scholarly journals Sensitivity analysys and potential evaluation using building thermal mass combined with DSM strategies

2019 ◽  
Vol 111 ◽  
pp. 06029
Author(s):  
MCarmen Pavón ◽  
José Sánchez ◽  
MCarmen Guerrero ◽  
JLuis Molina ◽  
Servando Álvarez

The objective of the work is to develop an algorithm that automatically manages the activation of the heat pump in response to the most appropriate strategies according to the pricing and operating conditions. It is interesting to see if a balance can be reached between the cost savings, the increase in energy consumed, the thermal comfort of the occupants and the contribution to the reduction of the peak loads. The study shows different results and conclusions, highlighting the important influence of various factors on the results obtained, such as user behavior, constructive quality of the building and electric pricing. Connection with a future renewable production can maximize the economic savings; it is interesting the use of buildings as thermal storage of unused photovoltaic surplus. Finally, the possibility of combining these measures with electrical storage and with the possible arbitration linked to renewable production.

Author(s):  
Yahya I. Sharaf-Eldeen

This work involves measurements, analyses, and evaluation of performance of air-source heat pump water heaters (HPWHs), and their impacts on electric utility loads. Two add-on, heat pumps (HPs) rated at 7000 BTU/h (2.051 kW) and 12,000 BTU/h (3.517 kW) were utilized. The HPs were retrofitted to two 50 gal (189.3 l) electric water heaters (EWHs) with their electric heating elements removed. A third standard EWH was used for comparison. The testing setups were fully instrumented for measurements of all pertinent parameters, including inlet and outlet water temperatures, inlet and outlet air temperatures of the HPs, temperature and humidity of the surrounding air, volume of water drawn out of the storage tanks, as well as the electric energy consumptions of the systems. Performance measures evaluated included the coefficient of performance, the energy factor (EF), and the first hour rating (FHR). The HPWH systems gave EFs ranging from 1.8 to 2.5 and corresponding energy savings (and reductions in utility peak loads) ranging from 49.0% to 63.0%, approximately. The values obtained in the summer months were, as expected, somewhat higher than those obtained in the winter ones. The average values of the EFs and energy savings (and reductions in utility peak loads) were about 2.1 and 56.0%, respectively. FHR results were much lower for the HPWHs compared with those for the standard EWH. These results show that HPWHs are much more efficient compared with standard EWHs. While the average value of the EF for the EWH was about 0.92, the HPWHs yielded EFs averaging more than 2.00, resulting in annual energy savings averaging more than 50%. The results also show that HPWHs are effective at reducing utility peak loads, in addition to providing substantial cost savings to consumers.


Author(s):  
E. A. Polozova

Improving the quality of drugs is the main task of the pharmaceutical industry as a whole. Getting safe and eff ective medications is directly related to minimizing the risks of conducting clinical trials. Maintaining the quality of clinical research based on risk management is a continuous, constant and dynamic process ensuring the success of the study, which in turn leads to the integrity of the data collected, the safety of subjects and compliance with legal requirements, as well as to the financial cost savings of pharmaceutical companies. The cost of research is growing inexorably, and the quality of their research is rapidly declining, so it is important to use a risk-based approach when developing the upcoming clinical trial project.


BMC Medicine ◽  
2020 ◽  
Vol 18 (1) ◽  
Author(s):  
Anne B. Wichmann ◽  
◽  
Eddy M. M. Adang ◽  
Kris C. P. Vissers ◽  
Katarzyna Szczerbińska ◽  
...  

Abstract Background The number of residents in long-term care facilities (LTCFs) in need of palliative care is growing in the Western world. Therefore, it is foreseen that significantly higher percentages of budgets will be spent on palliative care. However, cost-effectiveness analyses of palliative care interventions in these settings are lacking. Therefore, the objective of this paper was to assess the cost-effectiveness of the ‘PACE Steps to Success’ intervention. PACE (Palliative Care for Older People) is a 1-year palliative care programme aiming at integrating general palliative care into day-to-day routines in LTCFs, throughout seven EU countries. Methods A cluster RCT was conducted. LTCFs were randomly assigned to intervention or usual care. LTCFs reported deaths of residents, about whom questionnaires were filled in retrospectively about resource use and quality of the last month of life. A health care perspective was adopted. Direct medical costs, QALYs based on the EQ-5D-5L and costs per quality increase measured with the QOD-LTC were outcome measures. Results Although outcomes on the EQ-5D-5L remained the same, a significant increase on the QOD-LTC (3.19 points, p value 0.00) and significant cost-savings were achieved in the intervention group (€983.28, p value 0.020). The cost reduction mainly resulted from decreased hospitalization-related costs (€919.51, p value 0.018). Conclusions Costs decreased and QoL was retained due to the PACE Steps to Success intervention. Significant cost savings and improvement in quality of end of life (care) as measured with the QOD-LTC were achieved. A clinically relevant difference of almost 3 nights shorter hospitalizations in favour of the intervention group was found. This indicates that timely palliative care in the LTCF setting can prevent lengthy hospitalizations while retaining QoL. In line with earlier findings, we conclude that integrating general palliative care into daily routine in LTCFs can be cost-effective. Trial registration ISRCTN14741671.


