scholarly journals Deep lower crustal earthquakes in central India: inferences from analysis of regional broadband data of the 1997 May 21, Jabalpur earthquake

2002 ◽  
Vol 148 (1) ◽  
pp. 132-138 ◽  
Author(s):  
N. P. Rao ◽  
T. Tsukuda ◽  
M. Kosuga ◽  
S. C. Bhatia ◽  
G. Suresh
2018 ◽  
Vol 9 (1) ◽  
Author(s):  
Feng Shi ◽  
Yanbin Wang ◽  
Tony Yu ◽  
Lupei Zhu ◽  
Junfeng Zhang ◽  
...  

2020 ◽  
Author(s):  
Xin Zhong ◽  
Arianne Petley-Ragan ◽  
Sarah Incel ◽  
Marcin Dabrowski ◽  
Niels Andersen ◽  
...  

<p>Earthquakes are among the most catastrophic geological events that last only several to tens of seconds. During earthquakes, many processes may occur including rupturing, frictional sliding, pore fluid pressurization and occasionally frictional melting. However, little direct records of these fast processes remain preserved through geological time. During rapid shearing, frictional melt may form that lubricates the rocks and facilitates further sliding. The frictional melt layer may quench quickly within seconds to minutes depending on its thickness. After quenching, the product pseudotachylyte preserves valuable information about the conditions when the frictional melt was generated. Here, we study pseudotachylyte from Holsnøy Island in the Bergen Arcs of Western Norway, an exhumed portion of the lower continental crust. The investigated pseudotachylyte vein is ca. 1-2 cm thick and free of injection veins along the 2 m visible length of the fault. The pseudotachylyte matrix is made up of fine-grained omphacite (Jd<sub>38</sub>), sodic plagioclase (Ab<sub>83</sub>) and kyanite with minor rutile and sulphides. Many dendritic garnets are found within the pseudotachylyte showing gradual grain size reduction towards the wall rock. This suggests that the garnets crystallized during rapid quenching. The stability of epidote, kyanite and quartz in the wall rock plagioclase, and omphacite and albitic plagioclase together with quartz in the pseudotachylyte matrix constrains the ambient P ca. 1.5-1.7 GPa and T ca. 650-750°C. Using Raman elastic barometry, the constrained pressure condition from quartz inclusions in the dendritic garnets in the pseudotachylyte is > 2 GPa. Based on an elastic model (Eshelby’s solution), it is not possible to maintain 0.5 GPa overpressure within a thin melt layer by thermal pressurization or melting expansion. A potential explanation is that GPa level differential stress was present in the wall rocks and the melt pressure approached the normal stress when shear rigidity vanished during frictional melting. Our study illustrates how overpressure can be created within frictional melt veins under conditions of high differential stress, and offers a mechanism that facilitates co-seismic weakening during lower crustal earthquakes.  </p>


2008 ◽  
Vol 146 (1) ◽  
pp. 133-143 ◽  
Author(s):  
SARBANI PATRANABIS-DEB ◽  
JUERGEN SCHIEBER ◽  
ABHIJIT BASU

AbstractWe report on the newly discovered almandine garnet phenocrysts in rhyolitic ignimbrites (Sukhda Tuff) in the Precambrian Churtela Shale Formation of the Chhattisgarh Supergroup in central India. SHRIMP ages of igneous zircon from the ignimbrites range from 990 Ma to 1020 Ma. These ignimbrites exhibit characteristic eutaxitic texture with compacted curvilinear glass shards with triple junctions. Quartz (commonly embayed; bluish cathodoluminescence) and albite (altered but retaining ghosts of twinning) are common phenocrysts; others are apatite, ilmenite, rutile, magnetite, zircon, monazite and garnet. There are no metamorphic or granitic xenoliths in the ignimbrites. Garnet grains occur as isolated broken isotropic crystals with sharp or corroded boundaries in a very fine-grained groundmass of volcanic ash that consists principally of albite, quartz, magnetite and glass. They do not have any systematically distributed inclusions. A few have penetratively intergrown phenocrysts of apatite, ilmenite, rutile and zircon, which we interpret as subophitic texture. Extensive SEM-BSE imaging of more than 100 grains and electron microprobe traverses across about 30 grains showed no zoning or systematic compositional variability. Common (metamorphic) garnets are usually zoned with respect to Fe–Mg–Mn and typically have mineral inclusions. We infer, therefore, that these observed garnets are not metamorphic xenocrysts. The average major oxide composition of analysed garnets from five different horizons within the Sukhda Tuff, spanning approximately 300 m of the stratigraphic section, have very small standard deviation for each element, which is suggestive of a single magmatic source. Phenocrysts of quartz, including those in contact with coexisting garnets, show blue scanning electron CL, indicating rapid cooling from high temperature; this suggests that adjacent coexisting garnets are not slowly cooled restites. We conclude, on the basis of texture, mineral chemistry and absence of any indicative xenoliths or xenocrysts, that these almandine garnets (Al78.7Py12.3Gr7.4Sp1.6) are phenocrysts within the Sukhda Tuff. Almandine of such composition is stable under high pressure. We infer that almandine crystallized at lower crustal depths in a magma that ascended very rapidly and may have erupted explosively.


