Turbulence statistics in fully developed channel flow at low Reynolds number

1987 ◽  
Vol 177 ◽  
pp. 133-166 ◽  
Author(s):  
John Kim ◽  
Parviz Moin ◽  
Robert Moser
Keyword(s):  
Experimental Data ◽  
Reynolds Number ◽  
Channel Flow ◽  
Stokes Equations ◽  
Turbulent Channel Flow ◽  
Navier Stokes ◽  
Turbulence Statistics ◽  
Navier Stokes Equations ◽  
Statistical Correlations ◽  
Grid Points

A direct numerical simulation of a turbulent channel flow is performed. The unsteady Navier-Stokes equations are solved numerically at a Reynolds number of 3300, based on the mean centreline velocity and channel half-width, with about 4 × 106 grid points (192 × 129 × 160 in x, y, z). All essential turbulence scales are resolved on the computational grid and no subgrid model is used. A large number of turbulence statistics are computed and compared with the existing experimental data at comparable Reynolds numbers. Agreements as well as discrepancies are discussed in detail. Particular attention is given to the behaviour of turbulence correlations near the wall. In addition, a number of statistical correlations which are complementary to the existing experimental data are reported for the first time.

Four-dimensional turbulence in a plane channel

2011 ◽  
Vol 680 ◽  
pp. 67-79 ◽  
Author(s):  
NIKOLAY NIKITIN
Keyword(s):  
Reynolds Number ◽  
Channel Flow ◽  
Stokes Equations ◽  
Plane Channel ◽  
Turbulent Channel Flow ◽  
Reynolds Numbers ◽  
Wall Friction ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Number Range

The four-dimensional (4D) incompressible Navier–Stokes equations are solved numerically for the plane channel geometry. The fourth spatial coordinate is introduced formally to be homogeneous and mathematically orthogonal to the others, similar to the spanwise coordinate. Exponential growth of small 4D perturbations superimposed onto 3D turbulent solutions was observed in the Reynolds number range from Re = 4000 to Re = 10000. The growth rate of small 4D perturbations expressed in wall units was found to be λ+4D = 0.016 independent of Reynolds number. Nonlinear evolution of 4D perturbations leads either to attenuation of turbulence and relaminarization or to establishment of a self-sustained 4D turbulent solution (4D turbulent flow). Both results on flow evolution were obtained at the lowest Reynolds number, depending on the grid resolution, pointing to the proximity of Re = 4000 as the critical Reynolds number for 4D turbulence. Self-sustained 4D turbulence appeared to be less intense compared with 3D turbulence in terms of mean wall friction, which is about 55% of that predicted by the empirical Dean law for turbulent channel flow at all Reynolds numbers considered. Thus, the law of resistance of 4D turbulent channel flow can be expressed as Cf = 0.04Re−0.25.

Burgers turbulence model for a channel flow

1971 ◽  
Vol 47 (2) ◽  
pp. 321-335 ◽  
Author(s):  
Jon Lee
Keyword(s):  
Channel Flow ◽  
Stokes Equations ◽  
Turbulent Channel Flow ◽  
Reynolds Numbers ◽  
Navier Stokes ◽  
Amplitude Equations ◽  
Fourier Amplitude ◽  
Navier Stokes Equations ◽  
Burgers Model ◽  
Model Dynamics

The truncated Burgers models have a unique equilibrium state which is defined continuously for all the Reynolds numbers and attainable from a realizable class of initial disturbances. Hence, they represent a sequence of convergent approximations to the original (untruncated) Burgers problem. We have pointed out that consideration of certain degenerate equilibrium states can lead to the successive turbulence-turbulence transitions and finite-jump transitions that were suggested by Case & Chiu. As a prototype of the Navier–Stokes equations, Burgers model can simulate the initial-value type of numerical integration of the Fourier amplitude equations for a turbulent channel flow. Thus, the Burgers model dynamics display certain idiosyncrasies of the actual channel flow problem described by a truncated set of Fourier amplitude equations, which includes only a modest number of modes due to the limited capability of the computer at hand.