Blood ◽  
2016 ◽  
Vol 128 (22) ◽  
pp. 2619-2619
Author(s):  
Aaron P Soff ◽  
Judy Dong ◽  
Simon Mantha ◽  
Gerald A. Soff

Abstract Venous thromboembolism (VTE) is a leading cause of mortality and morbidity in cancer patients, and management represents a major cost to the healthcare system. We have previously presented in a cohort of 200 patients with cancer-associated thrombosis, rivaroxaban provides an alternative to low molecular weight heparin (LMWH), with 4.4% recurrent VTE and 2.2% major bleeding at 6 months (Mantha et al, ASH Abstract, 2015). Other recent publications have provided similar support for use of rivaroxaban in treatment of cancer-associated thrombosis (Bott-Kitslaar et al, Am J Med. 2016, Prins et al, Lancet Haem, 2014). In our early experience with rivaroxaban, fewer patients were sent to the Emergency Room (ER) for initiation of rivaroxaban than LMWH. We now characterize the site and cost of initiation of anticoagulation for the full 200 rivaroxaban patient cohort and a similar cohort of patients treated with LMWH demonstrating significant changes in practice and cost savings. In an IRB approved initiative we track all patients with cancer-associated thrombosis at MSKCC. We characterized the site of initiation of anticoagulation of the first 200 cancer patients with a pulmonary embolism (PE) or lower extremity deep vein thrombosis DVT since January 2014, treated with rivaroxaban. A similar cohort from June through December 2013 was treated with enoxaparin. We excluded patients whose VTE developed as an inpatient. Anticoagulation starts were classified as an emergency room (ER) visit or a second return outpatient visit on the same day for patient education and insurance authorization, a single outpatient visit, or telephone communication. Respective billing codes were then used as part of an economic evaluation to estimate the cost of the additional healthcare resources utilized, and therefore the costs saved by reduction in ER visits or second medical office visits. In the first 6 months of rivaroxaban availability, there was no decrease in ER utilization, compared with LMWH use. After 6 months of rivaroxaban availability, there was a significant decrease in ER visits for VTE management (p=0.008), which resulted in a decrease from baseline of 71% to 34% after one year (p=0.0001). Also of note, after one year of rivaroxaban availability, 18% of newly diagnosed VTE were managed by a simple telephone call to the patient or family member, typically after a recent outpatient visit. Only 2 patients who were started on rivaroxaban had required an additional outpatient visit to our Hematology clinic for evaluation. Based on 2016 Medicare billing codes, we calculated the cost for the additional resources utilized, beyond a single outpatient visit. During the first 6 months of rivaroxaban use, the cost of additional resources per 100 outpatient VTE patients ($47,067) was not significantly different than during the LMWH era ($43,144). However, as practice patterns evolved, ER utilization declined and more patients were managed without additional healthcare resources, resulting in an approximately 50% reduction in costs, for a savings of approximately $20,000 per 100 anticoagulation initiations. Management of cancer-associated thrombosis with LMWH is painful to the patient and expensive to the healthcare system. Patient quality of life is improved by treatment with rivaroxaban versus LMWH, with no evidence of loss of safety or efficacy. In this analysis, we expand on our prior observation that demonstrated a marked reduction in ER visits or hematology consults for the purpose of anticoagulation initiation and also show a substantial cost savings, of approximately $20,000 per 100 VTE patients. These changes in practice developed over an 18-month period, presumably reflecting a learning curve as healthcare providers became more familiar and comfortable with rivaroxaban. Of course, some patients with a new cancer-associated thrombosis should be sent to an ER for evaluation, based on their hemodynamic state or co-morbidities. However, our findings suggest that a majority of patients with cancer-associated thrombosis do not require ER visits, improving patient quality of life and sparing healthcare resources. Disclosures Soff: Janssen Pharmaceuticals: Other: Summer Student Internship. Mantha:Janssen Scientific Affairs, LLC: Research Funding. Soff:Janssen Scientific Affairs, LLC: Consultancy, Research Funding.


