Analytical solution of the non-uniform heat exchange in a reactor cooling coil with constant fluid flow

1997 ◽  
Vol 43 (2) ◽  
pp. 101-113 ◽  
Author(s):  
Ph. Bogaerts ◽  
J. Castillo ◽  
R. Hanus
Geophysics ◽  
1997 ◽  
Vol 62 (1) ◽  
pp. 309-318 ◽  
Author(s):  
Jorge O. Parra

The transversely isotropic poroelastic wave equation can be formulated to include the Biot and the squirt‐flow mechanisms to yield a new analytical solution in terms of the elements of the squirt‐flow tensor. The new model gives estimates of the vertical and the horizontal permeabilities, as well as other measurable rock and fluid properties. In particular, the model estimates phase velocity and attenuation of waves traveling at different angles of incidence with respect to the principal axis of anisotropy. The attenuation and dispersion of the fast quasi P‐wave and the quasi SV‐wave are related to the vertical and the horizontal permeabilities. Modeling suggests that the attenuation of both the quasi P‐wave and quasi SV‐wave depend on the direction of permeability. For frequencies from 500 to 4500 Hz, the quasi P‐wave attenuation will be of maximum permeability. To test the theory, interwell seismic waveforms, well logs, and hydraulic conductivity measurements (recorded in the fluvial Gypsy sandstone reservoir, Oklahoma) provide the material and fluid property parameters. For example, the analysis of petrophysical data suggests that the vertical permeability (1 md) is affected by the presence of mudstone and siltstone bodies, which are barriers to vertical fluid movement, and the horizontal permeability (1640 md) is controlled by cross‐bedded and planar‐laminated sandstones. The theoretical dispersion curves based on measurable rock and fluid properties, and the phase velocity curve obtained from seismic signatures, give the ingredients to evaluate the model. Theoretical predictions show the influence of the permeability anisotropy on the dispersion of seismic waves. These dispersion values derived from interwell seismic signatures are consistent with the theoretical model and with the direction of propagation of the seismic waves that travel parallel to the maximum permeability. This analysis with the new analytical solution is the first step toward a quantitative evaluation of the preferential directions of fluid flow in reservoir formation containing hydrocarbons. The results of the present work may lead to the development of algorithms to extract the permeability anisotropy from attenuation and dispersion data (derived from sonic logs and crosswell seismics) to map the fluid flow distribution in a reservoir.


2021 ◽  
Vol 2057 (1) ◽  
pp. 012007
Author(s):  
A I Kadyirov ◽  
E K Vachagina

Abstract A semi-analytical solution to the problem of the steady flow of viscoelastic single equation eXended Pom-Pom (XPP) fluid in a round pipe using the four-mode rheological equation of state of XPP is presented. An original parametric method for solving the set problem is used. The resulting method is applicable for solving a similar problem in a flat slit. The developed solution method is tested by comparing it with numerical results and experimental data. Using a polyacrylamide solution as an example, the influence of the Weissenberg number on the axial velocity profiles and the components of normal stresses is studied.


Elements ◽  
2020 ◽  
Vol 16 (5) ◽  
pp. 319-324
Author(s):  
Emily H. G. Cooperdock ◽  
Alexis K. Ault

Fault zones record the dynamic motion of Earth’s crust and are sites of heat exchange, fluid–rock interaction, and mineralization. Episodic or long-lived fluid flow, frictional heating, and/or deformation can induce open-system chemical behavior and make dating fault zone processes challenging. Iron oxides are common in a variety of geologic settings, including faults and fractures, and can grow at surface-to magmatic temperatures. Recently, iron oxide (U–Th)/He thermochronology, coupled with microtextural and trace element analyses, has enabled new avenues of research into the timing and nature of fluid–rock interactions and deformation. These constraints are important for understanding fault zone evolution in space and time.


2020 ◽  
Vol 43 (5) ◽  
pp. 457-462
Author(s):  
Pramod Kumar Yadav ◽  
Jaikanth Yadav Puchakatla ◽  
Sneha Jaiswal

1970 ◽  
Vol 185 (1) ◽  
pp. 925-930 ◽  
Author(s):  
A. R. Shouman ◽  
C. E. Garcia

An analytical solution for the compressible one-dimensional flow in convergent and divergent ducts with friction is obtained. It is found that a non-dimensional parameter, N, can be formed using the friction factor, duct half-angle and the ratio of specific heats of the gas. Seven flow regimes are describable with the solution, based on certain bounds on the magnitude of N. The regimes are discussed and corollary data are presented graphically.


2020 ◽  
Vol 154 ◽  
pp. 04001
Author(s):  
Przemysław Motyl ◽  
Marcin Wikło ◽  
Julita Bukalska ◽  
Bartosz Piechnik ◽  
Rafał Kalbarczyk

In Europe, especially in Poland, wood-fired stoves remain one of the most popular renewable household heating. The use of wood logs in small-scale units stoves are expected to increase substantially. The work proposes a comprehensive approach to modify the design of wood stoves with heating power up to 20 kW, including design works, simulations, and experimental research. The article also presents the numerical study of a combustion process including fluid flow, chemical combustion reaction, and heat exchange in the wood stove. The retrofit enhanced a more stable heat release from the wood stove, which increased efficiency and reduction of the harmful components of combustion.


Sign in / Sign up

Export Citation Format

Share Document