Discrete element modeling of the compression molding of polymer–crystal composite particles

Polymer–crystal composite particles formed by crystals coated with binders are widely used in the fields of medicine, energy, the chemical industry, and civil engineering. Binder content is an important factor in determining the mechanical behavior of composite particles. Therefore, this study aimed to investigate the underlying effect of binder coatings in the fracture micromechanics of polymer–crystal composite particles using the discrete element method (DEM). To achieve this objective, realistic particle and crystal shapes were first obtained and reconstructed based on X-ray micro-computed tomography (μCT) scanning and scanning electron microscope (SEM) images. A series of single particle crushing tests and DEM simulations were conducted on real and reconstructed polymer–crystal composite particles, respectively. Based on the experimental and DEM results, the effect of binder coatings on the crushing strength and crushing patterns of polymer–crystal composite particles was measured. Moreover, the micromechanics of the development and distribution of microcracks was further investigated to reveal the mechanism by which binder coatings affect polymer–crystal composite particles.

Download Full-text

An Energy-Based Discrete Element Modeling Method Coupled with Time-Series Analysis for Investigating Deformations and Failures of Jointed Rock Slopes

Applied Sciences ◽

10.3390/app11125447 ◽

2021 ◽

Vol 11 (12) ◽

pp. 5447

Author(s):

Xiaona Zhang ◽

Gang Mei ◽

Ning Xi ◽

Ziyang Liu ◽

Ruoshen Lin

Keyword(s):

Time Series ◽

Iterative Process ◽

Discrete Element ◽

Jointed Rock ◽

Modeling Method ◽

Discrete Element Modeling ◽

Rock Slopes ◽

Sliding Surface ◽

Element Modeling ◽

Displacement Based

The discrete element method (DEM) can be effectively used in investigations of the deformations and failures of jointed rock slopes. However, when to appropriately terminate the DEM iterative process is not clear. Recently, a displacement-based discrete element modeling method for jointed rock slopes was proposed to determine when the DEM iterative process is terminated, and it considers displacements that come from rock blocks located near the potential sliding surface that needs to be determined before the DEM modeling. In this paper, an energy-based discrete element modeling method combined with time-series analysis is proposed to investigate the deformations and failures of jointed rock slopes. The proposed method defines an energy-based criterion to determine when to terminate the DEM iterative process in analyzing the deformations and failures of jointed rock slopes. The novelty of the proposed energy-based method is that, it is more applicable than the displacement-based method because it does not need to determine the position of the potential sliding surface before DEM modeling. The proposed energy-based method is a generalized form of the displacement-based discrete element modeling method, and the proposed method considers not only the displacement of each block but also the weight of each block. Moreover, the computational cost of the proposed method is approximately the same as that of the displacement-based discrete element modeling method. To validate that the proposed energy-based method is effective, the proposed method is used to analyze a simple jointed rock slope; the result is compared to that achieved by using the displacement-based method, and the comparative results are basically consistent. The proposed energy-based method can be commonly used to analyze the deformations and failures of general rock slopes where it is difficult to determine the obvious potential sliding surface.

Download Full-text