2019 ◽  
Vol 70 (2) ◽  
pp. 193-202
Author(s):  
Ľubica Simanová ◽  
Andrea Sujová ◽  
Pavol Gejdoš

The main aim of this paper is to illustrate the application of selected methods and procedures in the implementation of the Six Sigma Methodology in the furniture manufacturing processes, specifically in the wood veneer pressing, to verify the application and to evaluate the benefits of using selected methods and procedures through a series of step DMAIC process improvement. The application of selected methods and tools within the Six Sigma Methodology, such as DPMO, efficiency and sigma levels, project charter, histogram of mistakes caused by the application of the adhesive, the SIPOC plot mapping process, reaction plans, Ishikawa diagram and control diagrams bring the system and clarity of measurable results into project management for process improvement and process change. The benefits of their use are the cost savings and performance improvement processes.


1980 ◽  
Vol 3 (4) ◽  
pp. 421-421
Author(s):  
Jerome Joffe

Numerous problem areas were encountered in the evaluation of a voluntary second surgical opinion program. Some problems could be handled only on a conceptual level, while others require for their solution the integration of existing with new data sets. (1) Reliance on program participants to provide medical data was sensitivity tested and found to have minimal impact. (2) Program impact on hospital bed reduction was considered in the context of the total market and political environment in the region, and the anticipated duration of the program. A reasonable judgment was that almost the entire fixed component in the per diem cost of anticipated patient days foregone could be written off as part of the cost savings of the program. (3) As hospital reporting systems identify only average per diem costs, a methodology was developed to separate surgical from nonsurgical case costs. (4) Quality of care evaluation will incorporate a substratum of cases for which there exists a control group within the program user population. Outcome measures obtainable through survey interviews were identified.


Author(s):  
Jules White ◽  
Brian Dougherty

Product-line architectures (PLAs) are a paradigm for developing software families by customizing and composing reusable artifacts, rather than handcrafting software from scratch. Extensive testing is required to develop reliable PLAs, which may have scores of valid variants that can be constructed from the architecture’s components. It is crucial that each variant be tested thoroughly to assure the quality of these applications on multiple platforms and hardware configurations. It is tedious and error-prone, however, to setup numerous distributed test environments manually and ensure they are deployed and configured correctly. To simplify and automate this process, the authors present a model-driven architecture (MDA) technique that can be used to (1) model a PLA’s configuration space, (2) automatically derive configurations to test, and (3) automate the packaging, deployment, and testing of con-figurations. To validate this MDA process, the authors use a distributed constraint optimization system case study to quantify the cost savings of using an MDA approach for the deployment and testing of PLAs.


Author(s):  
Zuzana Kolková ◽  
Peter Hrabovský ◽  
Jozef Matušov

Microclimatic conditions and thermal comfort are important factors in the design of high quality buildings and the quality of working conditions for people in different operations. The importance of thermal comfort in the indoor environment can not be underestimated. A vast majority of complaints about indoor climate relate to poor thermal comfort. This paper presents an analysis of subjective thermal comfort measurement. The experiments were conducted to collect the data in the real conditions. ComfortSense system was used in these experiments. A Humidity and an Operative probe are available together with application software with graphical presentation of results including the Predicted Mean Vote (PMV) and Predicted Percentage Dissatisfied (PPD). The operating conditions are regulated by law in our country. The aim of the legislation is to protect people in the working environment and create appropriate health conditions for them. The goal of a thermal comfort analysis is finding an appropriate function of the physical parameters (background radiant temperature, air temperature, air humidity, wind speed, clothing, metabolic rate, and core temperature), which would yield the corresponding comfort/discomfort level.


1988 ◽  
Vol 1 (3) ◽  
pp. 173-177
Author(s):  
James W. Cooper

The cost savings of consultant pharmacy practice and drug-related problems and care outcomes of dealing with the geriatric patients at all levels of care are reviewed. The consultant pharmacist has been shown to decrease overall drug costs, adverse drug reactions, and drug-related hospitalizations and mortality, while improving the quality of drug therapy and actually lowering drug monitoring costs. Problems and issues yet to be resolved are presented along with recommendations for improved quality of pharmacy services and education.


2005 ◽  
Vol 72 (4) ◽  
pp. 482-485 ◽  
Author(s):  
Mehmet Sait Söylemez

A thermo economic optimization analysis is presented yielding simple algebraic formula for estimating the optimum operating conditions of interconnected heat pump assisted milk pasteurizing systems. The overall operational cost method including the cost of auxiliary heater is used in the present study, together with the thermal analyses of all system components, for thermo economic analysis of the system.


Sign in / Sign up

Export Citation Format

Share Document