The Supersonic Flow Past a Slender Ducted Body of Revolution with an Annular Intake

1950 ◽  
Vol 1 (4) ◽  
pp. 305-318
Author(s):  
G. N. Ward

SummaryThe approximate supersonic flow past a slender ducted body of revolution having an annular intake is determined by using the Heaviside operational calculus applied to the linearised equation for the velocity potential. It is assumed that the external and internal flows are independent. The pressures on the body are integrated to find the drag, lift and moment coefficients of the external forces. The lift and moment coefficients have the same values as for a slender body of revolution without an intake, but the formula for the drag has extra terms given in equations (32) and (56). Under extra assumptions, the lift force due to the internal pressures is estimated. The results are applicable to propulsive ducts working under the specified condition of no “ spill-over “ at the intake.

1953 ◽  
Vol 4 (3) ◽  
pp. 287-314 ◽  
Author(s):  
W. Chester

SummaryThe supersonic flow past a combination of a thin wing and a slender body of revolution is discussed by means of the linearised equation of motion. The exact equation is first established so that the linearised solution can be fed back and the order of the error terms calculated. The theory holds under quite general conditions which should be realised in practice.The wing-body combination considered consists of a wing symmetrically situated on a pointed body of revolution and satisfying the following fairly general conditions. The wing leading edge is supersonic at the root, and the body is approximately cylindrical downstream of the leading edge. The body radius is of an order larger than the wing thickness, but is small compared with the chord or span of the wing.It is found that if the wing and body are at the same incidence, and the aspect ratio of the wing is greater than 2 (M2-1)-½, where M is the main stream Mach number, the lift is equivalent to that of the complete wing when isolated. If the wing only is at incidence then the lift is equivalent to that of the part of the wing lying outside the body.The presence of the body has a more significant effect on the drag. If, for example, the body is an infinite cylinder of radius a, and the wing is rectangular with aspect ratio greater than 2(M2-1)-½, then the drag of the wing is decreased by a factor (1-2a/b), where 2b is the span of the wing.When these conditions do not hold the results are not quite so simple but are by no means complicated.


1951 ◽  
Vol 3 (1) ◽  
pp. 61-79 ◽  
Author(s):  
P. M. Stocker

SummaryThe method developed by G. N. Ward for the treatment of slender pointed bodies in a uniform supersonic stream is applied to three special cases. (i)Supersonic flow past a body of revolution with thin wings of symmetrical section and of small aspect ratio at zero incidence.(ii)Supersonic flow past a body of revolution with plane wings of small aspect ratio set at incidence to the body, the whole being at incidence to the stream.(iii)Supersonic flow past a body of revolution with a plane fin of small aspect ratio set at incidence, the whole being at incidence to the stream.The pressure distribution on the wing has been calculated for a special case of (i) and is given in the Appendix.


1976 ◽  
Vol 78 (3) ◽  
pp. 577-600 ◽  
Author(s):  
James Geer

The complete uniform asymptotic expansion of the velocity and pressure fields for Stokes flow past a slender body of revolution is obtained with respect to the slenderness ratio ε of the body. A completely general incident Stokes flow is assumed and hence these results extend the special cases treated by Tillett (1970) and Cox (1970). The part of the flow due to the presence of the body is represented as a superposition of the flows produced by three types of singularity distributed with unknown densities along a portion of the axis of the body and lying entirely inside the body. The no-slip boundary condition on the body then leads to a system of three coupled, linear, integral equations for the densities of the singularities. The complete expansion for these densities is then found as a series in powers of ε and ε log ε. It is found that the extent of these distributions of singularities inside the body is the same for all the singular flows and depends only upon the geometry of the body. The total force, drag and torque experienced by the body are computed.


A theory is developed of the supersonic flow past a body of revolution at large distances from the axis, where a linearized approximation is valueless owing to the divergence of the characteristics at infinity. It is used to find the asymptotic forms of the equations of the shocks which are formed from the neighbourhoods of the nose and tail. In the special case of a slender pointed body, the general theory at large distances is used to modify the linearized approximation to give a theory which is uniformly valid at all distances from the axis. The results which are of physical importance are summarized in the conclusion (§ 9) and compared with the results of experimental observations.


