Characterization of δ-KZnPO4 by X-ray powder diffraction

2021 ◽  
pp. 1-5
Author(s):  
Peter G. Self ◽  
Mark D. Raven
Keyword(s):  
Low Temperature ◽  
Powder Diffraction ◽  
Structural Parameters ◽  
Rietveld Analysis ◽  
X Ray ◽  
Temperature Form

The structural parameters of a second low-temperature form of KZnPO4 have been refined using Rietveld analysis of X-ray powder diffraction (XRPD) data. This form of KZnPO4 is isostructural with NH4ZnPO4I and has previously been denoted as KZnPO4II. This article uses the notation δ-KZnPO4, to be consistent with the α, β, and γ notation commonly used for other KZnPO4 phases.

Structural characterization of two K2SnX(PO4)3 (X=Fe,Yb) with langbeinite structure

2006 ◽  
Vol 21 (3) ◽  
pp. 214-219 ◽  
Author(s):  
Abderrahim Aatiq ◽  
Btissame Haggouch ◽  
Rachid Bakri ◽  
Youssef Lakhdar ◽  
Ismael Saadoune
Keyword(s):  
Solid State ◽  
Powder Diffraction ◽  
Room Temperature ◽  
Cell Parameter ◽  
Rietveld Analysis ◽  
Conventional Solid State Reaction ◽  
X Ray ◽  
Octahedral Sites ◽  
Parameter Values

Structures of two K2SnX(PO4)3(X=Fe,Yb) phosphates, obtained by conventional solid state reaction techniques at 950 °C, were determined at room temperature by X-ray powder diffraction using Rietveld analysis. The two materials exhibit the langbeinite-type structure (P213 space group, Z=4). Cubic unit cell parameter values are: a=9.9217(4) Å and a=10.1583(4) Å for K2SnFe(PO4)3 and K2SnYb(PO4)3, respectively. Structural refinements show that the two crystallographically independent octahedral sites (of symmetry 3) have a mixed Sn∕X (X=Fe,Yb) population although ordering is stronger in the Yb phase than in the Fe phase.

Structure of TlSr2PrCu207−x by Rietveld analysis

1994 ◽  
Vol 9 (3) ◽  
pp. 194-199
Author(s):  
Hoong-Kun Fun ◽  
Ping Yang ◽  
Rusli Othman ◽  
Tsong-Jen Lee ◽  
Chiou-Chu Lai ◽  
...  
Keyword(s):  
Low Temperature ◽  
Crystalline Structure ◽  
Powder Diffraction ◽  
Room Temperature ◽  
Goodness Of Fit ◽  
Rietveld Analysis ◽  
Crystal Data ◽  
X Ray ◽  
Tetragonal System

The crystalline structure of new TlSr2PrCu207−x was obtained at room temperature (300 K) and low temperature (100 K) from X-ray powder diffraction with CuKα radiation using Rietveld analysis. TlSr2PrCu207−x has an isotypical structure with TlBa2CaCu207 (1212). At 300 K, crystal data: Tl0.864Sr2PrCu2O6.75, Mr=727.811, the tetragonal system, P4/mmm, a =3.85404(5) Å, c = 12.1046(2) Å, V=179.80 Å3, Z=1, Dx =6.7218 g cm−3, μ =1143.922 cm−1 (λ = 1.54051 Å), F(000)=317.0, the structure was refined with 28 parameters to Rwp=5.29%, Rp = 3.65% for 3551 step intensities and Rb=7.40%, Rf=639% for 155 peaks, “goodness of fit” 5=3.05. At 100 K, crystal data: Tl0.858Sr2PrCu2O6.61, Mr=724.345, the tetragonal system, P4/mmm, a =3.84872(6) Å, c = 12.0771(3) Å, V=178.89 Å3, Z=1, Dx=6.7235 g cm−3, μ=1146.939 cm−1 (λ= 1.54051 Å), F(000) = 315.4, the structure was refined with 26 parameters to Rwp=6.70%, Rp=5.11% for 2926 step intensities and Rb=7.83%, Rf=6.70% for 131 peaks, “goodness of fit” S = 1.75.

Structural Characterization of Nickel Oxide

1991 ◽  
Vol 46 (6) ◽  
pp. 503-512 ◽  
Author(s):  
V. Massarotti ◽  
D. Capsoni ◽  
V. Berbenni ◽  
R. Riccardi ◽  
A. Marini ◽  
...  
Keyword(s):  
Powder Diffraction ◽  
Structural Parameters ◽  
Powder Diffraction Data ◽  
Lower Mass ◽  
X Ray ◽  
Low Mass ◽  
Refinement Procedure ◽  
Structural Characterizations ◽  
The Ideal

