scholarly journals Luminescence of impyrity and radiation defects in magnesium oxide irradiated by fast neutrons

2009 ◽  
Vol 2 (2) ◽  
pp. 567-570 ◽  
Author(s):  
V. Skvortsova ◽  
L. Trinkler
2008 ◽  
Vol 2008 ◽  
pp. 1-4 ◽  
Author(s):  
T. Troev ◽  
N. Nankov ◽  
L. Petrov ◽  
E. Popov

Computer simulations of the radiation defects created in beryllium irradiated by fast neutrons (E>0.1 MeV) using the Geant4 and SRIM packages were carried out. The atom cascade displacements in Be at a neutron fluence of 1.6×1020 n/cm2 were determined to be 0.06 dpa and the helium concentration was calculated to be 168 appm. The concentration of 6Li has been estimated to be 5% in comparison to the He concentration. Nanoscale calculations were done in 30×30×30 nm cube of fast neutron-irradiated Be. A correlation between the Be primary knock-on atom (PKA) energies and the damage cascades has been established. The final defect distributions of single vacancies, divacancies, and small vacancy clusters were examined. Our results indicate that the damages caused by He atoms are about 3 times less than damages caused by Be primary knock-on atoms (PKAs).


Author(s):  
V. I. Bobrovskii ◽  

Processes that take place in the precipitates of -phase under irradiation with fast neutrons are topical and draw attention when one searches for ways of improving radiation resistance of structural reactor steels. A special feature of these processes is that the formation of vacancies and interstices proceeds at the background of a disordering of the initial crystal lattice, which mani-fests itself in the formation of antisite defects. X-ray and neutron diffraction techniques are efficient tools of studying changes that occur in the post-radiation structural state of such systems. However, interpretation of the experimental results calls for more complicated models for the description of structural effects exerted by accumulation of radiation defects in the material than those developed before for elementary metals. Several models are proposed in this paper.


2010 ◽  
Vol 46 (4) ◽  
pp. 298-300
Author(s):  
M. Karimov ◽  
Sh. Makhkamov ◽  
Sh. A. Makhmudov ◽  
R. A. Muminov ◽  
A. Z. Rakhmatov ◽  
...  

1966 ◽  
Vol 13 (126) ◽  
pp. 1149-1156 ◽  
Author(s):  
B. Henderson ◽  
R. D. King

2015 ◽  
Vol 770 ◽  
pp. 518-521 ◽  
Author(s):  
A.V. Gradoboev ◽  
V.V. Sednev

In this paper we present the results of investigation of the power mode influence on the resistance to fast neutron irradiation of IR-LEDs based on AlGaAs heterostructures. The investigation shows that there are 2 stages of LED emissive power lowering. At the first stage the emissive power decreases due to reorganization of existing defective structure. At the second stage it happens as the result of radiation defects introduction. The rate of defects introduction that influences the emissive power lowering at the first stage in the space charge region of the embedded p-n junction is higher than in the neutral region. The forward current flowing under irradiation results in partial annealing of introduced defects and consequently to resistance growth at the first stage of emissive power lowering. The LED power mode doesn’t contribute essentially to the power lowering at the second stage while observed difference is due to decrease of contribution of the first stage to the whole process of emissive power lowering.


1979 ◽  
Vol 44 (4) ◽  
pp. 1023-1033 ◽  
Author(s):  
Milan Pospíšil ◽  
Miroslav Tvrzník

The low-temperature reduction of the mixed system nickel oxide-magnesium oxide with hydrogen was studied thermogravimetrically in the region 260-470 °C. The two oxides form in the whole composition region solid solutions, some physicochemical parameters of which vary nonmonotonically with the sample composition. The kinetics and degree of reduction of nickel oxide are appreciably affected by the presence of the unreduced magnesium oxide, in higher concentrations lowering the reaction rate. The kinetics of the reduction can be quantitatively described by the equation 1-(1-α)1/3 = kt, valid in dependence on the composition in differently wide ranges of the degree of reduction α. The reaction rate can be varied, particularly for samples with low contents of magnesium oxide, by heat treatment in inert atmosphere at 700 °C, and for all samples by irradiation by gamma rays or fast neutrons. The reduction rate grows with the increasing content of magnesium oxide up to a constant value. The positive effect increases with the increasing gamma dose and, according to the kind of radiation, in the order γ, n. The variation of the reactivity of irradiated or thermally treated mixed oxides is due predominantly to the shift of the equilibrium of the lattice defects, formation and stabilization of new centres, which affect the rate of nucleation of the forming metal phase.


2018 ◽  
Vol 173 (3-4) ◽  
pp. 223-231 ◽  
Author(s):  
V. G. Kvatchadze ◽  
V. T. Gritsyna ◽  
M. G. Abramishvili ◽  
G. G. Dekanozishvili ◽  
M. V. Galustashvili ◽  
...  

Author(s):  
P. L. Burnett ◽  
W. R. Mitchell ◽  
C. L. Houck

Natural Brucite (Mg(OH)2) decomposes on heating to form magnesium oxide (MgO) having its cubic ﹛110﹜ and ﹛111﹜ planes respectively parallel to the prism and basal planes of the hexagonal brucite lattice. Although the crystal-lographic relation between the parent brucite crystal and the resulting mag-nesium oxide crystallites is well known, the exact mechanism by which the reaction proceeds is still a matter of controversy. Goodman described the decomposition as an initial shrinkage in the brucite basal plane allowing magnesium ions to shift their original sites to the required magnesium oxide positions followed by a collapse of the planes along the original <0001> direction of the brucite crystal. He noted that the (110) diffraction spots of brucite immediately shifted to the positions required for the (220) reflections of magnesium oxide. Gordon observed separate diffraction spots for the (110) brucite and (220) magnesium oxide planes. The positions of the (110) and (100) brucite never changed but only diminished in intensity while the (220) planes of magnesium shifted from a value larger than the listed ASTM d spacing to the predicted value as the decomposition progressed.


Author(s):  
T. Kizuka ◽  
N. Tanaka

Structure and stability of atomic clusters have been studied by time-resolved high-resolution electron microscopy (TRHREM). Typical examples are observations of structural fluctuation in gold (Au) clusters supported on silicon oxide films, graphtized carbon films and magnesium oxide (MgO) films. All the observations have been performed on the clusters consisted of single metal element. Structural stability of ceramics clusters, such as metal-oxide, metal-nitride and metal-carbide clusters, has not been observed by TRHREM although the clusters show anomalous structural and functional properties concerning to solid state physics and materials science.In the present study, the behavior of ceramic, magnesium oxide (MgO) clusters is for the first time observed by TRHREM at 1/60 s time resolution and at atomic resolution down to 0.2 nm.MgO and gold were subsequently deposited on sodium chloride (001) substrates. The specimens, single crystalline MgO films on which Au particles were dispersed were separated in distilled water and observed by using a 200-kV high-resolution electron microscope (JEOL, JEM2010) equipped with a high sensitive TV camera and a video tape recorder system.


Sign in / Sign up

Export Citation Format

Share Document