scholarly journals A Code for Simulating Heat Transfer in Turbulent Channel Flow

Mathematics ◽  
2021 ◽  
Vol 9 (7) ◽  
pp. 756
Author(s):  
Federico Lluesma-Rodríguez ◽  
Francisco Álcantara-Ávila ◽  
María Jezabel Pérez-Quiles ◽  
Sergio Hoyas
Keyword(s):  
Heat Transfer ◽  
Stokes Equations ◽  
Three Dimensional ◽  
Turbulent Channel Flow ◽  
Passive Scalar ◽  
Direct Numerical Simulations ◽  
Time Dependent ◽  
Navier Stokes ◽  
Thermal Flow ◽  
Navier Stokes Equations

One numerical method was designed to solve the time-dependent, three-dimensional, incompressible Navier–Stokes equations in turbulent thermal channel flows. Its originality lies in the use of several well-known methods to discretize the problem and its parallel nature. Vorticy-Laplacian of velocity formulation has been used, so pressure has been removed from the system. Heat is modeled as a passive scalar. Any other quantity modeled as passive scalar can be very easily studied, including several of them at the same time. These methods have been successfully used for extensive direct numerical simulations of passive thermal flow for several boundary conditions.

A note on the solution of the Navier-Stokes equations for a spherically symmetric expansion into a very low pressure

1973 ◽  
Vol 59 (2) ◽  
pp. 391-396 ◽  
Author(s):  
N. C. Freeman ◽  
S. Kumar
Keyword(s):  
Shock Wave ◽  
Reynolds Number ◽  
Stokes Equation ◽  
Stokes Equations ◽  
Low Pressure ◽  
Navier Stokes ◽  
Spherically Symmetric ◽  
Navier Stokes Equation ◽  
Navier Stokes Equations ◽  
Type Flow

It is shown that, for a spherically symmetric expansion of a gas into a low pressure, the shock wave with area change region discussed earlier (Freeman & Kumar 1972) can be further divided into two parts. For the Navier–Stokes equation, these are a region in which the asymptotic zero-pressure behaviour predicted by Ladyzhenskii is achieved followed further downstream by a transition to subsonic-type flow. The distance of this final region downstream is of order (pressure)−2/3 × (Reynolds number)−1/3.

Simulation of the Gap Resonance Between Two Rectangular Barges in Regular Waves by a Free Surface Viscous Flow Solver

2013 ◽  
Author(s):  
B. Elie ◽  
G. Reliquet ◽  
P.-E. Guillerm ◽  
O. Thilleul ◽  
P. Ferrant ◽  
...  
Keyword(s):  
Experimental Data ◽  
Free Surface ◽  
Viscous Flow ◽  
Stokes Equations ◽  
Resonance Phenomenon ◽  
Navier Stokes ◽  
Regular Waves ◽  
Navier Stokes Equations ◽  
Flow Solver ◽  
Gap Resonance

This paper compares numerical and experimental results in the study of the resonance phenomenon which appears between two side-by-side fixed barges for different sea-states. Simulations were performed using SWENSE (Spectral Wave Explicit Navier-Stokes Equations) approach and results are compared with experimental data on two fixed barges with different headings and bilges. Numerical results, obtained using the SWENSE approach, are able to predict both the frequency and the magnitude of the RAO functions.

Free-stream coherent structures in parallel boundary-layer flows

2014 ◽  
Vol 752 ◽  
pp. 602-625 ◽  
Author(s):  
Kengo Deguchi ◽  
Philip Hall
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Coherent Structures ◽  
Free Stream ◽  
Stokes Equations ◽  
Navier Stokes ◽  
Homotopy Continuation ◽  
Boundary Layer Flows ◽  
Navier Stokes Equations ◽  
High Reynolds

AbstractOur concern in this paper is with high-Reynolds-number nonlinear equilibrium solutions of the Navier–Stokes equations for boundary-layer flows. Here we consider the asymptotic suction boundary layer (ASBL) which we take as a prototype parallel boundary layer. Solutions of the equations of motion are obtained using a homotopy continuation from two known types of solutions for plane Couette flow. At high Reynolds numbers, it is shown that the first type of solution takes the form of a vortex–wave interaction (VWI) state, see Hall & Smith (J. Fluid Mech., vol. 227, 1991, pp. 641–666), and is located in the main part of the boundary layer. On the other hand, here the second type is found to support an equilibrium solution of the unit-Reynolds-number Navier–Stokes equations in a layer located a distance of $\def \xmlpi #1{}\def \mathsfbi #1{\boldsymbol {\mathsf {#1}}}\let \le =\leqslant \let \leq =\leqslant \let \ge =\geqslant \let \geq =\geqslant \def \Pr {\mathit {Pr}}\def \Fr {\mathit {Fr}}\def \Rey {\mathit {Re}}O(\ln \mathit{Re})$ from the wall. Here $\mathit{Re}$ is the Reynolds number based on the free-stream speed and the unperturbed boundary-layer thickness. The streaky field produced by the interaction grows exponentially below the layer and takes its maximum size within the unperturbed boundary layer. The results suggest the possibility of two distinct types of streaky coherent structures existing, possibly simultaneously, in disturbed boundary layers.