AbstractIt is known from the literature that a slight distortion of the ideal cubic cell is present in the NiO structure. This work shows that such a distortion can be accurately evaluated by means of a refinement of the structural and profile parameters of X-ray powder diffraction data. Moreover, since only small amounts of products are sometimes at disposal to perform structural characterizations, it was thought useful to extend the refinement procedure to X-ray data collected on NiO samples of much lower mass (15-60 mg) than those usually utilized in X-ray diffractometric studies. The results obtained show that reliable structural parameters can be obtained from low mass samples too

New horizons for the structural characterization of stainless steel slags by X-ray powder diffraction

2007 ◽  
Vol 2007 (suppl_26) ◽  
pp. 61-66 ◽  
Author(s):  
B. Peplinski ◽  
B. Adamczyk ◽  
G. Kley ◽  
K. Adam ◽  
F. Emmerling ◽  
...  
Keyword(s):  
Stainless Steel ◽  
Powder Diffraction ◽  
Structural Characterization ◽  
X Ray ◽  
New Horizons

Small angle X-ray scattering study of porosity variation in a styrene-divinylbenzene copolymer

1981 ◽  
Vol 46 (7) ◽  
pp. 1675-1681 ◽  
Author(s):  
Josef Baldrian ◽  
Božena N. Kolarz ◽  
Henrik Galina
Keyword(s):  
Small Angle ◽  
Structural Parameters ◽  
Two Phase ◽  
X Ray ◽  
Porosity Variation ◽  
Swelling Agent ◽  
X Ray Scattering ◽  
Styrene Divinylbenzene ◽  
Ray Scattering

Porosity variations induced by swelling agent exchange were studied in a styrene-divinylbenzene copolymer. Standard methods were used in the characterization of copolymer porosity in the dry state and the results were compared with related structural parameters derived from small angle X-ray scattering (SAXS) measurements as developed for the characterization of two-phase systems. The SAXS method was also used for porosity determination in swollen samples. The differences in the porosity of dry samples were found to be an effect of the drying process, while in the swollen state the sample swells and deswells isotropically.

The Application of X-Ray Diffraction at Elevated Temperatures to Study the Mechanism of Formation of Sodium Tripolyphosphate

1961 ◽  
Vol 5 ◽  
pp. 276-284
Author(s):  
E. L. Moore ◽  
J. S. Metcalf
Keyword(s):  
High Temperature ◽  
Low Temperature ◽  
Amorphous Phase ◽  
Elevated Temperatures ◽  
Sodium Tripolyphosphate ◽  
X Ray Diffraction ◽  
Mechanism Of Formation ◽  
X Ray ◽  
Temperature Form ◽  
High Temperature Form

AbstractHigh-temperature X-ray diffraction techniques were employed to study the condensation reactions which occur when sodium orthophosphates are heated to 380°C. Crystalline Na4P2O7 and an amorphous phase were formed first from an equimolar mixture of Na2HPO4·NaH2PO4 and Na2HPO4 at temperatures above 150°C. Further heating resulted in the formation of Na5P3O10-I (high-temperature form) at the expense of the crystalline Na4P4O7 and amorphous phase. Crystalline Na5P3O10-II (low-temperature form) appears after Na5P3O10-I.Conditions which affect the yield of crystalline Na4P2O7 and amorphous phase as intermediates and their effect on the yield of Na5P3O10 are also presented.

Distorted chiolite crystal structures of α-Na5M3F14 (M=Cr,Fe,Ga) studied by X-ray powder diffraction

2003 ◽  
Vol 18 (2) ◽  
pp. 128-134 ◽  
Author(s):  
A. Le Bail ◽  
A.-M. Mercier
Keyword(s):  
Crystal Structures ◽  
Powder Diffraction ◽  
Room Temperature ◽  
Rietveld Refinements ◽  
Space Group ◽  
X Ray ◽  
Precise Characterization

The crystal structures of the chiolite-related room temperature phases α-Na5M3F14 (MIII=Cr,Fe,Ga) are determined. For all of them, the space group is P21/n, Z=2; a=10.5096(3) Å, b=7.2253(2) Å, c=7.2713(2) Å, β=90.6753(7)° (M=Cr); a=10.4342(7) Å, b=7.3418(6) Å, c=7.4023(6) Å, β=90.799(5)° (M=Fe), and a=10.4052(1) Å, b=7.2251(1) Å, c=7.2689(1), β=90.6640(4)° (M=Ga). Rietveld refinements produce final RF factors 0.036, 0.033, and 0.035, and RWP factors, 0.125, 0.116, and 0.096, for MIII=Cr, Fe, and Ga, respectively. The MF6 polyhedra in the defective isolated perovskite-like layers deviate very few from perfect octahedra. Subtle octahedra tiltings lead to the symmetry decrease from the P4/mnc space group adopted by the Na5Al3F14 chiolite aristotype to the P21/n space group adopted by the title series. Facile twinning precluded till now the precise characterization of these compounds.

Sign in / Sign up

Export Citation Format

Share Document