Experimental study of unsteadiness in supersonic shock-wave/turbulent boundary-layer interactions with separation

2010 ◽  
Vol 114 (1155) ◽  
pp. 299-308 ◽  
Author(s):  
D. Estruch ◽  
D. G. MacManus ◽  
D. P. Richardson ◽  
N. J. Lawson ◽  
K. P. Garry ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Shock Wave ◽  
Turbulent Boundary Layer ◽  
High Speed ◽  
Low Frequency ◽  
Fast Response ◽  
Recirculation Region ◽  
Supersonic Wind Tunnel ◽  
Supersonic Shock ◽  
Fluctuation Energy

AbstractShock-wave/turbulent boundary-layer interactions (SWTBLIs) with separation are known to be inherently unsteady but their physical mechanisms are still not totally understood. An experimental investigation has been performed in a supersonic wind tunnel at a freestream flow Mach number of 2·42. The interaction between a shock wave created by a shock generator (α = 3°, α = 9°, α = 13° and α = 15° deflection angles) and a turbulent boundary layer with thickness δ = 5mm has been studied. High-speed Schlieren visualisations have been obtained and used to measure shock wave unsteadiness by means of digital image processing. In the interactions with separation, the reflected shock’s unsteadiness has been in the order of 102Hz. High-speed wall pressure measurements have also been obtained with fast-response micro-transducers along the interactions. Most of the energy of the incoming turbulent boundary layer is broadband and at high frequencies (>104Hz). An addition of low-frequency (<104Hz) fluctuation energy is found at separation. Along the interaction region, the shock impingement results in an amplification of fluctuation energy due to the increase in pressure. Under the main recirculation region core there is only an increase in high frequency energy (>104Hz). Amplification of lower frequency fluctuation energy (>103Hz) is also observed close to the separation and reattachment regions.

The Three-Dimensional Interaction of a Shock Wave with a Turbulent Boundary Layer

1966 ◽  
Vol 17 (3) ◽  
pp. 231-252 ◽  
Author(s):  
A. McCabe
Keyword(s):  
Boundary Layer ◽  
Shock Wave ◽  
Turbulent Boundary Layer ◽  
Reasonable Agreement ◽  
Three Dimensional ◽  
Side Wall ◽  
Approximate Theory ◽  
Streamwise Vorticity ◽  
Supersonic Wind Tunnel ◽  
Dimensional Interaction

SummaryExperiments are described on the interaction of the shock wave generated by a wedge in a supersonic wind tunnel with the turbulent boundary layer on the side wall. It is shown that the onset of separation appears to be largely affected by the action of streamwise vorticity in the interaction region. A simple approximate theory based on this concept shows reasonable agreement with the experimental results. Comparisons have been made with two-dimensional interactions of normal shocks and boundary layers, but they did not produce any conclusive results.

Three-dimensional instantaneous structure of a shock wave/turbulent boundary layer interaction

2009 ◽  
Vol 622 ◽  
pp. 33-62 ◽  
Author(s):  
R. A. HUMBLE ◽  
G. E. ELSINGA ◽  
F. SCARANO ◽  
B. W. van OUDHEUSDEN
Keyword(s):  
Boundary Layer ◽  
Shock Wave ◽  
Turbulent Boundary Layer ◽  
High Speed ◽  
Large Scale ◽  
Three Dimensional ◽  
Reflected Shock Wave ◽  
Layer Interaction ◽  
Reflected Shock ◽  
Boundary Layer Interaction

An experimental study is carried out to investigate the three-dimensional instantaneous structure of an incident shock wave/turbulent boundary layer interaction at Mach 2.1 using tomographic particle image velocimetry. Large-scale coherent motions within the incoming boundary layer are observed, in the form of three-dimensional streamwise-elongated regions of relatively low- and high-speed fluid, similar to what has been reported in other supersonic boundary layers. Three-dimensional vortical structures are found to be associated with the low-speed regions, in a way that can be explained by the hairpin packet model. The instantaneous reflected shock wave pattern is observed to conform to the low- and high-speed regions as they enter the interaction, and its organization may be qualitatively decomposed into streamwise translation and spanwise rippling patterns, in agreement with what has been observed in direct numerical simulations. The results are used to construct a conceptual model of the three-dimensional unsteady flow organization of the interaction.

Unsteady effects of strong shock-wave/boundary-layer interaction at high Reynolds number

2017 ◽  
Vol 823 ◽  
pp. 617-657 ◽  
Author(s):  
Vito Pasquariello ◽  
Stefan Hickel ◽  
Nikolaus A. Adams
Keyword(s):  
Boundary Layer ◽  
Shock Wave ◽  
Reynolds Number ◽  
Turbulent Boundary Layer ◽  
High Reynolds Number ◽  
Separation Bubble ◽  
Low Frequency ◽  
Boundary Layer Interaction ◽  
High Reynolds ◽  
Unsteady Effects

