Leaching behavior of cadmium from hazardous waste

2012 ◽  
Vol 86 ◽  
pp. 9-18 ◽  
Author(s):  
Mahdi Gharabaghi ◽  
Mehdi Irannajad ◽  
Amir Reza Azadmehr
2015 ◽  
Vol 1103 ◽  
pp. 121-127
Author(s):  
Suthatip Sinyoung ◽  
Ekkachai Taweekitwanit ◽  
Puangrat Kajitvichyanukul

Burning of hazardous waste in cement kiln is the new technology based on waste derived and alternative fuels. Besides being the alternative way to destroy hazardous waste, this method provides alternative material as raw material or the fuel in the cement production process. This disposal method can be applied if the contaminant either does not appear in the emission or leach from cement to environment. This work focused on properties and the leaching behavior of nickel from cement. The resulting clinker was analyzed for the content of free lime and X-ray diffraction (XRD) analysis was done. The identification of MgNiO2 peaks in XRD pattern was found in all clinkers with nickel addition in the range of 0.5-2.0 wt.%. Results obtained from this part suggested that nickel incorporated in the clinker phase and may combine with magnesium to form the new compound as MgNiO2 during the burning process. To study the leaching behavior, M3051A, NEN:7341 and pH static leach test were used. Results showed that approximately 3% of nickel can be leached to environment. From the pH static leach test, nickel was effectively leached at pH 4 and the reachability of its decreased when the pH increased. In this work, Toxicity characteristic leaching procedure (TCLP) was also used to identify the cement as hazardous waste or non-hazardous waste. The results showed that raw material doped with nickel up to 2 wt.%, the cement was not classified as hazardous waste.


2021 ◽  
Author(s):  
Vinod Kumar ◽  
Pokhraj Sahu ◽  
Richa Singh ◽  
Arti Gupta ◽  
Pramod Kumar Singh

Abstract Without immobilized hazardous waste contaminates soil and groundwater, which can further bio-accumulates and poses serious negative health impact on flora as well as fauna. The present investigation has been conducted to study of leaching behavior of chromium species in immobilized hazardous waste containing Basic Chrome Sulphate (BCS) dumped at dumping site Khanchandpur Kharanja, Rania, Kanpur Dehat district of Uttar Pradesh, India. Results indicated that the pH of sludge ranged from 10.16–11.90 while EC ranged from 840-16160 dSm-1 in a different layer of the dumpsite and significantly varies on increasing depth. A similar trend was also observed in TDS contents which strongly justified the leaching of salts in lower depth. Total Cr concentration (25029.94 mg kg-1) was observed in the top layer which was significantly increased on increasing depth i.e., 36102.0 mg kg-1 and 42811.77 mg kg-1 while TCLP based concentration ( 216.44 mg kg-1 in top layer) was significantly increased on increasing depth i.e., 406.25 mg kg-1 and 517.60 mg kg-1. A similar trend was also observed in total and TCLP hexavalent and trivalent (Cr6+ and Cr3+) chromium concentration. Hierarchical Cluster Analysis is separated all sample based on depth into three different cluster based on dissimilarity. A significant correlation was observed with TCLP Cr6+ in TCLP Cr3+, EC, and TDS at 0.01 levels while EC, TDS, total Cr6+, and TCLP Cr were significant correlated with TCLP Cr3+. The leaching behavior of Cr species was higher as well as increasing of depth in the dumping site.


Author(s):  
L. L. Sutter ◽  
G. R. Dewey ◽  
J. F. Sandell

Municipal waste combustion typically involves both energy recovery as well as volume reduction of municipal solid waste prior to landfilling. However, due to environmental concerns, municipal waste combustion (MWC) has not been a widely accepted practice. A primary concern is the leaching behavior of MWC ash when it is stored in a landfill. The ash consists of a finely divided fly ash fraction (10% by volume) and a coarser bottom ash (90% by volume). Typically, MWC fly ash fails tests used to evaluate leaching behavior due to high amounts of soluble lead and cadmium species. The focus of this study was to identify specific lead bearing phases in MWC fly ash. Detailed information regarding lead speciation is necessary to completely understand the leaching behavior of MWC ash.


Sign in / Sign up

Export Citation Format

Share Document