Relationship between earthquake-induced uplift of rectangular underground structures and the excess pore water pressure ratio in saturated sandy soils

2018 ◽  
Vol 79 ◽  
pp. 35-51 ◽  
Author(s):  
Jilei Hu ◽  
Qihua Chen ◽  
Huabei Liu
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Pressure Ratio ◽  
Sandy Soils ◽  
Underground Structures ◽  
Excess Pore Water Pressure ◽  
Excess Pore

Study on Dissipation of Excess Pore Water Pressure of Clay

2012 ◽  
Vol 174-177 ◽  
pp. 1981-1985
Author(s):  
Jian Zhong Li ◽  
Kangning Hao
Keyword(s):  
Strain Rate ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Axial Stress ◽  
Water Pressure ◽  
Pressure Ratio ◽  
Back Pressure ◽  
Creep Tests ◽  
Excess Pore Water Pressure ◽  
Excess Pore

Dissipation of excess pore water pressure of saturation clay was discussed in the paper. Monotonic loading, unloading-reloading, and creep tests of one dimensional compression were performed to study the orderliness of dissipation of excess pore water pressure. In the drained consolidated tests, strain rate was changed step by step to check the effects of excess pore water pressure on effective axial stress. Creep tests were performed in different stage of loading and unloading procedure under different effective axial stress. In order to estimate the effects of excess pore water on effective axial stress more precisely, excess pore water pressure ratio was introduced. Test results show that: (1) excess pore water pressure changed gradually as strain rate changed abruptly, while excess pore water pressure ratio changed quickly; (2) excess pore water pressure maintained constant shortly after the change of strain rate during monotonic loading tests under small strain rate; (3) excess pore water pressure may be smaller than back pressure during unloading-reloading tests, in which, excess pore water pressure ratio is negative; (4) there neutral creep existed in unloading-creep-unloading procedure. Excess pore water pressure ratio equal to 0 and excess pore water pressure maintained a constant value equal to the back pressure in neutral creep.

Influence of Soil Consolidation History on Seismic Response of Underground Structure in Layered Liquefiable Ground

2013 ◽  
Vol 639-640 ◽  
pp. 670-677
Author(s):  
Zhi Fan Xia ◽  
Yan Ling Zheng ◽  
Guan Lin Ye
Keyword(s):  
Constitutive Model ◽  
Pore Water ◽  
Yield Surface ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Underground Structure ◽  
Soil Consolidation ◽  
Underground Structures ◽  
Excess Pore Water Pressure ◽  
Excess Pore

It is shown that liquefaction induced uplift is one of the most typical disasters for underground structures in liquefiable zone. Though a lot of researches were conducted to investigate the uplift phenomenon of underground structures in the past years, further studies need to be carried out to discover its mechanism because the seismic responses were correlated with many factors. In the paper, a fully coupled dynamic analysis was performed to investigate the dynamic responses of underground structure in layered saturated ground. The soils were simulated by a cyclic mobility constitutive model, which adopted some important concepts such as stress induced anisotropy, subloading yield surface, and superloading yield surface. It was verified that the constitutive model can perfectly describe the dynamic character of both liquefiable sand and non-liquefiable clay. Simulated results were obtained for excess pore water pressure and deformation of soil deposit and uplift of underground structure. Special emphasis was given to discuss the influence of soil consolidation history on the seismic responses of underground structure. Simulation indicated that with the occurrence of liquefaction, soils at lateral sides of underground structure flowed toward the bottom of the structure, which led to the uplift of structure. Results also showed that the excess pore water pressure ratio of liquefiable soil decreased with the increasing of soil pre-consolidation pressure. Then the liquefied zones diminished, and the uplift of underground structure reduced.

Stress–strain pattern–based criterion to assess cyclic shear resistance of soil from laboratory element tests

2016 ◽  
Vol 53 (9) ◽  
pp. 1460-1473 ◽  
Author(s):  
Dharma Wijewickreme ◽  
Achala Soysa
Keyword(s):  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Shear Stiffness ◽  
Large Strains ◽  
Fundamental Parameter ◽  
Stress Strain ◽  
Cyclic Shear ◽  
Excess Pore Water Pressure ◽  
Excess Pore

The cyclic shear response of soils is commonly examined using undrained (or constant-volume) laboratory element tests conducted using triaxial and direct simple shear (DSS) devices. The cyclic resistance ratio (CRR) from these tests is expressed in terms of the number of cycles of loading to reach unacceptable performance that is defined in terms of the attainment of a certain excess pore-water pressure and (or) strain level. While strain accumulation is generally commensurate with excess pore-water pressure, the definition of unacceptable performance in laboratory tests based purely on cyclic strain criteria is not robust. The shear stiffness is a more fundamental parameter in describing engineering performance than the excess pore-water pressure alone or shear strain alone; so far, no criterion has considered shear stiffness to determine CRR. Data from cyclic DSS tests indicate consistent differences inherent in the patterns between the stress–strain loops at initial and later stages of cyclic loading; instead of relatively “smooth” stress–strain loops in the initial parts of loading, nonsmooth changes in incremental stiffness showing “kinks” are notable in the stress–strain loops at large strains. The point of pattern change in a stress–strain loop provides a meaningful basis to determine the CRR (based on unacceptable performance) in cyclic shear tests.