1988 ◽  
Vol 22 (5) ◽  
pp. 743-746 ◽  
Author(s):  
V. F. Zakharchenko ◽  
Yu. Kh. Kardanov ◽  
P. V. Sidorov

2008 ◽  
Vol 131 (1) ◽  
Author(s):  
Q. X. Wang ◽  
S. K. Tan

A slender body of revolution berthing to a wall is studied by extending the classical slender body theory. This topic is of practical importance for a ship berthing to a quay wall. The flow problem is solved analytically using the method of matched asymptotic expansions. The lateral force and yaw moment on the body are obtained in a closed form too. The translation and yawing of the body are modeled using the second Newton law and coupled with the flow induced. Numerical analyses are performed for the dynamic lateral translation and yawing of a slender spheroid, while its horizontal translation parallel to the wall is prescribed at zero speed, constant speed, and time varying speed, respectively. The analysis reveals the interesting dynamic features of the translation and yawing of the body in terms of the forward speed and starting angle of yaw of the body.


2020 ◽  
Vol 34 (14n16) ◽  
pp. 2040089
Author(s):  
Yiding Zhu

This paper describes an experimental investigation of the initial growth of flow asymmetries over a slender body of revolution at high angles of attack with natural and disturbed noses. Time-resolved particle image velocimetry (PIV) is used to investigate the flow field around the body. Flow visualization clearly shows the formation of the asymmetric vortices. Instantaneous PIV shows that the amplified asymmetric disturbances lead to Kelvin–Helmholtz instability appearing first on one side, which increases the momentum exchange crossing the layer. As a result, the separation region shrinks which creates the initial vortex asymmetry.


1956 ◽  
Vol 1 (3) ◽  
pp. 290-318 ◽  
Author(s):  
G. B. Whitham

A method is presented for treating problems of the propagation and ultimate decay of the shocks produced by explosions and by bodies in supersonic flight. The theory is restricted to weak shocks, but is of quite general application within that limitation. In the author's earlier work on this subject (Whitham 1952), only problems having directional symmetry were considered; thus, steady supersonic flow past an axisymmetrical body was a typical example. The present paper extends the method to problems lacking such symmetry. The main step required in the extension is described in the introduction and the general theory is completed in §2; the remainder of the paper is devoted to applications of the theory in specific cases.First, in §3, the problem of the outward propagation of spherical shocks is reconsidered since it provides the simplest illustration of the ideas developed in §2. Then, in §4, the theory is applied to a model of an unsymmetrical explosion. In §5, a brief outline is given of the theory developed by Rao (1956) for the application to a supersonic projectile moving with varying speed and direction. Examples of steady supersonic flow past unsymmetrical bodies are discussed in §6 and 7. The first is the flow past a flat plate delta wing at small incidence to the stream, with leading edges swept inside the Mach cone; the results agree with those previously found by Lighthill (1949) in his work on shocks in cone field problems, and this provides a valuable check on the theory. The second application in steady supersonic flow is to the problem of a thin wing having a finite curved leading edge. It is found that in any given direction the shock from the leading edge ultimately decays exactly as for the bow shock on a body of revolution; the equivalent body of revolution for any direction is determined in terms of the thickness distribution of the wing and varies with the direction chosen. Finally in §8, the wave drag on the wing is calculated from the rate of dissipation of energy by the shocks. The drag is found to be the mean of the drags on the equivalent bodies of revolution for the different directions.


1977 ◽  
Vol 79 (3) ◽  
pp. 499-524 ◽  
Author(s):  
J. F. Clarke ◽  
Y. L. Sinai

The results of the linear theory for the flow of a supersonic relaxing gas past a slender body of revolution are analysed in regions where its predictions of wavelet position begin to break down. In this way new variable systems can be found which make it possible to discuss the correct nonlinear wave behaviour far from the body. The situation depends upon three especially important parameters, namely the thickness ratio ε of the body, the ratio δ of relaxing-mode energy to thermal energy and the ratio λ of a relaxation length to a typical body length. After establishing general results from the linear theory, the conical body is treated in some detail. This makes it possible to demote λ as an important parameter, although its restoration does prove useful at one point in the analysis, and results are derived for shock-wave behaviour when ord 1 [ges ] δ > ord ε4, δ = ord ε4and δ < ord ε4. In the first range of δ fully dispersed waves are essential, although they are fully established only at great distances from the cone; in the second range of δ partly dispersed waves seem to be the most likely to appear, and in the third range relaxation effects are second-order modifications of a basically frozen-flow field. Practical situations may well fall into the first of these categories.


1976 ◽  
Vol 76 (1) ◽  
pp. 1-16 ◽  
Author(s):  
Francis R. Hama ◽  
Leigh F. Peterson

At the body-diameter Reynolds number 2000, the axisymmetric wake behind a slender streamlined body of revolution remained laminar without any indication of breakup far beyond the five-body-lengths test section. The mean-velocity profiles were measured with close spacings in order to obtain experimental information on the transient process from boundary layer to fully developed wake. A semi-empirical theory was developed to describe the flow-field characteristics.


Sign in / Sign up

Export Citation Format

Share Document