Drag on a Sphere in Poiseuille Flow of Shear-Thinning Power-Law Fluids

2011 ◽  
Vol 50 (23) ◽  
pp. 13105-13115 ◽  
Author(s):  
Daoyun Song ◽  
Rakesh K. Gupta ◽  
Rajendra P. Chhabra
2014 ◽  
Vol 751 ◽  
pp. 184-215
Author(s):  
Liyan Yu ◽  
John Hinch

AbstractWe study the solitary wave solutions in a thin film of a power-law fluid coating a vertical fibre. Different behaviours are observed for shear-thickening and shear-thinning fluids. For shear-thickening fluids, the solitary waves are larger and faster when the reduced Bond number is smaller. For shear-thinning fluids, two branches of solutions exist for a certain range of the Bond number, where the solitary waves are larger and faster on one and smaller and slower on the other as the Bond number decreases. We carry out an asymptotic analysis for the large and fast-travelling solitary waves to explain how their speeds and amplitudes change with the Bond number. The analysis is then extended to examine the stability of the two branches of solutions for the shear-thinning fluids.


2013 ◽  
Vol 11 (1) ◽  
pp. 95-102 ◽  
Author(s):  
Sima Didari ◽  
Zakaria Y. Ahmad ◽  
James D. Veldhorst ◽  
Tequila A. L. Harris

Author(s):  
Ajay Raj Dwivedi ◽  
Amit Dhiman ◽  
Aniruddha Sanyal

Abstract The article examines the consequence of thermal buoyancy-driven cross-flow and heat transfer for shear-thinning power-law fluids on the tandem orientation of two cylinders. Finite volume methodology is used to investigate the effect of the gap ratio (2.5 ≤ S/D ≤ 5.5), power-law index (0.2 ≤ n ≤ 1) and Richardson number (0 ≤ Ri ≤ 1) on flow and thermal output parameters at Reynolds number Re ≤ 100 and Prandtl number Pr ≤ 50 in a confined channel. An unprecedented jump has been witnessed in the flow/thermal parameters at the critical gap ratio (critical spacing). At forced convection (Ri ≤ 0), this critical spacing keeps on increasing with shear-thinning character, from S/D = 3.9 (at n = 1) to 4.9 (at n = 0.2). On the contrary, an increase in shear-thinning characteristic leads to a decrease in critical spacing from S/D = 3.9 (at n = 1) to 2.8 (at n = 0.4) for Ri = 1 (mixed convection). The heat transfer rate increases with shear-thinning behavior, with a maximum heat transfer, noted at n = 0.2. A higher unprecedented increment for flow/thermal parameters is seen at critical spacing for the downstream cylinder than the upstream cylinder. At the highest gap ratio, the output parameters for the upstream cylinder approximate that of an isolated cylinder. The time-variant fluctuations in lift coefficients for a shear-thinning flow in a tandem arrangement provide a new understanding of co-shedding and extended body flow regimes.


2017 ◽  
Vol 826 ◽  
pp. 918-941 ◽  
Author(s):  
A. Bougouin ◽  
L. Lacaze ◽  
T. Bonometti

Experiments on the collapse of non-colloidal and neutrally buoyant particles suspended in a Newtonian fluid column are presented, in which the initial volume fraction of the suspension $\unicode[STIX]{x1D719}$, the viscosity of the interstitial fluid $\unicode[STIX]{x1D707}_{f}$, the diameter of the particles $d$ and the mixing protocol, i.e. the initial preparation of the suspension, are varied. The temporal evolution of the slumping current highlights two main regimes: (i) an inertial-dominated regime followed by (ii) a viscous-dominated regime. The inertial regime is characterized by a constant-speed slumping which is shown to scale as in the case of a classical inertial dam-break. The viscous-dominated regime is observed as a decreasing-speed phase of the front evolution. Lubrication models for Newtonian and power-law fluids describe most of situations encountered in this regime, which strongly depends on the suspension parameters. The temporal evolution of the propagating front is used to extract the rheological parameters of the fluid models. At the early stages of the viscous-dominated regime, a constant effective shear viscosity, referred to as an apparent Newtonian viscous regime, is found to depend only on $\unicode[STIX]{x1D719}$ and $\unicode[STIX]{x1D707}_{f}$ for each mixing protocol. The obtained values are shown to be well fitted by the Krieger–Dougherty model whose parameters involved, say a critical volume fraction $\unicode[STIX]{x1D719}_{m}$ and the exponent of divergence, depend on the mixing protocol, i.e. the microscale interaction between particles. On a longer time scale which depends on $\unicode[STIX]{x1D719}$, the front evolution is shown to slightly deviate from the apparent Newtonian model. In this apparent non-Newtonian viscous regime, the power-law model, indicating both shear-thinning and shear-thickening behaviours, is shown to be more appropriate to describe the front evolution. The present experiments indicate that the mixing protocol plays a crucial role in the selection of a shear-thinning or shear-thickening type of collapse, while the particle diameter $d$ and volume fraction $\unicode[STIX]{x1D719}$ play a significant role in the shear-thickening case. In all cases, the normalized effective consistency of the power-law fluid model is found to be a unique function of $\unicode[STIX]{x1D719}$. Finally, an apparent viscoplastic regime, characterized by a finite length spreading reached at finite time, is observed at high $\unicode[STIX]{x1D719}$. This regime is mostly observed for volume fractions larger than $\unicode[STIX]{x1D719}_{m}$ and up to a volume fraction $\unicode[STIX]{x1D719}_{M}$ close to the random close packing fraction at which the initial column remains undeformed on opening the gate.


Sign in / Sign up

Export Citation Format

Share Document