Microstructural design is generally applied to improve the mechanical property of titanium alloy by introducing different phase transformations and thermomechanical treatments. Aside from the martensitic and diffusion transformation, the occurrence of massive transformation occurs in Ti alloy. Massive transformation is categorized as civilian phase transformation, which resulted in the change of crystal structure of an alloy with a given composition without changing the chemical composition of its initial phase. It happened when the body centered-cubic β phase changed into hexagonal closed-pack α phase without decomposing into α+β. Massive transformation involves a diffusion and growth mechanism in a short-range and generally occurs during the introduction of high cooling rates to restrict the full diffusion mechanism. Owing to the nature of a rapid cooling rate as a requirement for massive transformation, the massive phase is normally found together with the product of martensitic transformation. On the other hand, the product of massive transformation is observed as a blocky grain with a featureless characteristic using optical microscopy and. Phase identification using electron backscattered diffraction shows that the region of αm shows only the presence of the α phase. It was reported for containing a high dislocation density similar to martensitic transformation. Specifically, in Ti alloy, the higher magnification using scanning electron microscopy shows fine sub-lamellar morphology, which observed as a combination product morphology between martensitic and diffusion transformation. It resulted in the mechanical property of the massive phase is between those two morphologies. Hence, it brings a new perspective on designing the microstructure of Ti alloy, which can be used to improve the mechanical property of Ti alloy.
Dynamic Phase Transformation Behavior of a Nb-microalloyed Steel during Roughing Passes at Temperatures above the Ae3
