scholarly journals Synthesis, Optical Resolution, and Stereochemical Properties of a Rationally Designed Chiral C–N Palladacycle

2014 ◽  
Vol 33 (4) ◽  
pp. 930-940 ◽  
Author(s):  
Jeanette See Leng Yap ◽  
Houguang Jeremy Chen ◽  
Yongxin Li ◽  
Sumod A. Pullarkat ◽  
Pak-Hing Leung
Keyword(s):  
Optical Resolution ◽  
Stereochemical Properties

Synthesis of Axially Chiral 2,2’-Bisphosphobiarenes via a Nickel-Catalyzed Asymmetric Ullmann Coupling: General Access to Privileged Chiral Ligands without Optical Resolution

2020 ◽  
Author(s):  
Ziqing Zuo ◽  
Raphael Kim ◽  
Donald Watson
Keyword(s):  
Optical Resolution ◽  
Chiral Ligands ◽  
Chiral Auxiliaries ◽  
Axially Chiral ◽  
Ullmann Coupling

<div><p>We report an asymmetric Ullmann-type homocoupling of <i>ortho-</i>(iodo)arylphosphine oxides and <i>ortho</i>-(iodo)arylphosphonates that results in highly enantioenriched axially chiral bisphosphine oxides and bisphosphonates in good yields and excellent enantioselectivities. These products are readily converted to enantioenriched biaryl bisphosphines without need for chiral auxiliaries or optical resolution. This process provides a straightforward and practical route for the development of previously uninvestigated atroposelective biaryl bisphosphine ligands.</p></div>

Stereochemical properties of inulins

2020 ◽  
Vol 8 (14) ◽  
pp. 52-60
Author(s):  
Roman Grushetskiy ◽  
◽  
Iryna Grinenko ◽  
Liubomyr Khomichak ◽  
◽  
...  
Keyword(s):  
Stereochemical Properties

VLSI Design for Functional Failure Analysis in the < 90 nm and Flip-Chip Era

2003 ◽  
Author(s):  
Yoav Weizman ◽  
Ezra Baruch
Keyword(s):  
Failure Analysis ◽  
Flip Chip ◽  
Light Emission ◽  
Vlsi Design ◽  
Optical Resolution ◽  
Critical Issue ◽  
Acquisition Time ◽  
Resolution Limit ◽  
Design Rules ◽  
The Impact

Abstract In recent years, two new techniques were introduced for flip chip debug; the Laser Voltage Probing (LVP) technique and Time Resolved Light Emission Microscopy (TRLEM). Both techniques utilize the silicon’s relative transparency to wavelengths longer than the band gap. This inherent wavelength limitation, together with the shrinking dimensions of modern CMOS devices, limit the capabilities of these tools. It is known that the optical resolution limits of the LVP and TRLEM techniques are bounded by the diffraction limit which is ~1um for both tools using standard optics. This limitation was reduced with the addition of immersion lens optics. Nevertheless, even with this improvement, shrinking transistor geometry is leading to increased acquisition time, and the overlapping effect between adjacent nodes remains a critical issue. The resolution limit is an order of magnitude above the device feature densities in the &lt; 90nm era. The scaling down of transistor geometry is leading to the inevitable consequence where more than 50% of the transistors in 90nm process have widths smaller than 0.4um. The acquisition time of such nodes becomes unreasonably long. In order to examine nodes in a dense logic cuicuit, cross talk and convolution effects between neighboring signals also need to be considered. In this paper we will demonstrate the impact that these effects may have on modern design. In order to maintain the debug capability, with the currently available analytical tools for future technologies, conceptual modification of the FA process is required. This process should start on the IC design board where the VLSI designer should be familiar with FA constraints, and thus apply features that will enable enhanced FA capabilities to the circuit in hand during the electrical design or during the physical design stages. The necessity for reliable failure analysis in real-time should dictate that the designer of advanced VLSI blocks incorporates failure analysis constraints among other design rules. The purpose of this research is to supply the scientific basis for the optimal incorporation of design rules for optical probing in the &lt; 90nm gate era. Circuit designers are usually familiar with the nodes in the design which are critical for debug, and the type of measurement (logic or DC level) they require. The designer should enable the measurement of these signals by applying certain circuit and physical constraints. The implementation of these constraints may be done at the cell level, the block level or during the integration. We will discuss the solutions, which should be considered in order to mitigate tool limitations, and also to enable their use for next generation processes.

ChemInform Abstract: OPTICAL RESOLUTION OF TRIS(ACETYLACETONATO)ALUMINUM(III) BY LOW TEMPERATURE CHROMATOGRAPHY

1976 ◽  
Vol 7 (6) ◽  
pp. no-no
Author(s):  
BENGT NORDEN ◽  
IVAN JONAS
Keyword(s):  
Low Temperature ◽  
Optical Resolution

543. The optical resolution of (±)-trans-9 : 10-dihydroxy-9 : 10-dihydrophenanthrene

1950 ◽  
Vol 0 (0) ◽  
pp. 2808-2810 ◽  
Author(s):  
J. Booth ◽  
E. Boyland ◽  
E. E. Turner
Keyword(s):  
Optical Resolution

Optical resolution and reactivity of chiral tungsten alkyne complexes

1992 ◽  
Vol 114 (26) ◽  
pp. 10097-10103 ◽  
Author(s):  
J. L. Caldarelli ◽  
P. S. White ◽  
J. L. Templeton
Keyword(s):  
Optical Resolution ◽  
Alkyne Complexes

scholarly journals 3D phonon microscopy with sub-micron axial-resolution

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Richard J. Smith ◽  
Fernando Pérez-Cota ◽  
Leonel Marques ◽  
Matt Clark
Keyword(s):  
Signal To Noise Ratio ◽  
Single Cells ◽  
Optical Resolution ◽  
Acquisition Time ◽  
Label Free ◽  
Axial Resolution ◽  
Force Microscopy ◽  
Atomic Force ◽  
Accuracy And Precision ◽  
Good Agreement

AbstractBrillouin light scattering (BLS) is an emerging method for cell imaging and characterisation. It allows elasticity-related contrast, optical resolution and label-free operation. Phonon microscopy detects BLS from laser generated coherent phonon fields to offer an attractive route for imaging since, at GHz frequencies, the phonon wavelength is sub-optical. Using phonon fields to image single cells is challenging as the signal to noise ratio and acquisition time are often poor. However, recent advances in the instrumentation have enabled imaging of fixed and living cells. This work presents the first experimental characterisation of phonon-based axial resolution provided by the response to a sharp edge. The obtained axial resolution is up to 10 times higher than that of the optical system used to take the measurements. Validation of the results are obtained with various polymer objects, which are in good agreement with those obtained using atomic force microscopy. Edge localisation, and hence profilometry, of a phantom boundary is measured with accuracy and precision of approximately 60 nm and 100 nm respectively. Finally, 3D imaging of fixed cells in culture medium is demonstrated.

ChemInform Abstract: OPTICAL RESOLUTION STUDIES OF CYCLOPHOSPHAMIDE

1978 ◽  
Vol 9 (38) ◽  
Author(s):  
T. KAWASHIMA ◽  
R. D. KROSHEFSKY ◽  
R. A. KOK ◽  
J. G. VERKADE
Keyword(s):  
Optical Resolution
Sign in / Sign up

Export Citation Format

Share Document