Enhanced photocatalytic bacteriostatic activity towards Escherichia coli using 3D hierarchical microsphere BiOI/BiOBr under visible light irradiation

2016 ◽  
Vol 15 (5) ◽  
pp. 666-672 ◽  
Author(s):  
Ya Wang ◽  
Li Lin ◽  
Fang Li ◽  
Liang Chen ◽  
Donghui Chen ◽  
...  

With an improved separation efficiency of photogenerated holes, the BiOI/BiOBr composite exhibited enhanced photocatalytic bacteriostatic activity towards E. coli compared to the pure BiOI or BiOBr under visible light.

2020 ◽  
Vol 20 (6) ◽  
pp. 2216-2225
Author(s):  
Xiu-Feng Yin ◽  
Na Shi ◽  
Ting Meng ◽  
Ying-Xue Sun

Abstract This study investigated the simulated solar light disinfection of Escherichia coli CGMCC 1.1595, a multidrug-resistant (MDR) strain resistant to tetracycline and ampicillin. With the increase of light intensity, the maximum inactivation efficiency reached 0.74 log in 60 min following visible light irradiation with an intensity of 115.8 mW/cm2 and following UVA–visible light irradiation, using a 98% UVA-ray contribution at 6.5 mW/cm2 and 95% contribution at 20.0 mW/cm2, the inactivation efficiency was up to 6.09 log. The inactivated MDR E. coli did not regrow after light irradiation or in the dark after 24 or 48 h after visible light disinfection, demonstrating that visible light disinfection can prevent MDR E. coli self-repair. The MDR E. coli plasmid electrophoresis band gradually went dark with increase of the light irradiation time and could be completely eliminated by high UVA light intensity treatment, however, simulated sunlight irradiation had minimal influence on both tetracycline and ampicillin resistance of the MDR E. coli strain.


RSC Advances ◽  
2021 ◽  
Vol 11 (11) ◽  
pp. 6383-6394 ◽  
Author(s):  
Haishuai Li ◽  
Linlin Cai ◽  
Xin Wang ◽  
Huixian Shi

A noval ternary nanocomposite AgCl/Ag3PO4/g-C3N4 was successfully synthesized for photocatalytic degradation of methylene blue, methylparaben and inactivation of E. coli under visible light irradiation, showing excellent photocatalytic degradation performance and stability.


2017 ◽  
Vol 4 (11) ◽  
pp. 11671-11678
Author(s):  
M. Giridhar ◽  
H.S. BhojyaNaik ◽  
R. Vishwanath ◽  
C.N. Sudhamani ◽  
M.C. Prabakar ◽  
...  

2016 ◽  
Vol 52 (30) ◽  
pp. 5316-5319 ◽  
Author(s):  
Wenjie Fan ◽  
Haibo Li ◽  
Fengyi Zhao ◽  
Xujing Xiao ◽  
Yongchao Huang ◽  
...  

BiOI nanosheets with highly exposed (001) and surface disorders are used for efficient photocatalytic HCHO oxidation under visible light irradiation.


2019 ◽  
Vol 118 ◽  
pp. 01013 ◽  
Author(s):  
Wei Xiong ◽  
Altair T.F. Cheung ◽  
Michael K.H. Leung

In this article, the carbon doped TiO2 (C-TiO2) quantum dots (QDs) were prepared through the hydrothermal method and calcination. The size of the C-TiO2 QDs is about 5.7 nm. The doping amount of carbon can be tuned by adjusting the volumes of the carbon source, ethylene glycol added. The carbon atoms are proved to be doped into the interstitial sites of TiO2 lattice and induce the change of chemical states of Ti 2p and C 1s. The doping of carbon leads to the increasing photocatalytic sterilization of E. coli under the visible light irradiation. The survival rate of E. coli cells over C-TiO2 is only 1.5 % after 6 h. The reactive oxygen species (ROS), such as hydroxyl radical and superoxide radical, are considered as the primary factors for the photocatalytic sterilization. Due to oxidative stress of the attack by ROS, the enzyme activity per cells increases for self-protection during the photocatalytic sterilization.


2012 ◽  
Vol 91 ◽  
pp. 59-66 ◽  
Author(s):  
Linfei Zhu ◽  
Chun He ◽  
Yanling Huang ◽  
Zhuohua Chen ◽  
Dehua Xia ◽  
...  

2018 ◽  
Vol 14 (1-2) ◽  
pp. 159-163 ◽  
Author(s):  
Faisal Hussin ◽  
Hendrik Oktendy Lintang ◽  
Siew Ling Lee ◽  
Leny Yuliati

In order to utilize solar light in an efficient way, a good photocatalyst shall absorb both UV and visible light. In this study, a series of composite photocatalyst consisting of zinc oxide (ZnO) and carbon nitride (CN) was successfully prepared through a physical mixing method. The ZnO is an ultraviolet (UV)-based photocatalyst, while the CN is known as a visible light-driven photocatalyst. The effect of zinc to carbon mol ratio (Zn/C) towards the properties and photocatalytic activities was investigated. X-ray diffraction (XRD) patterns revealed that the prepared ZnO-CN composite photocatalysts composed of wurtzite ZnO and graphitic CN. The presence of ZnO and CN made the composites have absorption at both UV and visible region, suggesting the potential application as photocatalysts under both UV and visible light. Fluorescence studies revealed that all ZnO-CN composites showed emission peaks at 445 and 460 nm when excited at 273 nm, but with lower intensity as compared to those of the CN. The lower emission intensity suggested the role of ZnO to reduce the charge recombination and improve the charge separation on the CN. The ZnO-CN composites were further evaluated for photocatalytic degradation of phenol. The amount of degraded phenol was determined by a gas chromatography, in which a flame ionization detector was used in this study (GC-FID). The composite photocatalyst with an optimum content of 1% Zn/C gave almost 1.15 times higher activity than the CN under visible light irradiation. On the other hand, the composite photocatalyst with an optimum content of 50% Zn/C showed 2.6 times higher activity than the CN under UV light. The improved photocatalytic efficiency on the ZnO-CN composite photocatalysts was caused by the synergic effect between ZnO and CN. The ZnO would boost the separation efficiency of photogenerated electrons on the CN, while the CN would enable ZnO to absorb visible light region as the ZnO-CN composites. 


Sign in / Sign up

Export Citation Format

Share Document