The South Wales Coalfield: low grade metamorphism in a foreland basin setting?

1996 ◽  
Vol 133 (06) ◽  
pp. 739 ◽  
Author(s):  
R. E. Bevins ◽  
S. C. White ◽  
D. Robinson
2000 ◽  
Vol 69-70 ◽  
pp. 581-584 ◽  
Author(s):  
M Davidson ◽  
J Egger ◽  
R.D Elmore ◽  
M Engel ◽  
S Woods ◽  
...  

1978 ◽  
Vol 15 (4) ◽  
pp. 480-500 ◽  
Author(s):  
Carl M. Lesher

The Proterozoic Sokoman Iron Formation near Ardua Lake, Quebec at the western edge of the Labrador Trough has undergone considerable diagenetic changes but probable only very low-grade metamorphic conditions. Locally, intense folding and thrust faulting are present. Comparisons have been made with the well-established stratigraphy of the relatively undeformed Sokoman Iron Formation in the Howells River area, 65 km along strike to the south of Ardua Lake.Representative assemblages for some of the members are as follows: quartz–chamosite–siderite–ankerite–K–spar–graphite±biotite±stilpnomelane (Ruth shale); chert–magnetite–siderite–talc±ankerite±stilpnomelane (Lower Iron Formation); chert–hematite–magnetite–talc–dolomite±riebeckite (Lower Red Cherty –Pink Grey Cherty); and chert–dolomite–magnetite–stilpnomelane±albite±hematite (Lean Chert). Although the assemblages may be strongly recrystallized, many of the original, sedimentary textural features and mineralogy have been preserved. Chert (and recrystallized quartz), hematite, magnetite, carbonates (calcite, manganoan siderite and manganoan dolomite) and possibly stilpnomelane are considered to be the recrystallization products of sedimentary precursors. Albite, chlorite and riebeckite are considered to be authigenic or diagenetic in origin; only biotite and members of the talc–minnesotaite series are considered to be reaction products of late diagenesis and subsequent very low-grade metamorphism.


Author(s):  
I. Statham ◽  
C. Golightly ◽  
G. Treharne

AbstractThe Department of the Environment and the Welsh Office jointly sponsored a South Wales Desk Study into the feasibility of producing thematic maps of the Mining subsidence risk for planners. A method was to be developed and tested for a 25 km2 Pilot Area centred on Ebbw Vale.The study was started by collecting geological and mining data for the Pilot Area and compiling this information on a map. It was then intended to prepare the mining subsidence map from this map by back analysing subsidence incidents to determine the hazardous areas. This simple approach could not be followed for two reasons. First, the record of mining was incomplete and it was therefore necessary to define ‘worked’ seams and areas from the total historical record and not only from the surviving mine plans. Secondly, insufficient subsidence incidents were discovered in the Pilot Area to carry out meaningful back analysis.The study was extended to collect all readily available records of subsidence incidents throughout the Coalfield. A total of 388 were traced, mainly dating from 1960. About threequarters were collapses through superficial materials and were either close to the outcrop or above mine entries, the remaining 25% propagated to the ground surface through rock. The upper limit of migration was typically 8 times the extracted height where the dip was shallow, incrasing to as much as 18 times for steep dips. Selected grout contracts and opencast mining sites were also examined to gain information on the present condition of old workings and to study the ‘reputations’ of the various seams for voids.The results of the coalfield study were applied to the Pilot Area to produce a 1:10 000 scale Development Advice Map, ‘Mining Subsidence for use by developers and planners’. The map is zoned to show areas where specialist advice is necessary to support a planning application and it also shows all mine entries traced by the desk study. The method of production is general for the South Wales Coalfield and further maps could be prepared, using the Coalfield Study, quickly and cheaply.


Sign in / Sign up

Export Citation Format

Share Document