Nanoparticle transport effect on magnetohydrodynamic mixed convection of electrically conductive nanofluids in micro-annuli with temperature-dependent thermophysical properties

This paper describes the mechanical and thermophysical properties of actinide monocarbides AnCs (An=Np and Cm) as a function of temperature and crystallographic direction. The temperature-dependent second- and third-order elastic constant (SOECs and TOECs) have been computed first using Coulomb and Born–Mayer potential up to second nearest neighbor. SOECs have been applied to find out mechanical constant such as bulk modulus, shear modulus, tetragonal modulus, Poisson’s ratio and Zener anisotropy for the prediction of futuristic performance of the NpC and CmC. We also found the value of G/B [Formula: see text] 0.59 for the chosen materials, which indicates that NpC and CmC have brittle nature. The computed elastic constants are further applied directly to indirectly find out the ultrasonic velocity, Grüneisen parameters, pressure derivative, Debye temperature, micro-hardness, Breazeale’s nonlinearity parameter, thermal relaxation time and thermal conductivity. These evaluated parameters were finally used to compute ultrasonic attenuation of the NpC and CmC along [Formula: see text], [Formula: see text] and [Formula: see text] directions at room temperature. The behavior of the obtained results of this investigation has been compared with similar type of materials.

Download Full-text

Simultaneous inverse determination of temperature-dependent thermophysical properties in fluids using the network simulation method

International Journal of Heat and Mass Transfer ◽

10.1016/j.ijheatmasstransfer.2007.01.004 ◽

2007 ◽

Vol 50 (15-16) ◽

pp. 3234-3243 ◽

Cited By ~ 37

Author(s):

J. Zueco ◽

F. Alhama

Keyword(s):

Thermophysical Properties ◽

Network Simulation ◽

Simulation Method ◽

Temperature Dependent ◽

Network Simulation Method

Download Full-text

Effects of Temperature Dependent Viscosity and Thermal Conductivity on MHD Mixed Convection Flow of Dusty Fluid Through a Vertical Porous Plate

International Journal of Engineering Trends and Technology ◽

10.14445/22315381/ijett-v55p222 ◽

2018 ◽

Vol 55 (3) ◽

pp. 113-119 ◽

Cited By ~ 1

Author(s):

Santana Hazarika ◽

◽

G.C.Haza rika

Keyword(s):

Thermal Conductivity ◽

Mixed Convection ◽

Porous Plate ◽

Convection Flow ◽

Mixed Convection Flow ◽

Temperature Dependent ◽

Temperature Dependent Viscosity ◽

Vertical Porous Plate ◽

Effects Of Temperature ◽

Dependent Viscosity

Download Full-text

Mechanical and thermophysical properties of rare-earth monopnictides

International Journal of Computational Materials Science and Engineering ◽

10.1142/s2047684116500123 ◽

2016 ◽

Vol 05 (03) ◽

pp. 1650012

Author(s):

Vyoma Bhalla ◽

Devraj Singh ◽

Sushil Kumar Jain

Keyword(s):

Thermal Properties ◽

Rare Earth ◽

Thermophysical Properties ◽

Nearest Neighbors ◽

Mechanical And Thermal Properties ◽

Ultrasonic Velocities ◽

Temperature Dependent ◽

Repulsive Potentials ◽

Similar Materials ◽

Hardness Values

The present paper addresses the temperature dependent elastic, mechanical and thermal properties of NaCl structure (B1 type) holmium monopnictides, HoX (X = N, P, As, Sb, Bi) computed using Coulomb and Born repulsive potentials extended up to second nearest neighbors. The second-order elastic constants (SOECs) of single crystals HoX are calculated as a function of temperature in the range 0–500[Formula: see text]K. The compounds under study are found to be brittle in nature. Beside these calculations, the theoretical hardness has been obtained for various rare-earth monopnictides using the elastic properties in the polycrystalline approach. The obtained hardness values indicate HoN to be hard, but cannot be considered super hard. The anisotropic nature of the chosen single crystal is an important physical quantity in studying the directional dependent thermal properties such as Debye temperature and thermal conductivity computed using ultrasonic velocities along different crystallographic directions. The obtained results are discussed in correlation with mechanical and thermophysical properties of similar materials.

Download Full-text