Interface structure of (130) twin in the U-14.0 at.% Nb alloy: an experimental and theoretical study

2022 ◽  
Vol 209 ◽  
pp. 114417
Author(s):  
Xin Wang ◽  
Wenyuan Wang ◽  
Chao Lu ◽  
Yawen Zhao ◽  
Ruizhi Qiu ◽  
...  
2020 ◽  
Vol 3 (6) ◽  
pp. 5153-5162
Author(s):  
Sachin R. Rondiya ◽  
Yogesh Jadhav ◽  
Nelson Y. Dzade ◽  
Raihan Ahammed ◽  
Tanmay Goswami ◽  
...  

Author(s):  
C. B. Carter ◽  
J. Rose ◽  
D. G. Ast

The hot-pressing technique which has been successfully used to manufacture twist boundaries in silicon has now been used to form tilt boundaries in this material. In the present study, weak-beam imaging, lattice-fringe imaging and electron diffraction techniques have been combined to identify different features of the interface structure. The weak-beam technique gives an overall picture of the geometry of the boundary and in particular allows steps in the plane of the boundary which are normal to the dislocation lines to be identified. It also allows pockets of amorphous SiO2 remaining in the interface to be recognized. The lattice-fringe imaging technique allows the boundary plane parallel to the dislocation to be identified. Finally the electron diffraction technique allows the periodic structure of the boundary to be evaluated over a large area - this is particularly valuable when the dislocations are closely spaced - and can also provide information on the structural width of the interface.


Author(s):  
M.J. Witcomb ◽  
U. Dahmen ◽  
K.H. Westmacott

Cu-Cr age-hardening alloys are of interest as a model system for the investigation of fcc/bcc interface structures. Several past studies have investigated the morphology and interface structure of Cr precipitates in a Cu matrix (1-3) and good success has been achieved in understanding the crystallography and strain contrast of small needle-shaped precipitates. The present study investigates the effect of small amounts of phosphorous on the precipitation behavior of Cu-Cr alloys.The same Cu-0.3% Cr alloy as was used in earlier work was rolled to a thickness of 150 μm, solution treated in vacuum at 1050°C for 1h followed by quenching and annealing for various times at 820 and 863°C.Two laths and their corresponding diffraction patterns in an alloy aged 2h at 820°C are shown in correct relative orientation in Fig. 1. To within the limit of accuracy of the diffraction patterns the orientation relationship was that of Kurdjumov-Sachs (KS), i.e. parallel close-packed planes and directions.


1999 ◽  
Vol 96 (12) ◽  
pp. 1817-1822
Author(s):  
TRUNG NGOC LE, LOC THANH NGUYEN, MINH THO

2002 ◽  
Vol 75 (4-5) ◽  
pp. 413-421
Author(s):  
Durga Prasad Ojha ◽  
Devesh Kumar ◽  
V.G.K.M. Pisipati

Sign in / Sign up

Export Citation Format

Share Document