuja ◽  
V. Sudha ◽  
S. Harinipriya ◽  
Meenu chhabra
Author(s):  
Zhou Ye ◽  
Junbo Hou ◽  
Michael W. Ellis ◽  
Bahareh Behkam

A three-electrode system was used to study the effect of anode surface roughness on the performance of microbial fuel cells (MFCs). Two glassy carbon plates were polished to uniform roughness of the orders of magnitude of 10s of nm and 100s of nm. Atomic force microscopy (AFM) was used to quantify the roughness as well as the 3D topography of the surfaces. Multiple electrochemical methods including potentiostatic tests, potentiodynamic tests, and electrochemical impedance spectroscopy (EIS) were utilized to monitor the performance of the glassy carbon electrodes. After 275 hours of experimentation, the current density generated by the rough electrode was much higher than that generated by the smooth one. Furthermore, the charge-transfer resistance of the rough electrode was lower than that of the smooth one. The better electrochemical performance of the rough surface may be due to denser biofilm grown on the surface, which was observed by scanning electron microscopy (SEM).


2013 ◽  
Vol 16 (3) ◽  
pp. 217-228 ◽  
Author(s):  
Beni Camacho-Pérez ◽  
Elvira Ríos-Leal ◽  
Omar Solorza-Feria ◽  
Pedro Alberto Vazquez-Landa ◽  
Josefina Barrera-Cortés ◽  
...  

Lindane is a chlorinated pesticide known for its toxicity and persistence in the environment. Recently, it has been proposed that soil microbial fuel cell technology (SMFC) could be applied to enhance the removal of organic matter, phenol, and petroleum hydrocarbon in contaminated soil with simultaneous electricity output. Yet, there is no information on the application to remediation of soils polluted with pesticides. The purpose of this research was to evaluate the biodegradation of lindane with simultaneous electricity generation in an electrobiochemical slurry reactor (EBCR). The EBCR was inoculated with a sulfate reducing inoculum acclimated to lindane, it was further characterized, and batch operated for 30 day at room temperature. No external carbon source was supplemented in the experiment 1; the substrate was the soluble natural organic matter (NOM) of the soil. In the experiment 2 the EBCR was supplemented with a stock solution of sucrose: sodium acetate: lactate to give a final concentration of 2g COD/L in the reactor. Results from electrochemical impedance spectroscopy characterization in the EBCR (Experiment 1) showed that the equivalent circuit had a high anodic resistance R1=2064 Ω, cathodic resistance R3 = 192 Ω; and electrolyte/membrane resistance R2 = 7?, totaling a relatively high overall internal resistance Rint of 2263 Ω. During the batch operation, the EBCR showed a 30% lindane removal efficiency along with a maximum volumetric power of 165 mW m-3.This value compared favorably with results corresponding to sediments microbial fuel cells that are used to power weather monitoring systems. The organic matter removal was very high (72% as soluble COD, NOM) whereas the coulombic efficiency was low (5.4%). The latter, although, was higher than values reported for microbial fuel cells that degraded leachate-like effluents. In Experiment 2 of the EBCR both cell characteristics and performance significantly improved. The internal resistance as determined by polarization curve was 102 Ω when the two-electrode sets were connected in parallel. During the batch operation, the EBCR showed a 78% lindane removal and a maximum power volumetric of 634 mW m-3, the organic matter removal was 76% and coulombic efficiency was 15%. Finally, it can be concluded that our EBCR showed a high lindane removal capability and mixing of the slurry phase was associated to improvement of bioremediation and electricity performances of the device.


2017 ◽  
Vol 113 ◽  
pp. 79-84 ◽  
Author(s):  
Beenish Saba ◽  
Ann D. Christy ◽  
Zhongtang Yu ◽  
Anne C. Co ◽  
Rafiq Islam ◽  
...  

Energies ◽  
2021 ◽  
Vol 14 (1) ◽  
pp. 206
Author(s):  
Jiao Wang ◽  
Xiaohui Zhang ◽  
Yang Li ◽  
Peng Liu ◽  
Xiaochen Chen ◽  
...  

Sugar has the potential to create enough energy to power mobile electronics. Various sugar-powered fuel cells have been reported, however, most of them used pure glucose as substrate and enzymes/noble metals as catalysts. In this work, an alkaline fuel cell with cheap catalysts were constructed, and different sweet drinks were used as fuels for power generation. The influence of different substrates on the electrochemical performance was characterized under the controlled conditions. Our experimental results showed that the fuel cell fueled with carbonated soft drinks had the best performance under the conditions of 99.95 g/L chemical oxygen demand and 3M KOH. The power densities of the fuel cell fueled with different substrates decreased in the order of Pepsi (33.41 W/m2) > Sprite (28.38 W/m2) > apple juice (20.63 W/m2) > Coca (16.31 W/m2) > pear juice (15.31 W/m2) > orange juice (12.75 W/m2), which was consistent with linear sweep voltammetry (LSV) and electrochemical impedance spectroscopy (EIS) analysis. This is the first report on alkaline fuel cell (AFC) performance using different sweet drinks as substrate. These values are more than 10 times higher than those of reported microbial fuel cells. Our findings demonstrated that sweet drinks fueled alkaline fuel cells can be a promising energy source for low-power electronics.


Sign in / Sign up

Export Citation Format

Share Document