We analyse the low-frequency dynamics of a high Reynolds number impinging shock-wave/turbulent boundary-layer interaction (SWBLI) with strong mean-flow separation. The flow configuration for our grid-converged large-eddy simulations (LES) reproduces recent experiments for the interaction of a Mach 3 turbulent boundary layer with an impinging shock that nominally deflects the incoming flow by $19.6^{\circ }$. The Reynolds number based on the incoming boundary-layer thickness of $Re_{\unicode[STIX]{x1D6FF}_{0}}\approx 203\times 10^{3}$ is considerably higher than in previous LES studies. The very long integration time of $3805\unicode[STIX]{x1D6FF}_{0}/U_{0}$ allows for an accurate analysis of low-frequency unsteady effects. Experimental wall-pressure measurements are in good agreement with the LES data. Both datasets exhibit the distinct plateau within the separated-flow region of a strong SWBLI. The filtered three-dimensional flow field shows clear evidence of counter-rotating streamwise vortices originating in the proximity of the bubble apex. Contrary to previous numerical results on compression ramp configurations, these Görtler-like vortices are not fixed at a specific spanwise position, but rather undergo a slow motion coupled to the separation-bubble dynamics. Consistent with experimental data, power spectral densities (PSD) of wall-pressure probes exhibit a broadband and very energetic low-frequency component associated with the separation-shock unsteadiness. Sparsity-promoting dynamic mode decompositions (SPDMD) for both spanwise-averaged data and wall-plane snapshots yield a classical and well-known low-frequency breathing mode of the separation bubble, as well as a medium-frequency shedding mode responsible for reflected and reattachment shock corrugation. SPDMD of the two-dimensional skin-friction coefficient further identifies streamwise streaks at low frequencies that cause large-scale flapping of the reattachment line. The PSD and SPDMD results of our impinging SWBLI support the theory that an intrinsic mechanism of the interaction zone is responsible for the low-frequency unsteadiness, in which Görtler-like vortices might be seen as a continuous (coherent) forcing for strong SWBLI.

scholarly journals Low-frequency dynamics in a shock-induced separated flow

2016 ◽  
Vol 807 ◽  
pp. 441-477 ◽  
Author(s):  
Stephan Priebe ◽  
Jonathan H. Tu ◽  
Clarence W. Rowley ◽  
M. Pino Martín
Keyword(s):  
Boundary Layer ◽  
Shock Wave ◽  
Turbulent Boundary Layer ◽  
Low Frequency ◽  
Dynamic Mode Decomposition ◽  
Dynamic Mode ◽  
High Momentum ◽  
Mean Flow ◽  
Linear Superposition ◽  
Downstream Flow

The low-frequency unsteadiness in the direct numerical simulation of a Mach 2.9 shock wave/turbulent boundary layer interaction with mean flow separation is analysed using dynamic mode decomposition (DMD). The analysis is applied both to three-dimensional and spanwise-averaged snapshots of the flow. The observed low-frequency DMD modes all share a common structure, characterized by perturbations along the shock, together with streamwise-elongated regions of low and high momentum that originate at the shock foot and extend into the downstream flow. A linear superposition of these modes, with dynamics governed by their corresponding DMD eigenvalues, accurately captures the unsteadiness of the shock. In addition, DMD analysis shows that the downstream regions of low and high momentum are unsteady and that their unsteadiness is linked to the unsteadiness of the shock. The observed flow structures in the downstream flow are reminiscent of Görtler-like vortices that are present in this type of flow due to an underlying centrifugal instability, suggesting a possible physical mechanism for the low-frequency unsteadiness in shock wave/turbulent boundary layer interactions.

scholarly journals Separated shear layer effect on shock-wave/turbulent-boundary-layer interaction unsteadiness

2018 ◽  
Vol 848 ◽  
pp. 154-192 ◽  
Author(s):  
David Estruch-Samper ◽  
Gaurav Chandola
Keyword(s):  
Boundary Layer ◽  
Shock Wave ◽  
Turbulent Boundary Layer ◽  
Shear Layer ◽  
Low Frequency ◽  
Separated Flow ◽  
Layer Interaction ◽  
Separation Shock ◽  
Separated Shear Layer ◽  
Boundary Layer Interaction

This paper presents an experimental study on shock-wave/turbulent-boundary-layer interaction unsteadiness and delves specifically into the shear layer’s role. A range of axisymmetric step-induced interactions is investigated and the scale of separation is altered by over an order of magnitude – mass in the recirculation by two orders – while subjected to constant separation-shock strength. The effect of the separated shear layer on interaction unsteadiness is thus isolated and its kinematics are characterised. Results point at a mechanism whereby the depletion of separated flow is dictated by the state of the large eddy structures at their departure from the bubble. Low-frequency pulsations are found to adjust in response and sustain a reconciling view of an entrainment–recharge process, with both an inherent effect of the upstream boundary layer on shear layer inception and an increase in the mass locally acquired by eddies as they develop downstream.

Low-frequency unsteadiness of swept shock-wave/turbulent-boundary-layer interaction

2018 ◽  
Vol 856 ◽  
pp. 797-821 ◽  
Author(s):  
Xin Huang ◽  
David Estruch-Samper
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
High Speed ◽  
Reverse Flow ◽  
Pressure Fluctuations ◽  
Low Frequency ◽  
Boundary Layer Separation ◽  
Frequency Instability ◽  
Pulsation Frequency ◽  
Wall Pressure Fluctuations

High-speed turbulent boundary-layer separation can lead to severe wall-pressure fluctuations, often extending over a swept shock region. Having noted the shear layer’s influence within axisymmetric step flows, tests go on to experimentally assess the unsteadiness of a canonical swept separation, caused by a slanted $90^{\circ }$-step discontinuity (with varying azimuthal height) over an axisymmetric turbulent boundary layer. Results document an increase in shock pulsation frequency along the swept separation region ($\unicode[STIX]{x1D6EC}\leqslant 30^{\circ }$ sweep angles) – whereby the recirculation enables downstream feedback via the reverse flow – as the local streamwise separation length is reduced. A link between the spanwise variation in the separation shock’s low-frequency instability and the downstream mass ejection rate, as large shear-layer eddies leave the bubble, is sustained. The local entrainment-recharge dynamics of swept separation are thereby duly evaluated.

Sign in / Sign up

Export Citation Format

Share Document