Consolidation Theory for Composite Ground with Granular Columns Based on Different Calculation Models

2011 ◽  
Vol 261-263 ◽  
pp. 1534-1538
Author(s):  
Yu Guo Zhang ◽  
Ya Dong Bian ◽  
Kang He Xie
Keyword(s):  
Pore Water ◽  
Analytical Solutions ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Vertical Flow ◽  
Excess Pore Water Pressure ◽  
Consolidation Theory ◽  
Composite Ground ◽  
Granular Column ◽  
Excess Pore

The consolidation of the composite ground under non-uniformly distributed initial excess pore water pressure along depth was studied in two models which respectively considering both the radial and vertical flows in granular column and the vertical flow only in granular column, and the corresponding analytical solutions of the two models were presented and compared with each other. It shows that the distribution of initial excess pore water pressure has obvious influence on the consolidation of the composite ground with single drainage boundary, and the rate of consolidation considering the radial-vertical flow in granular column is faster than that considering the vertical flow only in granular column.

The Test Study to the Changes of Excess Pore Water Pressure during Precast Pile Construction

2012 ◽  
Vol 193-194 ◽  
pp. 1010-1013
Author(s):  
Shu Qing Zhao
Keyword(s):  
Pore Water ◽  
Clayey Soil ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Excess Pore Pressure ◽  
Soil Pressure ◽  
Excess Pore Water Pressure ◽  
Test Study ◽  
Excess Pore

The construct to precast pile in thick clayey soil can cause the accumulation of excess pore water pressure. The high excess pore pressure can make soil, buildings and pipes surrounded have large deflection, even make them injured. Combining with actual projects, this paper presents an in-situ model test on the changes of excess pore water pressure caused by precast pile construct. It is found that the radius of influence range for single pile driven is about 15m，the excess pore water pressure can reach or even exceed the above effective soil pressure, and there are two relatively stable stages.

A Practical Saturated Sand Elastic-Plastic Dynamic Constitutive Model and Application

2012 ◽  
Vol 446-449 ◽  
pp. 1621-1626 ◽  
Author(s):  
Yan Mei Zhang ◽  
Dong Hua Ruan
Keyword(s):  
Constitutive Model ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Stone Columns ◽  
Saturated Sand ◽  
Multidimensional Model ◽  
Excess Pore Water Pressure ◽  
Elastic Plastic ◽  
Excess Pore

A practical saturated sand elastic-plastic dynamic constitutive model was developed on the base of Handin-Drnevich class nonlinear lag model and multidimensional model. In this model, during the calculation of loading before soil reaches yielding, unloading and inverse loading, corrected Handin-Drnevich equivalent nonlinear model was adopted; after soil yielding, based on the idea of multidimensional model, the composite hardening law which combines isotropy hardening and follow-up hardening, corrected Mohr-Coulomb yielding criterion and correlation flow principle were adopted. A fully coupled three dimension effective stress dynamic analysis procedure was developed on the base of this model. The seismic response of liquefaction foundation reinforced by stone columns was analyzed by the developed procedure. The research shows that with the diameter of stone columns increasing, the excess pore water pressure in soil between piles decreases; with the spacing of columns increasing, the excess pore water pressure increases. The influence of both is major in middle and lower level of composite foundation.

scholarly journals Effect of Reduced Zone on Time-Dependent Analysis of Tunnels

2011 ◽  
Vol 2011 ◽  
pp. 1-12
Author(s):  
Mohammed Y. Fattah ◽  
Kais T. Shlash ◽  
Nahla M. Salim
Keyword(s):  
Finite Element ◽  
Pore Water ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Outer Diameter ◽  
Transient Effects ◽  
Excess Pore Water Pressure ◽  
Modified Cam Clay ◽  
Tunnel Diameter ◽  
Excess Pore

The problem of the proposed “Baghdad metro line” which consists of two routes of 32 km long and 36 stations is analyzed. The tunnel is circular in cross-section with a 5.9 m outer diameter. The finite element analyses were carried out using elastic-plastic and modified Cam clay models for the soil. The excavation has been used together with transient effects through a fully coupled Biot formulation. All these models and the excavation technique together with Biot consolidation are implemented into finite-element computer program named “Modf-CRISP” developed for the purpose of these analyses. The results indicate that there is an inward movement at the crown and this movement is restricted to four and half tunnel diameters. A limited movement can be noticed at spring line which reaches 0.05% of tunnel diameter, while there is a heave at the region below the invert, which reaches its maximum value of about 0.14% of the diameter and is also restricted to a region extending to 1.5 diameters. The effect of using reduced zone on excess pore water pressure and surface settlement (vertical and horizontal) was also considered and it was found that the excess pore water pressure increases while the settlement trough becomes deeper and narrower using reduced .

Sign in / Sign up

Export Citation Format

Share Document