scholarly journals Nonlinear amplification in hydrodynamic turbulence

2021 ◽  
Vol 930 ◽  
Author(s):  
Kartik P. Iyer ◽  
Katepalli R. Sreenivasan ◽  
P.K. Yeung
Keyword(s):  
Reynolds Number ◽  
Isotropic Turbulence ◽  
Stokes Equations ◽  
Three Dimensional ◽  
Reynolds Numbers ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Developed Turbulence ◽  
Advection Term ◽  
Nonlinear Amplification

Using direct numerical simulations performed on periodic cubes of various sizes, the largest being $8192^3$ , we examine the nonlinear advection term in the Navier–Stokes equations generating fully developed turbulence. We find significant dissipation even in flow regions where nonlinearity is locally absent. With increasing Reynolds number, the Navier–Stokes dynamics amplifies the nonlinearity in a global sense. This nonlinear amplification with increasing Reynolds number renders the vortex stretching mechanism more intermittent, with the global suppression of nonlinearity, reported previously, restricted to low Reynolds numbers. In regions where vortex stretching is absent, the angle and the ratio between the convective vorticity and solenoidal advection in three-dimensional isotropic turbulence are statistically similar to those in the two-dimensional case, despite the fundamental differences between them.

scholarly journals Numerical Simulation of Slip effect on Lid-Driven Cavity Flow Problem for High Reynolds Number: Vorticity – Stream Function Approach

2021 ◽  
Vol 8 (3) ◽  
pp. 418-424
Author(s):  
Syed Fazuruddin ◽  
Seelam Sreekanth ◽  
G. Sankara Sekhar Raju
Keyword(s):  
Reynolds Number ◽  
Stream Function ◽  
Stokes Equations ◽  
Cavity Flow ◽  
Partial Slip ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Driven Cavity ◽  
Slip Conditions ◽  
Driven Cavity Flow

Incompressible 2-D Navier-stokes equations for various values of Reynolds number with and without partial slip conditions are studied numerically. The Lid-Driven cavity (LDC) with uniform driven lid problem is employed with vorticity - Stream function (VSF) approach. The uniform mesh grid is used in finite difference approximation for solving the governing Navier-stokes equations and developed MATLAB code. The numerical method is validated with benchmark results. The present work is focused on the analysis of lid driven cavity flow of incompressible fluid with partial slip conditions (imposed on side walls of the cavity). The fluid flow patterns are studied with wide range of Reynolds number and slip parameters.

An Implicit Multigrid Scheme for the Compressible Navier-Stokes Equations With Low-Reynolds-Number Turbulence Closure

1998 ◽  
Vol 120 (2) ◽  
pp. 257-262 ◽  
Author(s):  
Peter Gerlinger ◽  
Dieter Bru¨ggemann
Keyword(s):  
Reynolds Number ◽  
Stokes Equations ◽  
Low Reynolds Number ◽  
Convergence Acceleration ◽  
Iterative Solvers ◽  
Turbulence Closure ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Low Reynolds ◽  
Turbulence Transport

A multigrid method for convergence acceleration is used for solving coupled fluid and turbulence transport equations. For turbulence closure a low-Reynolds-number q-ω turbulence model is employed, which requires very fine grids in the near wall regions. Due to the use of fine grids, convergence of most iterative solvers slows down, making the use of multigrid techniques especially attractive. However, special care has to be taken on the strong nonlinear turbulent source terms during restriction from fine to coarse grids. Due to the hyperbolic character of the governing equations in supersonic flows and the occurrence of shock waves, modifications to standard multigrid techniques are necessary. A simple and effective method is presented that enables the multigrid scheme to converge. A strong reduction in the required number of multigrid cycles and work units is achieved for different test cases, including a Mack 2 flow over a backward facing step.

Sign in / Sign up

Export Citation Format

Share Document