2019 ◽  
Vol 5 (7) ◽  
pp. eaaw0913 ◽  
Author(s):  
Arianne Petley-Ragan ◽  
Yehuda Ben-Zion ◽  
Håkon Austrheim ◽  
Benoit Ildefonse ◽  
François Renard ◽  
...  

Earthquakes in the continental crust commonly occur in the upper 15 to 20 km. Recent studies demonstrate that earthquakes also occur in the lower crust of collision zones and play a key role in metamorphic processes that modify its physical properties. However, details of the failure process and sequence of events that lead to seismic slip in the lower crust remain uncertain. Here, we present observations of a fault zone from the Bergen Arcs, western Norway, which constrain the deformation processes of lower crustal earthquakes. We show that seismic slip and associated melting are preceded by fracturing, asymmetric fragmentation, and comminution of the wall rock caused by a dynamically propagating rupture. The succession of deformation processes reported here emphasize brittle failure mechanisms in a portion of the crust that until recently was assumed to be characterized by ductile deformation.


2011 ◽  
Vol 38 (1) ◽  
pp. n/a-n/a ◽  
Author(s):  
Guo-Chin Dino Huang ◽  
Steven W. Roecker ◽  
Vadim Levin

2017 ◽  
Author(s):  
Friedrich Hawemann ◽  
Neil Mancktelow ◽  
Sebastian Wex ◽  
Alfredo Camacho ◽  
Giorgio Pennacchioni

2009 ◽  
Vol 72 (1) ◽  
pp. 55-62 ◽  
Author(s):  
Heidi Soosalu ◽  
Janet Key ◽  
Robert S. White ◽  
Clare Knox ◽  
Páll Einarsson ◽  
...  

2009 ◽  
Vol 10 (6) ◽  
pp. n/a-n/a ◽  
Author(s):  
Derek Keir ◽  
Ian D. Bastow ◽  
Kathryn A. Whaler ◽  
Eve Daly ◽  
David G. Cornwell ◽  
...  

2021 ◽  
Author(s):  
Xin Zhong ◽  
Arianne J. Petley-Ragan ◽  
Sarah H. M. Incel ◽  
Marcin Dabrowski ◽  
Niels H. Andersen ◽  
...  

AbstractEarthquakes at lower crustal depths are common during continental collision. However, the coseismic weakening mechanisms required to propagate an earthquake at high pressures are poorly understood. Transient high-pressure fluids or melts have been proposed as a viable mechanism, but verifying this requires direct in situ measurement of fluid or melt overpressure along fault planes that have hosted dynamic ruptures. Here, we report direct measurement of highly overpressurized frictional melts along a seismic fault surface. Using Raman spectroscopy, we identified high-pressure quartz inclusions sealed in dendritic garnets that grew from frictional melts formed by lower crustal earthquakes in the Bergen Arcs, Western Norway. Melt pressure was estimated to be 1.8–2.3 GPa on the basis of an elastic model for the quartz-in-garnet system. This is ~0.5 GPa higher than the pressure recorded by the surrounding pseudotachylyte matrix and wall rocks. The recorded melt pressure could not arise solely from the volume expansion of melting, and we propose that it was generated when melt pressure approached the maximum principal stress in a system subject to high differential stress. The associated palaeostress field demonstrates that a strong lower crust accommodated up to 1 GPa differential stress during the compressive stage of the Caledonian orogeny.


Sign in / Sign up

Export Citation Format

Share Document